Yutian Hong^1,*, Yuping Yan²

Energy Engineering, Vol.120, No.1, pp. 245-261, 2023, DOI:10.32604/ee.2022.022877

Abstract With the rapid development of the economy, the scale of the power grid is expanding. The number of power equipment that constitutes the power grid has been very large, which makes the state data of power equipment grow explosively. These multi-source heterogeneous data have data differences, which lead to data variation in the process of transmission and preservation, thus forming the bad information of incomplete data. Therefore, the research on data integrity has become an urgent task. This paper is based on the characteristics of random chance and the Spatio-temporal difference of the system. According to the characteristics and data… More >

Tinnawat Hongphan¹, Matthew O. T. Cole^1,*, Chakkapong Chamroon¹, Ziv Brand²

Energy Engineering, Vol.120, No.1, pp. 147-161, 2023, DOI:10.32604/ee.2022.022821

Abstract This paper presents a theoretical and experimental study on controller design for the AMBs in a small-scale flywheel energy storage system, where the main goals are to achieve low energy consumption and improved rotordynamic stability. A H-infinity optimal control synthesis procedure is defined for the permanent-magnet-biased AMB-rotor system with 4 degrees of freedom. Through the choice of design weighting functions, notch filter characteristics are incorporated within the controller to reduce AMB current components caused by rotor vibration at the synchronous frequency and higher harmonics. Experimental tests are used to validate the controller design methodology and provide comparative results on performance… More >

Li Luo¹, Yuhang Fan¹, Yu Wang¹, Peiyong Ni¹, Xuewen Zhang¹, Guannan Xi^2,*

Energy Engineering, Vol.120, No.1, pp. 125-145, 2023, DOI:10.32604/ee.2022.022295

Abstract This paper aims to design a special exchanger to recover the exhaust gas heat of marine diesel engines used in small and medium-sized fishing vessels, which can then be used to heat water up to 55°C–85°C for membrane desalination devices to produce fresh water. A new exhaust-gas heat exchanger of fins and tube, with a reinforced heat transfer tube section, unequal spacing fins, a mixing zone between the fin groups and four routes tube bundle, was designed. Numerical simulations were also used to provide reference information for structural design. Experiments were carried out for exhaust gas waste heat recovery from… More >

Song Zhang¹, Wensheng Li², Zhao Li², Xiaolei Zhang¹, Zhipeng Lu¹, Xiaoning Ge^3,*

Energy Engineering, Vol.120, No.1, pp. 181-199, 2023, DOI:10.32604/ee.2022.022228

Abstract Driven by the goal of “carbon neutrality” and “emission peak”, effectively controlling system carbon emissions has become significantly important to governments around the world. To this end, a novel two-stage low-carbon economic scheduling framework that considers the coordinated optimization of ladder-type carbon trading and integrated demand response (IDR) is proposed in this paper for the integrated energy system (IES), where the first stage determines the energy consumption plan of users by leveraging the price-based electrical-heat IDR. In contrast, the second stage minimizes the system total cost to optimize the outputs of generations with consideration of the uncertainty of renewables. In… More >

Tao Hou¹, Shan Wang^1,2,*

Energy Engineering, Vol.120, No.1, pp. 87-106, 2023, DOI:10.32604/ee.2022.022122

Abstract The existing Maximum Power Point Tracking (MPPT) method has low tracking efficiency and poor stability. It is easy to fall into the Local Maximum Power Point (LMPP) in Partial Shading Condition (PSC), resulting in the degradation of output power quality and efficiency. It was found that various bio-inspired MPPT based optimization algorithms employ different mechanisms, and their performance in tracking the Global Maximum Power Point (GMPP) varies. Thus, a Cuckoo search algorithm (CSA) combined with the Incremental conductance Algorithm (INC) is proposed (CSA-INC) is put forward for the MPPT method of photovoltaic power generation. The method can improve the tracking… More > Graphic Abstract

