Ocampo Ocampo T¹, DL Ochoa Martínez¹, S Ramírez Rojas², G Valdovinos Ponce¹, C Nava Díaz¹

Phyton-International Journal of Experimental Botany, Vol.82, pp. 235-241, 2013, DOI:10.32604/phyton.2013.82.235

Abstract The Instituto Nacional de Investigaciones Forestales, Agrícolas y Pecuarias (INIFAP), in Zacatepec Morelos, started a genetic improvement program of wild and semi-cultivated poinsettia plants ("nochebuena de sol"). It is important to generate a phytosanitary database that allows the release of new varieties and hybrids that provide tolerance to the major pathogens reported in cultivated poinsettia plants. The phytosanitary status of the “nochebuena de sol” plants is not available in Mexico, so the objective of this research was to generate preliminary data about viruses associated to these materials. Based on DAS-ELISA and RT-PCR results, we reported More >

A. Rtibi¹, M. Hasnaoui¹, A. Amahmid¹

FDMP-Fluid Dynamics & Materials Processing, Vol.9, No.2, pp. 183-207, 2013, DOI:10.3970/fdmp.2013.009.183

Abstract In this paper we present an analytical and numerical study of Soret convection in an inclined rectangular porous layer saturated with a binary fluid and subject to uniform heat fluxes. In the problem formulation, the Darcy model is considered and the results are presented for wide ranges of R_T (50 ≤ R_T ≤ 1000), θ(0°≤θ≤180°) and φ(-1 ≤ φ ≤ 1) for Le = 10, where R_T, θ, φ, and Le are the thermal Darcy-Rayleigh number, the cavity inclination, the separation parameter, and the Lewis number, respectively. An analytical solution, derived on the basis of the parallel flow approximation,… More >

H. Jiang^1,2, B. Yang¹, S. Liu³

CMC-Computers, Materials & Continua, Vol.38, No.2, pp. 61-77, 2013, DOI:10.3970/cmc.2013.038.061

Abstract Actin, fibrin and collagen fiber networks are typical hierarchical biological materials formed by bundling fibrils into fibers and branching/adjoining fibers into networks. The bundled fibrils interact with each other through weak van der Waals forces and, in some cases, additional spotted covalent crosslinks. In the present work, we apply Timoshenko's beam theory that takes into account the effect of transverse shear between fibrils in each bundle to study the overall mechanical behaviors of such fiber networks. Previous experimental studies suggested that these fibers are initially loose bundles. Based on the evidence, it is hypothesized that More >

Ridha Djebali¹, Mohsen Toujani², Bernard Pateyron³

CMC-Computers, Materials & Continua, Vol.37, No.3, pp. 147-160, 2013, DOI:10.3970/cmc.2013.037.147

Abstract In this paper a study of the atmospheric plasma spraying process was conducted. The Jets&Poudres code was used to solve the partial differential equations for the conservation of mass, momentum and energy involved in the problem together with the K-e turbulent model. The Taguchi technique was used to study the influence of processing factors on droplet impact properties obtained on dense zirconia (ZrO₂) under H₂Ar75% plasma gas that allow optimal functioning condition. The test of the operating parameters for the studied ranges showed that the "thermal power" factor plays a key role on the state of sprayed More >

Ching-Feng Yu¹, Wen-Hwa Chen^1,2, Kun-Ling Chen¹, Hsien-Chie Cheng^2,3

CMC-Computers, Materials & Continua, Vol.36, No.2, pp. 203-229, 2013, DOI:10.3970/cmc.2013.036.203

Abstract The investigation assesses the thermal-mechanical and thermodynamic properties of various graphene sheets using a modified Nosé-Hoover (NH) thermostat method incorporated with molecular dynamics (MD) simulation. The investigation begins with an exploration of their thermal-mechanical properties at atmospheric pressure, including Young’s modulus, shear modulus, Poisson’s ratio, specific heats and linear and volumetric coefficients of thermal expansion (CTE). Two definitions of the line change ratio (ΔL/L) are utilized to determine the linear CTE of graphene sheets, and the calculations are compared with each other and data in the literature. To estimate the volumetric CTE values, the Connolly… More >

