P.A. Meroño¹, F.C. Gómez², F. Marín¹

CMC-Computers, Materials & Continua, Vol.47, No.2, pp. 107-125, 2015, DOI:10.3970/cmc.2015.047.107

Abstract This work represents a comparative study of Wavelet Transform of angular vibration signal and the traditional Fourier analysis applied to the signals of angular vibration, in one transmission which involve gears. How it is known, the elastic deformation of the material, together with the superficial irregularities of the teeth due to wear, provoke characteristic angular oscillations, which make it possible to distinguish between the regular functioning of a mechanism in good condition and the angular vibrations provoked by wear and the superficial irregularities of teeth in poor condition. However, the character of the vibrations produced in such circumstances means that… More >

Hao Zuo^1,2, Zhibo Yang^1,2,3, Xuefeng Chen^1,2, Yong Xie⁴, Xingwu Zhang^1,2

CMC-Computers, Materials & Continua, Vol.44, No.3, pp. 167-204, 2014, DOI:10.3970/cmc.2014.044.167

Abstract Following previous work, a wavelet finite element method is developed for bending, free vibration and buckling analysis of functionally graded (FG) plates based on Mindlin plate theory. The functionally graded material (FGM) properties are assumed to vary smoothly and continuously throughout the thickness of plate according to power law distribution of volume fraction of constituents. This article adopts scaling functions of two-dimensional tensor product BSWI to form shape functions. Then two-dimensional FGM BSWI element is constructed based on Mindlin plate theory by means of two-dimensional tensor product BSWI. The proposed two-dimensional FGM BSWI element possesses the advantages of high convergence,… More >

Y. L. Liu¹, N. Hu², H. Xu³, H. Ning¹, L. K. Wu¹

CMC-Computers, Materials & Continua, Vol.40, No.1, pp. 1-20, 2014, DOI:10.3970/cmc.2014.040.001

Abstract A real-time monitoring technique for local plasticity using Lamb waves was developed. Tensile test of a thin aluminum plate with a circular hole where high stress concentration was induced was conducted to verify this technique. During the tensile test, a series of wave signals passing through the local plastic region were collected using a directional actuator/sensor set to monitor plasticity evolution. A pulse compression technique was used to process the wave signals. With the increase of tensile stress in the specimen, the amplitude changes of S₀ and A₀ modes were obtained and the difference of Lamb wave signals was further… More >