Hamdy A. Ziedan¹, Hegazy Rezk^2,3, Mujahed Al-Dhaifallah^4,*

CMC-Computers, Materials & Continua, Vol.67, No.1, pp. 491-518, 2021, DOI:10.32604/cmc.2021.014493 - 12 January 2021

Abstract A new accurate algorithms based on mathematical modeling of two parallel transmissions lines system (TPTLS) as influenced by the mutual effect to determine the fault location is discussed in this work. The distance relay measures the impedance to the fault location which is the positive-sequence. The principle of summation the positive-, negative-, and zero-sequence voltages which equal zero is used to determine the fault location on the TPTLS. Also, the impedance of the transmission line to the fault location is determined. These algorithms are applied to single-line-to-ground (SLG) and double-line-to-ground (DLG) faults. To detect the More >

Hongchun Shu^1,2, Xiaohan Jiang^1,2,*, Pulin Cao², Na An², Xincui Tian², Bo Yang²

Energy Engineering, Vol.118, No.1, pp. 53-71, 2021, DOI:10.32604/EE.2020.012381 - 17 November 2020

Abstract The system impedance instability, high-order harmonics, and frequency offset are main fault characteristics of wind power system. Moreover, the measurement angle of faulty phase is affected by rotation speed frequency component, which causes traditional directional protections based on angle comparison between voltage and current to operate incorrectly. In this paper, a time-domain protection for connected to wind power plant based on model matching is proposed, which compares the calculated current and the measured current to identify internal faults and external faults. Under external faults, the calculated current and measured current waveform are quite similar because… More >

Qigang Sun¹, Jian Wu¹, Dahai Wang^2,*, Yue Xiang², Haitao Liu¹, Xiaobin Sun³

CMES-Computer Modeling in Engineering & Sciences, Vol.124, No.1, pp. 287-302, 2020, DOI:10.32604/cmes.2020.09118 - 19 June 2020

Abstract Downburst event is identified as a major cause to failure of transmission lines in non-coastal regions. In this paper, a novel nonlinear analytical frame for quasi-static buffeting responses of hinged and multi-span insulator-line systems are derived based on the theory of cable structure. The closed-form solutions are presented and applied to predict nonlinear response including displacements and other reactions of the system subjected to a moving downburst wind in a case study. Accuracy and efficiency of the derived analytical frame are validated via comparisons with results from finite element method. More >

Maciej Dutkiewicz^1,*, Marcela R. Machado²

Sound & Vibration, Vol.53, No.4, pp. 161-175, 2019, DOI:10.32604/sv.2019.04803

Abstract In the paper an important issue of vibrations of the transmission line in real conditions was analyzed. Such research was carried out by the authors of this paper taking into account the cross-section of the cable being in use on the transmission line. Analysis was performed for the modern ACSR high voltage transmission line with span of 213.0 m. The purpose of the investigation was to analyze the vibrations of the power transmission line in the natural environment and compare with the results obtained in the numerical simulations. Analysis was performed for natural and wind… More >

Marco Orellana¹, Jordi Selga¹, Paris Vélez¹, Marc Sans¹, Ana Rodríguez², Vicente Boria², Ferran Martín¹

CMC-Computers, Materials & Continua, Vol.52, No.3, pp. 159-174, 2016, DOI:10.3970/cmc.2016.052.157

Abstract This paper is focused on the automated synthesis of wideband bandpass filters operating at microwave frequencies and based on electromagnetic bandgap (EBG) structures. The classical counterpart of such filter consists of a combination of transmission line sections and shunt-connected grounded stubs placed at equidistant positions. By replacing the transmission line sections with capacitively-loaded lines (a kind of EBG-based lines) exhibiting the same phase shift at the lower cutoff frequency and the same characteristic (actually Bloch) impedance, filter size is reduced and the spurious pass bands can be efficiently suppressed. In practice, the loading capacitances are… More >

