Amnart Boonloi^a, Withada Jedsadaratanachai^b,*

Frontiers in Heat and Mass Transfer, Vol.14, pp. 1-11, 2020, DOI:10.5098/hmt.14.27

Abstract Numerical predictions on heat transfer characteristic, flow topology and thermal performance assessment in a square duct are presented. The passive technique, insertion of the vortex generator, is opted to develop the heat transfer rate in the square duct heat exchanger. The vortex generator of the present research is Double V-Orifice (DVO). The square duct equipped with DVO is tested with various parameters. The influences of DVO height, b, to the duct height, H, or b/H, gap spacing between the outer edge of the orifice and the duct wall, s, to the duct height or s/H and flow directions (tip-pointing-Downstream and… More >

Amnart Boonloi^a, Withada Jedsadaratanachai^b,*

Frontiers in Heat and Mass Transfer, Vol.18, pp. 1-13, 2022, DOI:10.5098/hmt.18.2

Abstract This study numerically investigates pressure loss, heat transfer and thermal efficiency in round tube heat exchangers attached with various types of Vrings. A typical type A V-ring is compared with two types of modified V-rings (type B and C). The impacts of blockage ratios, b/D = 0.05, 0.10, 0.15 and 0.20 for all V-ring types in the turbulent region are discussed (Re = 3000 – 20,000). Flow directions in the round pipe attached with the V-rings are varied. The V-apex setting downstream is referred to as “V-Downstream, while the V-apex setting upstream is referred to as “V-Upstream”. The flow and… More >