P. Ramya¹, B. Padmapriya², S. Poornachandra³

Computer Systems Science and Engineering, Vol.41, No.1, pp. 187-196, 2022, DOI:10.32604/csse.2022.020185 - 08 October 2021

Abstract Arthritis is an acute systemic disease of a joint accompanied by pain. In developed countries, it mainly causes disability among people over 50 years of age. Rheumatoid Arthritis is a type of arthritis that occurs commonly among elders. The incidence of arthritis is higher in females than in males. There is no permanent diagnosis method for arthritis, but if it was identified in the early stages based on the foot pressure, it can be diagnosed before attaining the critical stage of Rheumatoid Arthritis. The analysis and study of arthritis patients were done using design thinking… More >

Yecheng Xu¹, Chaojie Xu¹, Mingsong Chen¹, Jianzhang Li¹, Ling Zeng², Jing Luo³, Qiang Gao^1,*, Sheldon Q. Shi^4,*

Journal of Renewable Materials, Vol.10, No.3, pp. 639-652, 2022, DOI:10.32604/jrm.2022.018509 - 28 September 2021

Abstract Soy protein-based composite film is a potential replacement for petroleum-based film with multipurpose applications and cleaner production. It is difficult to improve both the tensile strength and toughness of a protein-based film without sacrificing its elongation. In this study, inspired by the hierarchical structure of nacre, a facile yet delicate strategy was developed to fabricate a novel bio-based film with excellent toughness and high strength. Triglycidylamine (TGA) crosslinked soy protein (SPI) as hard phase and thermoplastic polyurethane elastomer (TPU) as soft phase comprise an alternative lay-up hierarchical structure. The interface of these two phases is More >

Jingjing Liao^1,2, Jinxing Li², Fuxian Yang², Yan Zhu², Hongyan Wang³, Guanben Du^1,2,*, Hisham Essawy⁴, Xiaojian Zhou^2,*

Journal of Renewable Materials, Vol.10, No.2, pp. 359-372, 2022, DOI:10.32604/jrm.2021.016335 - 30 August 2021

Abstract Polyvinyl alcohol (PVA)-based films containing Chinese bayberry tannin (BT) were prepared by cross-linking using glyoxal, glutaraldehyde and dialdehyde starch, individually. The presence of cross-linkers was evident to promote the transparency and decrease the moisture content of PVA/BT films, while the water solubility stayed almost unchanged in the cross-linked PVA/BT films. All cross-linkers provided promotion of the water vapor permeability, mechanical property and thermal stability of PVA/BT films. The best water vapor barrier capacity was found in case of glutaraldehyde cross-linked PVA/BT film, while the highest tensile strength was encountered in case of glyoxal cross-linked PVA/BT More > Graphic Abstract

Jingjing Liao^1,2, Jinxing Li², Hongyan Wang³, Yan Zhu², Hisham Essawy⁴, Guanben Du^1,2,*, Xiaojian Zhou^2,*

Journal of Renewable Materials, Vol.10, No.1, pp. 19-31, 2022, DOI:10.32604/jrm.2021.016152 - 27 July 2021

Abstract The current work explores the potential use of commercial Chinese bayberry tannin (BT) to develop antioxidant PVA-based films using solvent casting process for packaging applications. The effect of BT concentration on opacity, water resistance and antioxidant capacity of resulting films was investigated. Properties like tensile strength, thermal behavior, and morphological aspects were also characterized. The experimental results showed that PVA/BT films formed with uniformly brown color and generally good transparency, offering good antioxidant ability. The PVA film containing BT presented slightly higher water resistance according to the results of moisture content and water vapor permeability, More > Graphic Abstract

DENIZ AKIN SAHBAZ^1,*, BETUL TURP KAYA²

Journal of Polymer Materials, Vol.38, No.3-4, pp. 247-256, 2021, DOI:10.32381/JPM.2021.38.3-4.6

Abstract The objective of this study is to develop chitosan-based films containing Hypericum perforatum L. and/or Citrus limon L. oils and to investigate their suitability as novel wound dressing materials. The morphology of the chitosan-based films were observed by means of employing the scanning electron microscopy (SEM) and the chemical structure characterization was performed via Fourier Transform Infrared Spectroscopy (FTIR). Hypericum perforatum L. and/or Citrus limon L. were successfully incorporated to the chitosan films. Antibacterial, swelling, and mechanical properties of these films were investigated. The antibacterial property was enhanced by incorporating Hypericum perforatum L. and Citrus More >

Revathi Gadamsetty^a,*,† , Venkata Subrahmanyam Sajja^b, P. Sudam Sekhar^c, Dhaneshwar Prasad^d

