Yiwen Li^1,#, Hongyan Si^1,#, Peng Wang¹, Hai Luo¹, Minggui Shen², Xiaoping Rao³, Zhanqian Song², Shibin Shang², Zongde Wang^1,*, Shengliang Liao^1,*

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.031089

Abstract Turpentine is a renewable and resourceful forest product. The deep processing and utilization of turpentine, particularly its primary component β-pinene, has garnered widespread attention. This study aimed to synthesize 40 derivatives of β-pinene, including nopinone, 3-cyanopyridines of nopinone, myrtanyl acid, myrtanyl acylthioureas, and myrtanyl amides. We assessed the antiviral activities of these β-pinene derivatives against influenza virus A/Puerto Rico/8/34 (H1N1) using the 3-(4,5-dimetylthiazol-2-yl)-2,5-diphenyltetrazolium bromide method. The β-pinene derivatives were used before and after cellular infection with the influenza virus to evaluate their preventive and therapeutic effects against the H1N1 virus. The results showed that only compound 10o exhibited a preventive… More >

Bo Chen¹, Mingjun Wang², Bo Liu^3,*, Chunping Lu⁴, Guohai Jia¹, Yong Chao⁵, Chao Zhong¹

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.031521

Abstract In order to study the combustion characteristics of tar in biomass gasifier inner wall and gasification gas, “tobacco stem semi-tar inside furnace”, “tobacco stem tar inside furnace” and “tobacco stem tar out-of-furnace” were subjected to thermogravimetric experiments, and the combustion characteristics and kinetic characteristics were analyzed. The result shows that “tobacco stem semi-tar inside furnace” has the highest value and “tobacco stem tar out-of-furnace” is has the lowest value on ignition characteristics, combustion characteristics and combustible stability; “tobacco stem semi-tar inside furnace” has the lowest value and “tobacco stem tar outside furnace” has the highest value on burnout characteristics; “tobacco… More > Graphic Abstract

Annisa Ardiyanti, Suprapto Suprapto, Yatim Lailun Ni’mah^*

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.031354

Abstract Dyes are pervasive contaminants in wastewater, posing significant health risks to both humans and animals. Among the various methods employed for effective dye removal, adsorption has emerged as a highly promising approach due to its notable advantages, including high efficiency, cost-effectiveness, low energy consumption, and operational simplicity compared to alternative treatments. This comprehensive review focuses on investigating adsorbents derived from biowastes and biomass, specifically carbon-based and non-conventional adsorbents, for the removal of malachite green, a widely used dye known for its toxic and carcinogenic properties. Carbon-based adsorbents encompass two main types: activated carbon and biochar, while non-conventional adsorbents refer to… More >

Arnoldo E. Alfaro-Corres¹, Daniel González-Mendoza², Esaú Ruiz-Sánchez^1,*, Carlos Ail-Catzin², Benjamín Valdez-Salas³, Federico Gutiérrez-Miceli⁴, Arturo Reyes-Ramírez¹, Jacques Fils Pierre¹

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.031129

Abstract This work was carried out to evaluate the insecticidal effect of mono, bi and trimetallic nanoparticles (NPs) from leaf extract of habanero pepper (Capsicum chinense Jacq.) on the red flour beetle (Tribolium castaneum herbst.) and cotton mealybug (Phenacoccus solenopsis Tinsley). The results showed that Cu NPs, Cu/Mn NPs and Zn/Cu NPs had high insecticidal effect against T. castaneum (63%–80% mortality after 96 h). The Cu NPs and Zn/Cu NPs showed also insecticidal effect against P. solenopsis, but to a lesser extent (20%–28% after 96 h). With regards to the physicochemical characterization, Cu NPs had a zeta potential of 21.1 mV,… More >

Qiaoguang Li^1,*, Puyou Jia^2,*, Ying Luo³, Yue Liu⁴

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.044083

Abstract This article has no abstract. More >

Bio Chéïssou Koto Tamou^1,2,3, Jean-Michel Mechling², Crespin Prudence Yabi^1,*, Gildas Edjrossè F. Godonou³, Edmond Codjo Adjovi¹, Mohamed Gibigaye³, André Lecomte², Nicolas Brosse⁴

