Ans Ahmed Memon¹, Laveet Kumar^1,2,*, Abdul Ghafoor Memon¹, Khanji Harijan¹, Ahmad K. Sleiti²

Frontiers in Heat and Mass Transfer, Vol.23, No.3, pp. 833-856, 2025, DOI:10.32604/fhmt.2025.064805 - 30 June 2025

Abstract Climate change, rising fuel prices, and fuel security are some challenges that have emerged and have grown worldwide. Therefore, to overcome these obstacles, highly efficient thermodynamic devices and heat recovery systems must be introduced. According to reports, much industrial waste heat is lost as flue gas from boilers, heating plants, etc. The primary objective of this study is to investigate and compare unary (Al₂O₃) thermodynamically, binary with three different combinations of nanoparticles namely (Al₂O₃ + TiO₂, TiO₂ + ZnO, Al₂O₃ + ZnO) and ternary (Al₂O₃ + TiO₂ + ZnO) as a heat transfer fluid. Initially, three different types of… More > Graphic Abstract

Adalberto Benavides-Mendoza¹, Rebeca Betancourt-Galindo², Nazario Francisco-Francisco^3,*

Phyton-International Journal of Experimental Botany, Vol.92, No.6, pp. 1831-1840, 2023, DOI:10.32604/phyton.2023.028085 - 11 April 2023

Abstract

Micronutrient nanoparticles (NPs) are currently an option for chemical fertilization and biostimulation in crops. However, there is little information on the phytotoxic or biostimulatory effects of NPs at low concentrations of some elements, such as Zn. In this study, the effect of low concentrations of Zn oxide (ZnO) NPs on germination, growth variables, and nutritional attributes of lettuce (Lactuca sativa L.) was evaluated in comparison to Zn sulfate. Romaine lettuce seeds were treated with ZnSO₄^-- × 7H₂O and ZnO NPs at Zn molar concentrations of 1 × 10⁻³, 5 × 10⁻³, 1 × 10⁻⁴, 5 × 10⁻⁴, 1

… More >

José Vulfrano González-Fernández^1,*, Diego David Pinzón-Moreno¹, Antony Alexander Neciosup-Puican², María Verónica Carranza-Oropeza¹

Journal of Renewable Materials, Vol.10, No.3, pp. 833-847, 2022, DOI:10.32604/jrm.2021.017377 - 28 September 2021

Abstract ZnO nanoparticles (ZnO-NP) present innovative optical, electrical, and magnetic properties that depend on specific characteristics, e.g., size, distribution, and morphology. Thus, these properties are essential to address various applications in areas such as electronics, medicine, energy, and others. In addition, the performance of this ZnONP depends of their preparation which can be done by chemical, physical, and biological methods. Meanwhile, nowadays, the main interest in developing ZnO-NP synthesis through biological methods bases on the decrease of use of toxic chemicals or energy applied to the procedures, making the process more cost-effective and environmentally friendly. However,… More >

F. Luzi¹, E. Fortunati^1*, A. Jiménez², D. Puglia¹, A. Chiralt², L. Torre¹

Journal of Renewable Materials, Vol.5, No.2, pp. 103-115, 2017, DOI:10.7569/JRM.2016.634135

Abstract Poly(lactic acid) (PLA) based nanocomposites reinforced with 1 wt% of surfactant-modified cellulose nanocrystals (s-CNC) extracted from Posidonia oceanica plant waste and zinc oxide nanoparticles (ZnO NPs) at different concentrations (0.1 and 0.5 wt%) were prepared by solvent casting process. Their thermal, morphological, optical, mechanical and water vapor permeability properties were investigated. Tensile testing showed increased values for strength and deformation at break in PLA based formulations reinforced with s-CNC and ZnO NPs as a consequence of better nanofiller dispersion compared to binary films reinforced only with ZnO NPs. Moreover, the effect of s-CNC and ZnO More >