@Article{csse.2023.022047, AUTHOR = {Waqar Hafeez, Nazrina Aziz,2}, TITLE = {Designing Bayesian Two-Sided Group Chain Sampling Plan for Gamma Prior Distribution}, JOURNAL = {Computer Systems Science and Engineering}, VOLUME = {44}, YEAR = {2023}, NUMBER = {2}, PAGES = {1069--1079}, URL = {http://www.techscience.com/csse/v44n2/48236}, ISSN = {}, ABSTRACT = {Acceptance sampling is used to decide either the whole lot will be accepted or rejected, based on inspection of randomly sampled items from the same lot. As an alternative to traditional sampling plans, it is possible to use Bayesian approaches using previous knowledge on process variation. This study presents a Bayesian two-sided group chain sampling plan (BTSGChSP) by using various combinations of design parameters. In BTSGChSP, inspection is based on preceding as well as succeeding lots. Poisson function is used to derive the probability of lot acceptance based on defective and non-defective products. Gamma distribution is considered as a suitable prior for Poisson distribution. Four quality regions are found, namely: (i) quality decision region (QDR), (ii) probabilistic quality region (PQR), (iii) limiting quality region (LQR) and (iv) indifference quality region (IQR). Producer’s risk and consumer’s risk are considered to estimate the quality regions, where acceptable quality level (AQL) is associated with producer’s risk and limiting quality level (LQL) is associated with consumer’s risk. Moreover, AQL and LQL are used in the selection of design parameters for BTSGChSP. The values based on all possible combinations of design parameters for BTSGChSP are presented and inflection points’ values are found. The finding exposes that BTSGChSP is a better substitute for the existing plan for industrial practitioners.}, DOI = {10.32604/csse.2023.022047} }