Jun Zhou^1,*, Shijie Fang¹, Jinghong Peng¹, Qing Li², Guangchuan Liang^1,*

Energy Engineering, Vol.120, No.1, pp. 221-243, 2023, DOI:10.32604/ee.2022.020317

Abstract Underground energy storage is an important function of all energy supply systems, and especially concerning the seemingly eternal imbalance between production and demand. Salt rock underground energy storage, for one, is widely applied in both traditional and renewable energy fields; and this particular technique can be used to store natural gas, hydrogen, and compressed air. However, resource diversification and structural complexity make the supply system increasingly uncertain with the passing years, leading to great challenges for energy storage facilities in the present, and perhaps going into the future as well. Hence, it is necessary to research the operation stability of… More >

Hao Liu¹, Xiaoyang Zhang¹, Zhongjie Yan^1,*, Yingjian Yang^2,3, Qing’an Li^3,4,5, Chang Cai^3,4

Energy Engineering, Vol.120, No.1, pp. 163-179, 2023, DOI:10.32604/ee.2022.019927

Abstract The typical location and number of anemometer towers in the assessed area are the key to the accuracy of wind resource assessment in complex topography. As calculation examples, this paper used two typical complex topography wind farms in Guangxi, Yunnan province in China. Firstly, we simulated the wind resource status of the anemometer tower in the Meteodyn WT software. Secondly, we compared the simulated wind resource with the actual measured data by the anemometer tower in the same situation. Thirdly, we analyzed the influence of anemometer tower location and quantity in the accuracy of wind resource assessment through the comparison… More >

Khaled Bawaneh^1,*, Bradley Deken², Amin Esmaeili³

Energy Engineering, Vol.120, No.1, pp. 23-34, 2023, DOI:10.32604/ee.2023.019813

Abstract In this study, information on energy usage in the United States (U.S.) aerospace manufacturing sector has been analyzed and then represented as energy intensities (kWh/m²) to establish benchmark data and to compare facilities of varying sizes. First, public sources were identified and the data from these previously published sources were aggregated to determine the energy usage of aerospace manufacturing facilities within the U.S. From this dataset, a sample of 28 buildings were selected and the energy intensity for each building was estimated from the data. Next, as a part of this study the energy data for three additional aerospace manufacturing… More >

Muhammad Idris^1,*, I. Husin², Indra Hermawan¹, Uun Novalia³, R. D. Batubara¹, Nugroho Agung Pambudi^4,*, Alfan Sarifudin⁴

Energy Engineering, Vol.120, No.1, pp. 107-123, 2023, DOI:10.32604/ee.2023.019203

Abstract Diesel engines is an internal combustion engine with high thermal efficiency, which also uses biodiesel fuel, an environmentally friendly, non-toxic, and low sulfur content. Biodiesel has been around for a long time due to its similar characteristics to diesel fuels which has limited availability. However, several disadvantages are associated with biodiesel, such as poor volatility and high viscosity, which reduces engine performance. Therefore, this study was carried out to improve the diesel engine performance by mixing biodiesel with ecodiesel (ED), an additive produced from natural ingredients that is dissolvable in biodiesel. The biodiesel fuel properties used are  density 860 kg/, dynamic… More >

Zhenyi Feng^*, Nina Mo, Shujuan Dai, Yu Xiao, Xia Cheng

Energy Engineering, Vol.120, No.1, pp. 201-219, 2023, DOI:10.32604/ee.2022.023471

Abstract The construction of relevant standards for building carbon emission assessment in China has just started, and the quantitative analysis method and evaluation system are still imperfect, which hinders the development of lowcarbon building design. Therefore, the use of intelligent energy management system is very necessary. The purpose of this paper is to explore the design optimization of low-carbon buildings based on intelligent energy management systems. Based on the proposed quantitative method of building carbon emission, this paper establishes the quota theoretical system of building carbon emission analysis, and develops the quota based carbon emission calculation software. Smart energy management system… More >