Etim S. Udoetok^*

Frontiers in Heat and Mass Transfer, Vol.4, No.2, pp. 1-5, 2013, DOI:10.5098/hmt.v4.2.3008

Abstract A model for the coefficient of thermal conductivity of binary mixtures of gases has been derived. The theory presented is based on the assumption of random fluctuations between two possible extreme arrangements of a binary gas mixture. The results obtained from the new model compared favorably with published experimental results. The proposed new model provides a simple approach without sacrificing much accuracy compared to previous models. It is applicable to any binary mixture of gases which includes monoatomic gas mixture, polyatomic gas mixtures and mixtures involving rare gases. The new model can be very useful More >

T. Ganier, J. Hu, A. Pizzi^*

Journal of Renewable Materials, Vol.1, No.1, pp. 79-82, 2013, DOI:10.7569/JRM.2012.634101

Abstract Linear vibration welding of extractive rich Paduk wood from central Africa containing a high proportion of a native mixture of water-insoluble extractives, or of low water solubility, has been shown to yield joints of much upgraded water resistance. This has been shown to be due to the protecting infl uence the extractives from the wood itself has on the welded interphase, due to their inherent water repellence. Joints of unusually high percentage wood failure but modest strength were obtained; Paduk wood brittleness apparently yielding weld line strengths always higher than that of the surrounding wood More >

Méndez-Aguilar R¹, MH Reyes-Valdés², N Mayek-Pérez³

Phyton-International Journal of Experimental Botany, Vol.82, pp. 215-226, 2013, DOI:10.32604/phyton.2013.82.215

Abstract Common bean was originated in México, and it is the most important protein source for millions of Mexicans, mainly those with low economic incomes. Grain yield of this crop is mainly affected by several fungal, bacterial and viral diseases. Among them, there are root rot diseases caused by the genera Macrophomina and Fusarium sp. Currently, some molecular biology tools such as DNA molecular markers are being used successfully to develop genetic maps where QTLs and major molecular markers are located, which are linked to genes that confer resistance to these fungi. The importance of the development… More >

Cerna E, Y Ochoa, LA Aguirre, M Flores, J Landeros

Phyton-International Journal of Experimental Botany, Vol.82, pp. 63-68, 2013, DOI:10.32604/phyton.2013.82.063

Abstract Southeastern potato growing regions from Coahuila and Nuevo León contribute with 15% to domestic production. Such production has been impacted by several factors, in particular Bactericera (=Paratrioza) cockerelli Sulc potato psyllid, one of the most important pests affecting this crop. Its control is based on Insecticide applications, leading to unsatisfactory results and high selection pressure. Five insecticides were evaluated in four field populations of B. cockerelli from the growing region, using a susceptible laboratory line for comparison. The field populations were collected from greenhouse and commercial orchards located at Huachichil, Saltillo, Raíces and San Rafael localities. All… More >

LUCIA PRONSATO, ANABELA LA COLLA, ANA CAROLINA RONDA, LORENA MILANESI, RICARDO BOLAND, ANDREA VASCONSUELO^*

BIOCELL, Vol.37, No.1, pp. 1-9, 2013, DOI:10.32604/biocell.2013.37.001

Abstract Cell lines with high passage numbers exhibit alterations in cell morphology and functions. In the present work, C2C12 skeletal muscle cells with either low (<20) or high (>60) passage numbers (identified as lC2C12 or h-C2C12, respectively) were used to investigate the apoptotic response to H2 O2 as a function of culture age h-C2C12. We found that older cultures (h-C2C12 group) were depleted of mitochondrial DNA (mtDNA). When we analyzed the behavior of Bad, Bax, caspase-3 and mitochondrial transmembrane potential, we observed that cells in the h-C2C12 group were resistant to H2 O2 induction of More >

Tony Mazzulli^1,2

Canadian Journal of Urology, Vol.19, Suppl.5, pp. 42-48, 2012

Abstract Urinary tract infections (UTIs) remain a common clinical problem in both the community and healthcare-associated settings. Each patient should be carefully assessed to ensure that a correct diagnosis is made and that antimicrobial therapy is appropriately prescribed—defined as using a clinically indicated agent in the correct dose and route of administration, for the correct duration—for symptomatic patients, and avoided for most asymptomatic patients. This should help stem the growing tide of antimicrobial resistance and allow for the continued use of simpler, less expensive agents. Continued surveillance and monitoring of antimicrobial resistance rates will be critical More >

Castro-Nava S¹, J Ortiz-Cereceres^2,†, M del C Mendoza-Castillo², AJ Huerta³

Phyton-International Journal of Experimental Botany, Vol.81, pp. 149-156, 2012, DOI:10.32604/phyton.2012.81.149

Abstract The aim of this study was to determine the efficiency of drought classification criteria that we previously reported for our grain sorghum genotypes. Two tolerant genotypes of grain sorghum [Sorghum bicolor (L.) Moench] (UAT-124 and UAT-152) and one susceptible (UAT-30) were subjected to drought under greenhouse conditions at either panicle initiation, flag leaf, or flowering. Results showed that the effects of drought depended on when drought stress occurred during development. Biomass of the three sorghum genotypes was significantly reduced at the flag leaf stage (48%) by drought stress, but the greatest reduction occurred in the susceptible… More >

F. Balle¹, S. Huxhold¹, G. Wagner¹, D. Eifler¹

Structural Durability & Health Monitoring, Vol.8, No.4, pp. 359-370, 2012, DOI:10.32604/sdhm.2012.008.359

Abstract Aluminum alloys and carbon fiber reinforced polymers (CFRP) are two important materials for lightweight design and the combination of these dissimilar materials becomes increasingly important. Recent investigations have shown that ultrasonic metal welding is a well suited process to realize aluminum/CFRP-joints.The ultrasonic shear oscillation parallel to the welding zone with a simultaneous welding force perpendicular to the aluminum/CFRP-sheets melts the polymer matrix and squeezes the polymer matrix out of the welding zone. This allows a direct contact between the carbon fibers and the aluminum. Beside monotonic properties the cyclic deformation behavior of these ultrasonically welded More >

A. Ramachandra Murthy¹, Nagesh R. Iyer¹, B.K. Raghu Prasad²

CMC-Computers, Materials & Continua, Vol.31, No.3, pp. 229-252, 2012, DOI:10.3970/cmc.2012.031.229

Abstract This paper presents the advanced analytical methodologies such as Double- G and Double - K models for fracture analysis of concrete specimens made up of high strength concrete (HSC, HSC1) and ultra high strength concrete. Brief details about characterization and experimentation of HSC, HSC1 and UHSC have been provided. Double-G model is based on energy concept and couples the Griffith's brittle fracture theory with the bridging softening property of concrete. The double-K fracture model is based on stress intensity factor approach. Various fracture parameters such as cohesive fracture toughness (K_Ic^c), unstable fracture toughness (K_Ic^un) and… More >

Deli Gao^1,2, Lianzhong Sun^1,3, Hongshu Wei⁴, Shunwen Wang⁴

CMES-Computer Modeling in Engineering & Sciences, Vol.89, No.2, pp. 143-162, 2012, DOI:10.3970/cmes.2012.089.143

Abstract Due to the complexity of forces acting on the down-hole tubular strings in extended reach drilling (ERD), the factors which influence the process should be taken into account as much as possible, in order to predict the down-hole drag & torque more accurately. This can help us to identify and prevent the problems related to downhole drag & torque in ERD. The effects of such factors, as the tubular buckling, the buoyancy, the mechanical resistance and the friction reducer, on down-hole drag & torque, are taken into account in this paper, in order to improve… More >