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.030509

Abstract The housing sector today uses elaborate materials such as cement, iron, sand, often prohibitively expensive and whose production generates a strong environmental impact (scarcity of resources, transport, greenhouse gas greenhouse, etc.). In order to meet the challenges of sustainable development, earth construction is experiencing a resurgence of interest these days. Despite its many advantages, raw earth material has drawbacks, in particular its low mechanical resistance and its loss of geometric characteristics in the face of water, which slow down its development. As part of this study, the mechanical characteristics and durability of raw earth were improved by using residual water… More >

Budhi Priyanto^1,2,*, Imam Khambali^1,2, Irma Septi Ardiani², Khoirotun Nadhiyah⁴, Anna Zakiyatul Laila², M. Chasrun Hasani¹, Bima Romadhon³, Retno Asih², Yoyok Cahyono², Triwikantoro², Darminto^2,*

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.028619

Abstract An a-C/a-C:N junction, which used palmyra sugar as the carbon source and ammonium hydroxide (NH₄OH) as the dopant source, was successfully deposited on the ITO glass substrate using the nano-spraying method. The current-voltage relationship of the junction was found to be a Schottky-like contact, and therefore the junction shows the characteristic rectifiers. This means the a-C and a-C:N are semiconductors with different types of conduction. Moreover, the samples showed an increase in current and voltage value when exposed to visible light (bright state) compared to the dark condition, thereby, indicating the creation of electron-hole pairs during the exposure. It was… More > Graphic Abstract

Jun Xiang^1,2,*, Xiaoqing Chen¹, Qi Liu¹, Huihua Jing², Tongqiang Chen², Wanli Tang², Wenyang Xu²

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.028090

Abstract Biomass-derived carbon dots (C-dots) are considered a very important carbon material in metal ion detection of their small environmental impact, simple preparation process, and relatively low cost. A green approach for synthesizing biomass-derived C-dots from Chenpi using a hydrothermal method without further processing is proposed in the present study. The as-synthesized C-dots show excellent fluorescence properties, superior resistance to UV irradiation photobleaching, and high photostability in salt-containing solutions. The C-dots were used in the form of label-free fluorescent probes for sensitively detecting Hg²⁺ selectively. The outcome relationship behaved linearly and was established based on a given range between 10–300 nM… More >

Hongqiong Zhang^1,2,#, Xu Wang^3,#, Zhaojing Qian⁴, Buchun Si^1,4,*, Kai Jin⁵, Tengfei Wang⁵

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.028438

Abstract Hydrochar prepared with four typical biowastes, pine wood, food waste, digested sewage sludge, and Chlorella were applied for the promotion of anaerobic digestion. The gas production and substrate composition were analyzed associated with the hydrochar characteristics. The results suggested that Chlorella hydrochar (C-C) showed the highest cumulative yield of methane (approximately 345 mL) with high total organic carbon (TOC) removal efficiency and low volatile fatty acids (VAFs) concentration. Especially, food waste hydrochar (F-C) showed a poor effect on anaerobic digestion and aroused 1.4–1.6 g/L accumulation of VAFs, in which the toxic components may account for the low efficiency. The C-C… More >

De Li^1,#, Bengang Zhang^1,#, Yuan Tu¹, Guoming Xiao¹, Meifen Tian², Xiaoxue Xu¹, Xiao Zhong¹, Qiaoyan Zhang³, Zhigang Wu^1,*, Jiankun Liang^4,*

Journal of Renewable Materials, Vol., , DOI:10.32604/jrm.2023.027895

Abstract Screw connection is a type most commonly applied to timber structures. As important commercial tree species in China, Masson pine and Chinese fir have the potential to prepare wood structures. In this study, the effects of the diameter of the self-tapping screw and the guiding bores on the nail holding performance on different sections of Masson pine and Chinese fir dimension lumbers were mainly explored. The results showed that: (1) The nail holding strength of the tangential section was the maximum, followed by that of the radial section, and that of the cross section was the minimum. (2) The nail… More >