Shihong Zhang^*，Zhihua Wang

Frontiers in Heat and Mass Transfer, Vol.4, No.2, pp. 1-6, 2013, DOI:10.5098/hmt.v4.2.3005

Abstract This article discussed exhaust gas temperature and pollutant emissions characteristics of the combustion of rich natural gas-air mixtures in Pd metal based honeycomb monoliths burner during the period of start-up process. The burner needs to be ignited by gas phase combustion with the excessive air coefficient (a) at 1.3. The chemistry at work in the monoliths was then investigated using the stagnation point flow reactor or SPFR. The experimental results in catalytic monolith can be explained from SPFR. The exhaust gas temperature and pollutant emissions were measured by thermocouple K of diameter 0.5 and the analyser every 1 minute, respectively.… More >

Jialin Tong^1,2, Yan Zhang², Ruikang Wu¹, Xiaojuan Qi¹, Xuemin Ye^2,*

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.4, pp. 1027-1041, 2023, DOI:10.32604/fdmp.2022.022303

Abstract A 600 MW coal-fired boiler with a four-corner tangential combustion mode is considered here to study the combustion features and pollutant emissions at different loads for large-percentages of blending dried sludges. The influence of the over-fired air (OFA) coefficient is examined and the impact of the blending ratio on the boiler operation is explored. The results show that for low blending ratios, a slight increase in the blending ratio can improve the combustion of bituminite, whereas a further increase leads to the deterioration of the combustion of blended fuels and thus reduces the boiler efficiency. Enhancing the supporting capability of the… More > Graphic Abstract