Open Access
ARTICLE
Properties of ABS/Organic-Attapulgite Nanocomposites Parts Fabricated by Fused Deposition Modeling
Ling Wang1,2, Shenglong Jiang2, Chenchen Huang2, Pengyuan Dai2, Fenghua Liu2,*, Xiaopeng Qi1, Gaojie Xu2
1 Faculty of Materials Metallurgy and Chemistry, Jiangxi University of Science and Technology, Ganzhou, 341000, China
2 Key Laboratory of Additive Manufacturing Materials of Zhejiang Province, Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Science, Ningbo, 315201, China
* Corresponding Author: Fenghua Liu. Email:
(This article belongs to the Special Issue: Current Advances in Green Nanomaterials Applications)
Journal of Renewable Materials 2020, 8(11), 1505-1518. https://doi.org/10.32604/jrm.2020.010544
Received 17 April 2020; Accepted 26 May 2020; Issue published 28 September 2020
Abstract
The paper discusses the mechanical and thermal performance manifested in natural nanorods attapulgite (ATP) reinforced Acrylonitrile butadiene
styrene (ABS) nanocomposites in the process of fused deposition modeling
(FDM). Molten extrusion technique was taken to manufacture the filaments of
ABS/organic-attapulgite (OAT) nanocomposites with different mass fraction
and the printing operation was made by one commercial FDM three-dimensional
(3D) printer. Results indicate that the mechanical performance of these FDM 3D
printed specimens are improved obviously via the introduction of OAT, and tensile strength of the ABS/OAT nanocomposites parts with only 2 wt% OAT addition is enhanced by 48.1%. At the same time, the addition OAT can reduce the
linear expansion coefficient and creep flexibility, and improve the thermal stability
and dimensional accuracy of these FDM 3D printed parts.
Keywords
Cite This Article
APA Style
Wang, L., Jiang, S., Huang, C., Dai, P., Liu, F. et al. (2020). Properties of abs/organic-attapulgite nanocomposites parts fabricated by fused deposition modeling. Journal of Renewable Materials, 8(11), 1505-1518. https://doi.org/10.32604/jrm.2020.010544
Vancouver Style
Wang L, Jiang S, Huang C, Dai P, Liu F, Qi X, et al. Properties of abs/organic-attapulgite nanocomposites parts fabricated by fused deposition modeling. J Renew Mater. 2020;8(11):1505-1518 https://doi.org/10.32604/jrm.2020.010544
IEEE Style
L. Wang et al., "Properties of ABS/Organic-Attapulgite Nanocomposites Parts Fabricated by Fused Deposition Modeling," J. Renew. Mater., vol. 8, no. 11, pp. 1505-1518. 2020. https://doi.org/10.32604/jrm.2020.010544
Citations