@Article{cmes.2020.07919,
AUTHOR = {Shuo Yang, Yuanhai Li, Xiaojie Tang, Jinshan Liu},
TITLE = {Experimental Simulation and Numerical Modeling of Deformation and Damage Evolution of Pre-Holed Sandstones After Heat Treatment},
JOURNAL = {Computer Modeling in Engineering \& Sciences},
VOLUME = {122},
YEAR = {2020},
NUMBER = {2},
PAGES = {633--659},
URL = {http://www.techscience.com/CMES/v122n2/38325},
ISSN = {1526-1506},
ABSTRACT = {The deformation and damage evolution of sandstone after heat treatment greatly
influence the efficient and safe development of deep geothermal energy extraction. To 
investigate this issue, laboratory confined compression tests and numerical simulations
were conducted on pre-holed sandstone specimens after heat treatment. The laboratory test 
results show that the failure modes are closely related to the heat treatment temperature, 
with increasing treatment temperature, the failure modes change from mixed and shear 
modes to a splitting mode. The cracks always initiate from the sidewalls of the hole and 
then propagate. The failure process inside the hole proceeds as follows: calm period, 
particle ejection period, rock fragment exfoliation period and rock failure period. The 
specimens have different final failure features for the entire rock after heat treatment, but 
have the same failure features inside the hole. These phenomena can be explained by 
numerical simulations. The numerical simulations reveal that the failure modes in the 
numerical results agree very well with those observed in the experimental results. The 
damage zone always occurs at sidewalls of the hole and then propagates to the entire rock 
affected by shear or tensile damage. From 20°C to 200°C, thermal effect may promote 
shear damage and restrain tensile damage, while from 200°C to 800°C, thermal effect 
promotes tensile damage and restrains shear damage. Notably, the damage zone near the 
sidewalls of the hole has the same distribution range and pattern. Finally, the differences 
in the mechanisms due to increasing heat temperature are evaluated using scanning electron 
microscope (SEM) observations.},
DOI = {10.32604/cmes.2020.07919}
}