Frontiers in Heat and Mass Transfer, Vol.16, pp. 1-6, 2021, DOI:10.5098/hmt.16.7

Abstract An attempt has been made to investigate hydrodynamic lubrication characteristics of asymmetric roller bearings lubricated by thin fluid film under the operating behavior of line contact for a heavily loaded rigid system for normal squeezing motion with cavitation points. The lubricant follows non-Newtonian incompressible Bingham plastic fluid model where the fluid viscosity is supposed to vary with hydrodynamic pressure . The equations which govern the fluid flow such as continuity and momentum equation are solved first analytically and later numerically using MATLAB. The numerical results are achieved for the velocity, pressure, load, and traction forces More >

BARKAT ALI KHAN¹, FAZAL KARIM¹, MUHAMMAD KHALID KHAN^1,*, FAHEEM HAIDER¹, SADIQULLAH KHAN²

BIOCELL, Vol.45, No.5, pp. 1273-1285, 2021, DOI:10.32604/biocell.2021.015323 - 12 July 2021

Abstract The fourth most predominant overwhelming type of trauma is burn injuries worldwide. Ideal wound healing dressings help in the wound healing process in a lower time with less pain. Commonly used dry wound dressing, like absorbent gauze or absorbent cotton, possess limited therapeutic effects and require repeated use, which further exaggerates patients’ suffering. In contrast, hydrogels films present a promising alternative to improve healing by guaranteeing a moisture balance at the wound site. The aim of the current study was to synthesize Tamarix aphylla (T. aphylla) extract-loaded hydrogel film with Na-CMC and pectin and to study their… More >

Heru Suryanto^1,2,*, Muhamad Muhajir¹, Bili Darnanto Susilo¹, Yanuar Rohmat Aji Pradana¹, Husni Wahyu Wijaya^2,3, Abu Saad Ansari⁴, Uun Yanuhar⁵

Journal of Renewable Materials, Vol.9, No.10, pp. 1717-1728, 2021, DOI:10.32604/jrm.2021.015312 - 12 May 2021

Abstract The microstructure of bacterial cellulose nanofibers (BCNs) film affects its characteristic. One of several means to engineer the microstructure is by changing the BCNs size and fiber distribution through a high-pressure homogenizer (HPH) process. This research aimed to find out the effects of repetition cycles on HPH process towards BCNs film characteristics. To prepare BCNs films, a pellicle from the fermentation of pineapple peels waste with Acetobacter xylinum (A. xylinum) was extracted, followed by crushing the pellicle with a high-speed blender, thereafter, homogenized using HPH at 150 bar pressure with variations of 5, 10, 15, and 20… More >

Mayyadah H. Mohsin¹, Najwan H. Numan², Evan T. Salim^1,*, Makram A. Fakhri^2,*

Journal of Renewable Materials, Vol.9, No.9, pp. 1519-1530, 2021, DOI:10.32604/jrm.2021.015465 - 23 April 2021

Abstract A SiC nanofilms have been deposited and investigated on quartz and silicon substrates using pulsed laser deposition technique with the 300 pulses of Nd: YAG laser at two different laser wavelengths of 1064 nm and 532 nm. The structural, morphological, and optical properties of the deposited nanostructure SiC were prepared and characterized as a function of the wavelengths of the used laser. The structural result shows four different pecks at (111), (200), (220), and (311) planes related to Nano SiC. The transmission result presents that the optical energy gap value for the SiC nanostructure is More > Graphic Abstract

Nguyen Thi Thanh Thuy^1,*, Le Hoang Huy¹, Truong Thuy Vy¹, Nguyen Thi Thanh Tam², Bien Thi Lan Thanh¹, Nguyen Thi My Lan³

Journal of Renewable Materials, Vol.9, No.8, pp. 1393-1411, 2021, DOI:10.32604/jrm.2021.015772 - 08 April 2021

Abstract In the present study, the biogenic silver nanoparticles have been synthesized using aqueous leaf extract of Plectranthus amboinicus (PA), which acted as both reducing and stabilizing agents. The PA synthesized silver nanoparticles were blended with carboxymethyl cellulose/polyvinyl alcohol (CMC/PVA) biocomposite. The prepared AgNPs as well as the biogenic AgNPs incorporated CMC/PVA films were investigated using UV-visible spectrophotometry, Fourier-transform infrared spectroscopy (FT-IR), dynamic light scattering (DLS), scanning electron microscope (SEM), and X–ray diffraction (XRD). The DLS results showed that biogenic AgNPs had the average particle size of 65.70 nm with polydispersity index of 0.44. The surface plasmon… More > Graphic Abstract