Weera Punin*, Somchai Maneewan, Chantana Punlek
Frontiers in Heat and Mass Transfer, Vol.11, pp. 1-5, 2018, DOI:10.5098/hmt.11.22
Abstract In the present experimental investigation, ethylene glycol cooling in a plate-fin heat sink was attached inside an aluminum cooling block for the
cooling unit of a thermoelectric (TE) power generator system. The plate-fin heat sink with two different fin heights was made from aluminum with
length, width and base thickness of 300, 200, and 25 mm, respectively. The ethylene glycol was used as a coolant. The effects of fin height, coolant
volume flow rate, and hot side surface temperature were considered for the temperature differences between the hot side surface and cold side surface
of the TE power module. The… More >
Login
Register