Raveendranath U. Nair, Preethi D.S, R. M. Jha

CMC-Computers, Materials & Continua, Vol.40, No.2, pp. 131-144, 2014, DOI:10.3970/cmc.2014.040.131

Abstract Controllable artificial dielectrics are used in the design of radomes to enhance their electromagnetic (EM) performance. The fabrication of such radome wall structures with controllable dielectric parameters seems to be an arduous task. Further even minor fluctuations of dielectric properties of radome wall due to fabrication uncertainties tend to result in drastic degradation of radome performance parameters. In the present work, a novel inhomogeneous radome with graded variation of dielectric parameters is proposed which limits the constraints on fabrication and facilitates excellent EM performance characteristics. This radome wall consists of five dielectric layers cascaded such More >

Shiv Narayan¹, Latha S.¹ and R M Jha¹

CMC-Computers, Materials & Continua, Vol.39, No.3, pp. 217-230, 2014, DOI:10.3970/cmc.2014.039.217

Abstract The EM analysis of multi-layered metamaterial based radar absorbing structure (RAS) with dual-band characteristics in millimeter wave frequency regime has been carried out in this paper using transmission line transfer matrix (TLTM) method for TE and TM polarizations. The proposed metamaterial-based RAS exhibits dual-band characteristics at centre frequencies 120 GHz and 175 GHz with very low power reflection. It absorbs more than 90% power of incidence wave over the frequency range from 111-131 GHz at first resonance and from 164.5-185 GHz at second resonance without metal backing plate, which is desirable for stealth applications. It More >

Raveendranath U Nair¹, R M Jha¹

CMC-Computers, Materials & Continua, Vol.37, No.2, pp. 109-121, 2013, DOI:10.3970/cmc.2013.037.109

Abstract Enhancement of electromagnetic performance of A-sandwich radome using aperture-type Jerusalem cross frequency selective surface (FSS) is presented. The Jerusalem cross FSS array is embedded in the mid-plane of the core of Asandwich radome to enhance the EM performance parameters over the entire Xband. For modeling the Jerusalem cross FSS embedded radome panel and evaluation of its EM performance parameters, equivalent transmission line method in conjunction with equivalent circuit model is used. A comparative study of Jerusalem cross FSS embedded A-sandwich radome and A-sandwich radome of identical material and thickness (core and skin layers) indicate that More >

Shiv Narayan¹, R M Jha¹

CMC-Computers, Materials & Continua, Vol.37, No.2, pp. 97-108, 2013, DOI:10.3970/cmc.2013.037.097

Abstract A novel metamaterial based FSS (frequency selective surfaces) structure is presented in this paper for wideband airborne radome applications. The proposed metamaterial-FSS structure consists of three layers, where a DPS (double positive sign) layer is sandwiched between a MNG (μ-negative) and ENG (ε- negative) layer, exhibits very good bandpass characteristics inside the operational band along with excellent roll-off characteristics outside the band. The EM performance analysis of the proposed structure has been carried out using transmission line transfer matrix (TLTM) method, which shows excellent bandpass characteristics over a wide frequency range. The transmission efficiency is More >

Shiv Narayan¹, Latha S.¹, R M Jha¹

CMC-Computers, Materials & Continua, Vol.34, No.2, pp. 131-142, 2013, DOI:10.3970/cmc.2013.034.131

Abstract The EM performance analysis of a multilayered metamaterial based radar absorbing structure (RAS) has been presented in this paper based on transmission line transfer matrix (TLTM) method for millimeter wave applications. The proposed metamaterial-RAS consists of cascaded DPS and MNG layers of identical configurations. It exhibits extremely low reflection (< 42 dB) at 95 GHz and absorbs more than 95% power of incident wave over the frequency range of 90.4- 100 GHz without metal backing for both TE and TM polarizations. In view of aerospace applications, the reflection, transmission, and absorption characteristics of the proposed More >