Tanzhong Fu^1,2,3, Yu Xue^1,*, Tancai Xia¹, Wang Jing¹, De Gejirifu¹

Energy Engineering, Vol., , DOI:10.32604/EE.2020.011633

Abstract To further study the impact of renewable energy penetration on the technical transformation of distribution networks. Based on the output power characteristics of wind power and photovoltaics, a renewable energy grid-connected capacity model and a distribution network full cost-benefit model were constructed. Based on this, to maximize the comprehensive income of the distribution network and the renewable energy penetration rate, to establish the technical reform optimization model and search for the optimal solution through the improved NSGA-II algorithm. Finally, the effectiveness of the proposed model was verified by setting up three scenarios of simultaneous wind power, grid-connected wind power, grid-connected… More >

Shafiqur Rehman¹, Umar T. Salman^2,*, Luai M. Alhems¹

Energy Engineering, Vol., , DOI:10.32604/EE.2020.011471

Abstract Renewable energy has received much attention in the last few decades and more investment is being attracted across the world to boost its contribution towards the existing energy mix. In the Kingdom of Saudi Arabia (KSA), many studies have been conducted on the potential of renewable energy sources (RES), such as wind, solar, and geothermal. Many of these studies have revealed that the Kingdom is blessed with an abundance of RES with wind energy being the best after solar. This paper presents an analysis of windfarm distributed generation (WFDG) for energy management strategy in the Eastern Province of KSA. The… More >

Shusheng Xiong¹, Defeng Xuan², Yonggen Zhang², Zhankuan Wu¹, Wei Li^1,*, Zhaohan Hu¹, Jing Xu¹

Energy Engineering, Vol., , DOI:10.32604/EE.2020.011975

Abstract This research studied catalytic reforming mechanism of low concentration alcohol, analyzed the producing conditions and influencing factors of a mixture of combustible gas, took an analysis towards the composition of the mixture produced by reforming, and studied the respective effects of temperature, traffic, alcohol concentration and catalyst on the components of mixed gas. It is found that, under different working conditions of the engine, the external condition of the reforming reaction changes, and the composition of the reforming gas will differ as well. As a result, the optimum air-fuel ratio of the engine must at the same time adapt to… More >

Wei Li¹, Shusheng Xiong^2,*, Xiaojun Zhou¹, Wei Shi³

Energy Engineering, Vol., , DOI:10.32604/EE.2020.011506

Abstract A multichannel temperature measurement system based on LabVIEW and modular instruments with general purpose input/output interface is described. External simple electronic components, such as analog switches arrays, sampling resistors and voltage reference are used to expand the analog input channel of the instrument. The interface circuit for 3-wire resistance temperature device powered by the voltage reference was designed and constructed. The feasibility of filtering algorithm based on moving average filter and the data conversion method by direct computation of the polynomial are verified in LabVIEW. A comparison test with the commercial temperature measurement instrument is conducted to test the same… More >