M. Farid Yahya¹, Reduan Mat Dan^2,3,*, M. Fadzlee Samsubaha¹, Zaini Rashid¹, Azma Putra^2,3,*

Sound & Vibration, Vol.57, pp. 119-131, 2023, DOI:10.32604/sv.2023.045029

Abstract A case study of excessive vibration on a motor-compressor system is presented in this paper. After barely two months of operation, the reciprocating compressor motor’s routine monitoring revealed excessive axial vibration amplitude. For this reason, the Operational Modal Analysis (OMA) was carried out in order to identify the primary cause. According to the investigation, one of the harmonic components which was 18 times the motor’s running speed matched with a resonance frequency of 112 Hz. According to OMA study, the motor was vibrating in torsional motion because the compressor’s load had stimulated the entire motor-compressor unit at this resonance frequency.… More >

Zhen Zhong^*, Yadong Li, Yuxuan Zhao, Pengfei Ju

Sound & Vibration, Vol.57, pp. 15-27, 2023, DOI:10.32604/sv.2023.041954

Abstract Bent-housing motor is the most widely used directional drilling tool, but it often encounters the problem of high friction when sliding drilling in horizontal wells. In this paper, a mathematical model is proposed to simulate slide drilling with a friction reduction tool of axial vibration. A term called dynamic effective tractoring force (DETF) is defined and used to evaluate friction reduction effectiveness. The factors influencing the DETF are studied, and the tool placement optimization problem is investigated. The study finds that the drilling rate of penetration (ROP) can lower the DETF but does not change the trend of the DETF… More >