C.P. Providakis¹, M.E. Voutetaki

Structural Durability & Health Monitoring, Vol.3, No.4, pp. 211-228, 2007, DOI:10.3970/sdhm.2007.003.211

Abstract Piezoceramic transducers have emerged as new tools for the health monitoring of large-scale structures due to their advantages of active sensing, low cost, quick response, availability in different shapes, and simplicity for implementations. In the present paper, a statistical metamodeling utilization of electro-mechanical (E/M) admittance approach by applying piezoelectric materials to the damage identification is investigated. A response surface metamodel is constructed by empirically fitting a model to a set of design points chosen using a Box-Behnken design of experiment (simulation) technique. This empirical fit allows polynomial models to be produced for relating damage parameter More >

S.P.L. Leme¹, M.H. Aliabadi², L.M. Bezerra¹, P.W. Partridge¹

Structural Durability & Health Monitoring, Vol.3, No.3, pp. 121-132, 2007, DOI:10.3970/sdhm.2007.003.121

Abstract The coupled electromechanical behaviour of a thin piezoceramic sensor bonded to a stiffened panel subjected to membrane mechanical loadings is examined. The sensor is characterised by an electrostatic line model bonded to a damaged panel modelled by the dual boundary element method. Numerical results obtained demonstrate that the proposed method is capable of modelling changes in the signal output due to presence of cracks. Also presented is a numerical model for detecting fatigue crack growth in a stiffened panel using piezoceramic sensors. More >

S.C. Forth¹, A. Staroselsky²

CMES-Computer Modeling in Engineering & Sciences, Vol.9, No.3, pp. 287-298, 2005, DOI:10.3970/cmes.2005.009.287

Abstract A new hybrid surface-integral-finite-element numerical scheme has been developed to model a three-dimensional crack propagating through a thin, multi-layered coating. The finite element method was used to model the physical state of the coating, and the surface integral method was used to model the fatigue crack growth. The two formulations are coupled through the need to satisfy boundary conditions on the crack and external surface. The coupling is sufficiently weak that the surface integral mesh of the crack surface and the finite element mesh of the uncracked volume can be set up independently. Thus, when More >