Tomio Okawa^*,†

Frontiers in Heat and Mass Transfer, Vol.3, No.1, pp. 1-8, 2012, DOI:10.5098/hmt.v3.1.3001

Abstract The present article summarizes the studies on the thermalhydraulic condition under which the onset of nucleate boiling (ONB) is triggered in subcooled flow boiling. Available correlations and experimental data show that the ONB is tended to be delayed in mini and microchannels. It is known that the ONB condition is significantly dependent on the surface condition even in conventional-sized channels. Accumulation of ONB data accompanied by the information on the surface condition is therefore considered of importance to elucidate the mechanisms of boiling incipience in microchannels. Discussion is also made for the bubble dynamics observed in mini and microchannels. It… More >

Frontiers in Heat and Mass Transfer, Vol.3, No.1, pp. 1-3, 2012, DOI:10.5098/hmt.v3.1.1001

Abstract This article has no abstract. More >

Soumei Baba^a,*, Nobuo Ohtani^a, Osamu Kawanami^b, Koichi Inoue^c, Haruhiko Ohta^a

Frontiers in Heat and Mass Transfer, Vol.3, No.4, pp. 1-8, 2012, DOI:10.5098/hmt.v3.4.3002

Abstract Effects of tube orientation on flow boiling heat transfer coefficients were investigated for FC72 flowing in single mini-tubes with tube diameters of 0.13 and 0.51 mm to define boundaries on a dominant force regime map. For the tube diameter of 0.51 mm, when mass velocity and vapor quality was varied, heat transfer coefficients were influenced by tube orientation at Froude number Fr < 4, while the effect of tube orientation on heat transfer coefficients disappears at Fr > 4. The results indicated that the boundary between the body force dominated and the inertia dominated regimes was given by Fr ≈… More >

Mohamed S. El-Genk^a,b,c,∗, Amir F. Ali^a,c

Frontiers in Heat and Mass Transfer, Vol.3, No.4, pp. 1-14, 2012, DOI:10.5098/hmt.v3.4.3001

Abstract Advanced spreaders for cooling a 10 x 10 mm underlying computer chip with a central hot spot (CHS) could remove > 85 W of dissipated thermal power at junctions’ temperature < 100o C. The spreaders comprise a 1.6 - 3.2 mm thick Cu substrate and an 80-μm thick micro-porous copper (MPC) surface cooled by saturation nucleate boiling of PF-5060 dielectric liquid. Investigated are the effects of varying the heat flux at the chip’s 1 and 4 mm² CHS and the impedance of thermal interface material (TIM) between the Cu substrate and underlying chip. Results confirmed the effectiveness of the MPC… More >

Di Peng^1,2, Guoqing Chen¹, Jiale Yan^1,*, Shiping Wang^2,*

CMES-Computer Modeling in Engineering & Sciences, Vol.139, No.3, pp. 2947-2964, 2024, DOI:10.32604/cmes.2024.047265

Abstract Cavitation is a prevalent phenomenon within the domain of ship and ocean engineering, predominantly occurring in the tail flow fields of high-speed rotating propellers and on the surfaces of high-speed underwater vehicles. The re-entrant jet and compression wave resulting from the collapse of cavity vapour are pivotal factors contributing to cavity instability. Concurrently, these phenomena significantly modulate the evolution of cavitation flow. In this paper, numerical investigations into cloud cavitation over a Clark-Y hydrofoil were conducted, utilizing the Large Eddy Simulation (LES) turbulence model and the Volume of Fluid (VOF) method within the OpenFOAM framework. Comparative analysis of results obtained… More > Graphic Abstract

Shen Yan¹, Dajiang Geng^2,*, Ning Dai³, Mingjian Long², Zhicheng Bai²

CMES-Computer Modeling in Engineering & Sciences, Vol.139, No.3, pp. 2893-2915, 2024, DOI:10.32604/cmes.2024.046931