Ashis Chawla, Adnan Qureshi, Aziz Alamri, Edward D. Matsumoto

Canadian Journal of Urology, Vol.19, No.1, pp. 6142-6146, 2012

Abstract Introduction: Placement of anterior abdominal wall trocars during laparoscopic radical prostatectomy (LRP) carries the risk of inadvertent injury to the inferior epigastric artery (IEA) and potential conflict between midline and lateral ports. We described and evaluated a new measured port placement approach.
Materials and methods: The intervention group included patients who underwent LRP using a specifically measured five-port approach. The medial 10 mm ports were placed 5 cm from the patient’s midline at a level midway between the anterior superior iliac spine (ASIS) and the umbilicus. The control group had five ports placed at the surgeon’s discretion.… More >

Simonetti E¹, E Alba², A Delibes²

Phyton-International Journal of Experimental Botany, Vol.81, pp. 139-142, 2012, DOI:10.32604/phyton.2012.81.139

Abstract In a previous work, deduced amino acid sequences from twenty wheat peroxidase genes were assigned to seven groups designated as TaPrx108 to TaPrx114. Some of these apoplastic peroxidases have previously shown to play different roles in the plant defense responses to infection by the cereal cyst nematode Heterodera avenae. In the present study, PCR marker analysis using Sears’s aneuploid wheat lines cv. ‘Chinese Spring’ was used to locate four genes encoding peroxidase isozymes. The TaPrx111-A, TaPrx112-D and TaPrx113-F genes were located on the short arm of chromosome 2B and the TaPrx109-C on the long arm of chromosome 1B. More >

A.S Vinod Kumar, Ranjan Ganguli²

CMES-Computer Modeling in Engineering & Sciences, Vol.88, No.6, pp. 443-474, 2012, DOI:10.3970/cmes.2012.088.443

Abstract The governing differential equation of a rotating beam becomes the stiff-string equation if we assume uniform tension. We find the tension in the stiff string which yields the same frequency as a rotating cantilever beam with a prescribed rotating speed and identical uniform mass and stiffness. This tension varies for different modes and are found by solving a transcendental equation using bisection method. We also find the location along the rotating beam where equivalent constant tension for the stiff string acts for a given mode. Both Euler-Bernoulli and Timoshenko beams are considered for numerical results. More >

Changsheng Wang¹, Ping Hu^1,2

CMES-Computer Modeling in Engineering & Sciences, Vol.88, No.5, pp. 325-350, 2012, DOI:10.3970/cmes.2012.088.325

Abstract Based on the Reissner-Mindlin plate theory, two 3-node triangular flat shell elements QCS31 and QCS32 are proposed by using Timoshenko's beam function within the framework of quasi-conforming technique. The exact displacement function of the Timoshenko's beam is used as the displacement on the element boundary in the bending part and the interpolated inner field function is also derived by the function. In the shear part the re-constitution technique is adopted. The drilling degrees of freedom are added in the membrane part to improve membrane behavior. The proposed elements can be used for the analysis of More >

Biao Zhou^1,2,3, Xiong yao Xie^1,2, Yeong Bin Yang⁴, Jing Cai Jiang³

CMES-Computer Modeling in Engineering & Sciences, Vol.86, No.4, pp. 321-348, 2012, DOI:10.3970/cmes.2012.086.321

Abstract The vibration-based SHM (Structure Health Monitoring) system has been successfully used in bridge and other surface civil infrastructure. However, its application in operation tunnels remains a big challenge. The reasons are discussed in this paper by comparing the vibration characteristics of the free tunnel structure and tunnel-soil coupled system. It is revealed that all the correlation characteristics of the free tunnel FRFs (Frequency Response Function spectrum) will vanish and be replaced by a coupled resonance frequency when the tunnel is surrounded by soil. The above statement is validated by field measurements. Moreover, the origin of More >