Amer A. Abdulrahman¹, Bashar J. Kadhim¹, Zainab Y. Shnain¹, Hassan Sh. Majidi², Asawer A. Alwaiti^1,*, Farooq Al-Sheikh¹, Adnan A. AbdulRazak¹, Mohammed Shorbaz¹, Mazin J. Shibeeb³

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.10, pp. 2579-2595, 2023, DOI:10.32604/fdmp.2023.027454

Abstract The well-known frictional effect related to liquid-liquid two-phase flow in pipelines can be reduced using drag-reducing additives. In this study, such an effect has been investigated experimentally using a mixture of oil and water. Moreover, numerical simulations have been carried out using the COMSOL simulation software. The measurements were taken in a horizontal pipe with the length and diameter equal to 3 and 0.125 m, respectively. Moreover, Polyethylene oxide with 150 ppm was exploited to reduce the drag effect while considering different water-to-oil fractions (0.3, 0.4, 0.5, and 0.7) and a constant total flow velocity of 2.3 m/s. As made… More >

G. Nagaraju^a,∗ , Mahesh Garvandha^b, J.V. Ramana Murthy^c

Frontiers in Heat and Mass Transfer, Vol.13, pp. 1-8, 2019, DOI:10.5098/hmt.13.6

Abstract This paper analyzes a hypothesis of the 2−dimensional thermal transport behavior of Newtonian axisymmetric, viscous heating flow in a horizontal pipe. The flow is subjected to an externally applied uniform suction across the pipe wall in the polar direction, a constant magnetic field perpendicular to the wall and a uniform heat source/sink on the surface of the cylinder. The thermal boundary condition is imposed as a uniform heat flux. The Velocity fields are expressed in terms of stream function and the solution is obtained using the homotopy analysis method (HAM). Graphs are designed to analyze the significant effect on temperature… More >

M. Gh. Mohammed Kamil^1,*, M. S. Kassim¹, R. A. Mahmood^2,3, L. AZ Mahdi⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.18, No.4, pp. 985-998, 2022, DOI:10.32604/fdmp.2022.018938

Abstract This work investigates the steam condensation phenomena in an air-cooled condenser. The considered horizontal flattened tube has a 30 mm hydraulic diameter, and its length is a function of the steam quality with a limit value between 0.95 and 0.05. The mass flow rate ranges from 4 to 40 kg/m².s with a saturated temperature spanning an interval from 40°C to 80°C. A special approach has been implemented using the Engineering Equation Solver (EES) to solve a series of equations for the two-phase flow pattern and the related heat transfer coefficients. A wavy-stratified structure of the two-phase flow has been found when… More >

Mingjun Du^1,2, Jiaqiang Jing^1,*, Xinqiang Xiong³, Bingbing Lang², Xuan Wang², Shiying Shi^4,*

FDMP-Fluid Dynamics & Materials Processing, Vol.18, No.1, pp. 81-91, 2022, DOI:10.32604/fdmp.2022.016640

Abstract Transportation of heavy oil by the so-called water-ring technique is a very promising method by which pressure drop and pollution can be significantly reduced. Dedicated experiments have been carried out by changing the phase’s density, viscosity, velocity and interfacial tension to systematically analyze the characteristics of the water ring. On the basis of such experimental data, a mathematical model for pressure drop prediction has been introduced. This research shows that as long as the density of oil and water remains the same, a concentric water ring can effectively be formed. In such conditions, the oil-water viscosity difference has little effect… More >

Li Lei¹, Jun An¹, Fushun Liang¹, Cheng Cheng¹, Naixiang Zhou², Yanhong Ning³, Jingzhi Zhang^1,4,*

FDMP-Fluid Dynamics & Materials Processing, Vol.17, No.6, pp. 1037-1048, 2021, DOI:10.32604/fdmp.2021.016081

Abstract The flow patterns and the void fraction related to a gas-liquid two-phase flow in a small channel are experimentally studied. The test channel is a transparent quartz glass circular channel with an inner diameter of 6.68 mm. The working fluids are air and water and their superficial velocities range from 0.014 to 8.127 m/s and from 0.0238 to 0.556 m/s, respectively. The void fraction is determined using the flow pattern images captured by a high-speed camera, while quick closing valves are used for verification. Four flow patterns are analyzed in experiments: slug flow, bubbly flow, annular flow and stratified flow.… More >

Xinke Yang¹, Shanzhi Shi¹, Hui Zhang¹, Yuzhe Yang^2,3, Zilong Liu^2,3, Ruiquan Liao^2,3,*, Joseph X. F. Ribeiro⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.17, No.2, pp. 371-383, 2021, DOI:10.32604/fdmp.2021.011486

Abstract The accurate prediction of the pressure distribution of highly viscous fluids in wellbores and pipelines is of great significance for heavy oil production and transportation. The flow behavior of high-viscosity fluids is quite different with respect to that of low-viscosity fluids. Currently, the performances of existing pressure-drop models seem to be relatively limited when they are applied to high-viscosity fluids. In this study, a gas-liquid two-phase flow experiment has been carried out using a 60 mm ID horizontal pipe with air and white oil. The experimental results indicate that viscosity exerts a significant influence on the liquid holdup and pressure… More >