Ajay Veludurthi¹, Venkateshwarlu Bolleddu^2,*

Energy Engineering, Vol.117, No.2, pp. 49-61, 2020, DOI:10.32604/EE.2020.010666

Abstract This work focused on modal and harmonic analysis of small wind turbine blades taken from the NACA 63415 series. The sandwich structure type composite blade is fabricated from GFRP and epoxy with Uni-vinyl hard foams of different alignments as stiffeners. In this work, the modal and harmonic analysis of different varieties of blades like solid, hallow and rectangular alignment blades is carried out by the finite element method using ANSYS 18.1 software. From Finite Element Analysis, the natural frequencies, amplitudes and mode shapes are obtained. Based on the working principle of wind turbine blades, the boundary conditions are applied. The… More >

Wei LIU, Jiacong YIN, Pu CHEN, Xianyue SU

The International Conference on Computational & Experimental Engineering and Sciences, Vol.17, No.4, pp. 127-128, 2011, DOI:10.3970/icces.2011.017.127

Abstract In this paper, parametric modeling technique is employed to fast build the three-dimensional finite element shell model of a preliminarily designed large composite wind turbine blade, which is subsequently used in the dynamic analysis and static elastic aeroelastic stability analysis of the blade. In the dynamic analysis, natural frequencies and corresponding modal shapes are obtained for the blade in the case of being still as well as being rotating with rated revolution. For the rotating blade, the stress stiffening effect and spin-softening effect due to the centrifugal forces are taken into account. The static elastic aeroelastic stability analysis, i.e. buckling… More >

Wei Liu¹, Yiwei Wang¹, Yiran An¹, Xianyue Su^1,2

The International Conference on Computational & Experimental Engineering and Sciences, Vol.10, No.1, pp. 27-28, 2009, DOI:10.3970/icces.2009.010.027

Abstract Understanding the aeroelastic behavior of the blade is crucial to the design of large wind turbines, which has been attracting more and more research efforts. Essentially, the aeroelasticity problem of wind turbine blades is a fluid-solid interaction problem with obvious interface. At the present time, in the aeroelasticity analysis of wind turbine, CFD software based on the incompressible Reynolds-averaged Navier-Stokes (RANS) equations are not yet routinely used , in part because of the lack of experience with regard to the application of these software to various wind turbine rotors for a wide range of conditions and the complexity of the… More >

W. Liu, X. Y. Su, Y. R. An, K. F. Huang¹

CMC-Computers, Materials & Continua, Vol.25, No.2, pp. 177-194, 2011, DOI:10.3970/cmc.2011.025.177

Abstract Local buckling is a typical failure mode of large scale composite wind turbine blades. A procedure for predicting the onset and location of local buckling of composite wind turbine blades under aerodynamic loads is proposed in this paper. This procedure is distinct from its counterparts in adopting the pressure distributions obtained from Computational Fluid Dynamics (CFD) calculations as the loads. The finite element method is employed to investigate local buckling resistance of the composite blade. To address the mismatch between the unstructured CFD grids of the blade surface and the finite shell elements used during the buckling analysis, an interpolation… More >