Biswajit De^*, Rajsekhar Panua

Frontiers in Heat and Mass Transfer, Vol.5, pp. 1-4, 2014, DOI:10.5098/hmt.5.10

Abstract As the world is facing crisis due to the dwindling resources of fossil fuels, rapid depletion of conventional energy is a matter of serious concern for the mankind. So there is a necessity to find alternate fuels. Vegetable oils, because of their agricultural origin, due to less carbon content compared to mineral diesel are producing less CO₂ emissions to the atmosphere is used as an alternate fuel in substitute to diesel fuel. In the present study optimum compression ratio for VCR diesel engine fuelled with Jatropha oil blends with diesel (30%) has been determined at 203 bars injector opening pressure,… More >

Machireddy Gnaneswara Reddy^*

Frontiers in Heat and Mass Transfer, Vol.5, pp. 1-9, 2014, DOI:10.5098/hmt.5.4

Abstract The numerical solution of transient natural convection MHD flow past a vertical cylinder embedded in a porous medium with surface temperature and concentration along with thermal radiation is presented. The temperature and concentration level at the cylinder surface are assumed to vary as power law type functions, with exponents m and n respectively in the stream wise co-ordinate. The governing boundary layer equations are converted into a non-dimensional form. A Crank-Nicolson type of implicit finite-difference method is used to solve the governing non-linear set of equations. Numerical results are obtained and presented with various thermal and mass Grashof numbers and… More >

Emmanuel Maurice Arthur^*, Timothy Ayando, Yakubu Ibrahim Seini

Frontiers in Heat and Mass Transfer, Vol.6, pp. 1-10, 2015, DOI:10.5098/hmt.6.21

Abstract The combined effects of chemical reaction and viscous dissipation on hydromagnetic mixed convective flow towards a vertical plate embedded in a highly porous medium with radiation and internal heat generation has been examined. The governing boundary layer equations have been transformed to a two-point boundary value problem using a local similarity approach and solved numerically using the Newton Raphson shooting method alongside the Fourth-order Runge - Kutta algorithm. The effects of various embedded parameters on fluid velocity, temperature and concentration have been presented graphically whilst the skin friction coefficient and the rates of heat and mass transfers have been tabulated… More >

Junying Wei^*, Gang Li, Chenrui Zhang, Wenwen Chang, Jidai Wang

Frontiers in Heat and Mass Transfer, Vol.21, pp. 199-214, 2023, DOI:10.32604/fhmt.2023.041793

Abstract To study the complex internal flow field variation and output characteristics of a variable base radius scroll expander, this paper uses dynamic mesh techniques and computational fluid dynamics (CFD) methods to perform transient numerical simulations of a variable base radius scroll expander. Analysis of the flow field in the working cavity of a variable base radius scroll expander at different spindle angles and the effect of different profiles, speeds and pressures on the output characteristics of the scroll expander. The results of the study show that due to the periodic blocking of the inlet by the orbiting scroll, the fluid… More >

Mekonnen Shiferaw Ayano^*, J. S. Mathunjwa

Frontiers in Heat and Mass Transfer, Vol.7, pp. 1-6, 2016, DOI:10.5098/hmt.7.9

Abstract This paper presents a study of the Magnetohydrodynamic flow of incompressible micropolar fluid past an infinite vertical porous plate with combined heat and mass transfer. The plate oscillate harmonically in its own plane and the temperature raised linearly with respect to time. Numerical calculations are carried out for different values of dimensionless parameters and an analysis of the results shown graphically and in table form. It is found that velocity and microrotation influenced appreciatively with parameters like radiation, magnetic, chemical reaction and coupling numbers. It is also noted that microrotation highly influenced by the magnetic parameters. The effects of some… More >

B. Venkateswarlu^a, P.V. Satya Narayana^b,*

Frontiers in Heat and Mass Transfer, Vol.7, pp. 1-9, 2016, DOI:10.5098/hmt.7.16

Abstract This paper studies the Soret and Dufour effects on MHD flow of a Casson fluid past a stretching sheet in the presence of chemical reaction, viscous dissipation and variable thermal conductivity. The fluid is taken to be electrically conducting and the flow is induced by a stretching surface. The governing partial differential equations are transformed into non-linear ordinary differential equations using similarity transformations. The resulting equations are then solved numerically by shooting method. The impact of various stimulating parameters on the flow, heat and mass transfer characteristics are analyzed and discussed in detail through graphs. It is observed that the… More >

Vandana Bisht^*

Frontiers in Heat and Mass Transfer, Vol.7, pp. 1-7, 2016, DOI:10.5098/hmt.7.19

Abstract In this paper the steady laminar magneto hydrodynamic (MHD) mixed convection boundary layer flow towards a vertical stretching sheet with variable fluid viscosity, radiation and in the presence of Dufour’s effect have been investigated. The governing partial differential equations are transformed into set of ordinary differential equations using similarity transformation, and then these equations have been solved numerically using Runge- Kutta method with shooting technique. Results shows that magnitude of skin friction coefficient decreases, while magnitude of heat transfer coefficient and mass transfer coefficient increases with decreasing values of viscosity variation parameter for the case of opposing flow. But in… More >

Odelu Ojjela^*, K. Pravin Kashyap, N. Naresh Kuma, Samir Kumar Das

Frontiers in Heat and Mass Transfer, Vol.7, pp. 1-9, 2016, DOI:10.5098/hmt.7.32

Abstract This article presents an unsteady incompressible Upper Convected Maxwell (UCM) fluid flow with temperature dependent thermal conductivity between parallel porous plates which are maintained at different temperatures varying periodically with time. Assume that there is a periodic suction and injection at the upper and lower plates respectively. The governing partial differential equations are reduced to non linear ordinary differential equations by using similarity transformations and the solution is obtained using differential transform method. The effects of various fluid and geometric parameters on the velocity components, temperature distribution and skin friction are discussed in detail through graphs. More >

Youhao Wang¹, Chuntian Zhe¹, Chang Guo², Jinpeng Li³, Jinheng Li³, Shen Cheng², Zitian Wu¹, Suoying He¹, Ming Gao^1,*

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.12, pp. 2965-2980, 2023, DOI:10.32604/fdmp.2023.029292

Abstract Flow channels with a variable cross-section are important components of piping system and are widely used in various fields of engineering. Using a finite element method and modal analysis theory, flow-induced noise, mode shapes, and structure-borne noise in such systems are investigated in this study. The results demonstrate that the maximum displacement and equivalent stress are located in the part with variable cross-sectional area. The average excitation force on the flow channel wall increases with the flow velocity. The maximum excitation force occurs in the range of 0–20 Hz, and then it decreases gradually in the range of 20–1000 Hz.… More >

Zuo-Hua Li¹, Qing-Gui Wu^1,*, Jun Teng^1,*, Chao-Jun Chen^1,2

CMES-Computer Modeling in Engineering & Sciences, Vol.138, No.1, pp. 865-884, 2024, DOI:10.32604/cmes.2023.029927

Abstract Collisions between a moving mass and an anti-collision device increase structural responses and threaten structural safety. An active mass damper (AMD) with stroke limitations is often used to avoid collisions. However, a stroke-limited AMD control system with a fixed limited area shortens the available AMD stroke and leads to significant control power. To solve this problem, the design approach with variable gain and limited area (VGLA) is proposed in this study. First, the boundary of variable-limited areas is calculated based on the real-time status of the moving mass. The variable gain (VG) expression at the variable limited area is deduced… More >