Abstract According to the design specifications, the construction of extended piles involves traversing the tunnel’s upper region and extending to the underlying rock layer. To address this challenge, a subterranean transfer structure spanning multiple subway tunnels was proposed. Deliberating on the function of piles in the transfer structure as springs with axial and bending stiffness, and taking into account the force balance and deformation coordination conditions of beams and plates within the transfer structure, we established a simplified mechanical model that incorporates soil stratification by combining it with the Winkler elastic foundation beam model. The resolved established simplified mechanical model employed… More >

Perla Patricia Ochoa-García¹, Jaime Sánchez-Salas², Ricardo Trejo-Calzada¹, Jesús Josafath Quezada-Rivera², Fabián García-González^1,*

Phyton-International Journal of Experimental Botany, Vol.93, No.2, pp. 371-386, 2024, DOI:10.32604/phyton.2024.048338

Abstract The genus Argemone L. (Papaveraceae) is found widely distributed in Mexico’s Chihuahuan Desert (CD). Some species of this genus are of phytochemical or ethnobotanical interest. They are inedible plants considered as scrubs. To date they have not been broadly studied; thus, their ecology is, to our knowledge, unknown. The present work was centered around carrying out a morphometric analysis and the determination of minerals in the soil and seeds of the wild populations of Argemone at sites belonging to two ecoregions of the CD in Mexico. In April 2021 and April 2022, seeds of Argemone spp., and soil samples were… More >

Eduardo Burgos-Valencia^1,#, Federico García-Laynes^1,#, Ileana Echevarría-Machado¹, Fatima Medina-Lara¹, Miriam Monforte-González¹, José Narváez-Zapata^2,*, Manuel Martínez-Estévez^1,*

Phyton-International Journal of Experimental Botany, Vol.93, No.2, pp. 151-183, 2024, DOI:10.32604/phyton.2023.046943

Abstract Habanero pepper (Capsicum chinense Jacq.) is a crop of economic relevance in the Peninsula of Yucatan. Its fruits have a high level of capsaicinoids compared to peppers grown in other regions of the world, which gives them industrial importance. Soil is an important factor that affects pepper development, nutritional quality, and capsaicinoid content. However, the effect of soil type on fruit development and capsaicinoid metabolism has been little understood. This work aimed to compare the effect of soils with contrasting characteristics, black soil (BS) and red soil (RS), on the expression of genes related to the development of fruits, and… More >

Qi Zhuang^1,*, Dong Liu², Zhuo Chen³

Energy Engineering, Vol.121, No.3, pp. 821-834, 2024, DOI:10.32604/ee.2023.044054

Abstract Oil and gas pipelines are affected by many factors, such as pipe wall thinning and pipeline rupture. Accurate prediction of failure pressure of oil and gas pipelines can provide technical support for pipeline safety management. Aiming at the shortcomings of the BP Neural Network (BPNN) model, such as low learning efficiency, sensitivity to initial weights, and easy falling into a local optimal state, an Improved Sparrow Search Algorithm (ISSA) is adopted to optimize the initial weights and thresholds of BPNN, and an ISSA-BPNN failure pressure prediction model for corroded pipelines is established. Taking 61 sets of pipelines blasting test data… More >

Mohamed Ammar^1,*, Alireza Mousavi¹, Hamed Al-Raweshidy^2,*

Digital Engineering and Digital Twin, Vol.2, pp. 1-31, 2024, DOI:10.32604/dedt.2023.044930

Abstract The advent of technology around the globe based on the Internet of Things, Cloud Computing, Big Data, Cyber-Physical Systems, and digitalisation. This advancement introduced industry 4.0. It is challenging to measure how enterprises adopt the new technologies. Industry 4.0 introduced Digital Twins, given that no specific terms or definitions are given to Digital Twins still challenging to define or conceptualise the Digital Twins. Many academics and industries still use old technologies, naming it Digital Twins. This young technology is in danger of reaching the plateau despite the immense benefit to sectors. This paper proposes a novel and unique definition for… More >