Louis F. Marie^*, Karina Sałek, Tadhg S. O’Donovan

Energy Engineering, Vol.120, No.10, pp. 2193-2209, 2023, DOI:10.32604/ee.2023.043075

Abstract Composite thermochemical energy storage (TCES) represents an exciting field of thermal energy storage which could address the issue of seasonal variance in renewable energy supply. However, there are open questions about their performance and the root cause of some observed phenomena. Some researchers have observed the breakdown of particles in their production phase, and in their use. This study seeks to investigate the underlying cause of this breakdown. SEM and EDX analysis have been conducted on MgCl₂ impregnated 13X zeolite composites of differing diameters, as well as LiX zeolite. This was done in order to study the level of impregnation… More > Graphic Abstract

Lingling Qin¹, Mengya Zhou¹, Jiahao Yan¹, Ping Duan^1,2,3,4,*, Yingcan Zhu^5,*, Wei Chen⁶, Zuhua Zhang⁷, Aiguo Wang²

Journal of Renewable Materials, Vol.11, No.5, pp. 2191-2208, 2023, DOI:10.32604/jrm.2023.025197

Abstract Montmorillonite and clinoptilolite zeolite were used as representative materials to prepare calcined clay-cement binary cementitious materials in order to study the effect of calcination treatment on the activation of clay minerals and the activity difference between layered and framed clays in this research. The influence of different calcined clay content (2%, 4%, 6%, 8%, 10%) on the fluidity, compressive strength, microstructure, phase change, and hydration heat of cement-based materials were analyzed. The calcined clay improves the fluidity of cement-based materials as compared with the uncalcined group. The addition of calcined montmorillonite (CMT) improves the development of mechanical strength, and the… More > Graphic Abstract

Fulin Wang^*, Xinyang Geng, Zhengping Yuan, Shijiao Yang^*

Journal of Renewable Materials, Vol.11, No.3, pp. 1469-1484, 2023, DOI:10.32604/jrm.2022.024994

Abstract The use of some environmental functional minerals as backfill-modified materials may improve the leaching resistance of cemented uranium tailings backfill created from alkali-activated slag (CUTB), but these materials may participate in the hydration reaction of the cementitious materials, which could have a certain impact on the pore structure of the CUTB, thus affecting its mechanical properties and leaching resistance. In this paper, natural zeolite is selected as the backfill-modified material, and it is added to alkali-activated slag paste (AASP) and CUTB in cementitious material proportions of 4%, 8%, 12%, and 16% to prepare AASP mixtures and CUTB mixtures containing environmental… More >

Sumari Sumari^*, Mega Murti, Aman Santoso, Muhammad Roy Asrori

Journal of Renewable Materials, Vol.10, No.12, pp. 3659-3670, 2022, DOI:10.32604/jrm.2022.022995

Abstract Kapok seed oil is an environmentally friendly biodiesel feedstock. The problem of the best catalyst for transesterification of Kapok seed oil still continues today. The research developed a base-heterogeneous catalyst with the effect of ultrasonic waves during transesterification. So, the study aims: (1) to determine the type of natural zeolite used, (2) to determine the characteristics of the synthesized CaO:BaO/ANZ catalyst, and (3) to determine the effectiveness of the CaO:BaO/ANZ catalyst in the biodiesel production process through sono-transesterification of kapok seed oil. The research stages consisted of: (1) activation of natural zeolite and its characterization, (2) preparation of CaO:BaO/ANZ catalyst,… More > Graphic Abstract

Aman Santoso^1,*, Amirotus Sholikhah¹, Sumari Sumari¹, Muhammad Roy Asrori¹, Anugrah Ricky Wijaya¹, Rini Retnosari^1,2, Ihsan Budi Rachman^1,3

Journal of Renewable Materials, Vol.10, No.11, pp. 2781-2789, 2022, DOI:10.32604/jrm.2022.021401

Abstract Plastic is a basic need for humans, but it has also caused big problems for the environment. Then, the purpose of this study was to determine the effect of the type of plastic and the addition of a zeolite catalyst on the oil yield from the pyrolysis of plastic waste. The research stages were natural zeolite activation, pyrolysis reactor settings, pyrolysis of plastic waste (PP and LDPE types), and characterization. The results showed that the used natural zeolite had a mordenite phase and activated natural zeolite had a higher Si/Al ratio than the inactivated one. The addition of a zeolite… More > Graphic Abstract

Sulardjaka Sulardjaka^1,*, Sri Nugroho¹, Norman Iskandar¹, Agus P. Adi¹, Deni F. Fitriyana²

FDMP-Fluid Dynamics & Materials Processing, Vol.17, No.2, pp. 385-395, 2021, DOI:10.32604/fdmp.2021.011784

Abstract Zeolite A has been successfully synthesized from geothermal waste with natrium aluminate and natrium silicate using conventional (C-H) and microwave heating (M-H) for the hydrothermal treatment. The products obtained for different aging times have been characterized using X-Ray Diffraction (XRD), Fourier transformation infrared spectroscopy (FTIR), and scanning electron microscopy (SEM). It is shown that with the M-H process, zeolite can be formed at relatively low temperature (100°C) in a relatively short time (40 min). The crystallization of zeolite A has been found to be generally promoted by an increase of aging and synthesis time; however, it has also been observed… More >

Yang Ming^1,2,3, Ping Chen^1,2,3,*, Yuanhao Wang^1,2,3,*, Ling Li^1,2,3, Xuandong Chen^1,2,3, Pengliang Sun^1,2,3,4

Journal of Renewable Materials, Vol.8, No.12, pp. 1647-1655, 2020, DOI:10.32604/jrm.2020.011929

Abstract In order to increase use ratio of steel slag solid waste, the concrete containing steel slag powder and zeolite powder as admixtures was prepared by using the orthogonal test method. The effects of water-binder ratio, sand ratio, steel slag powder content and zeolite powder on working properties, mechanical strength and chloride ion permeability of the concrete was studied. It was found that the early strength of the concrete had a decrease with the mixing of steel slag and zeolite powders, but its later strength approached to pure concrete. Moreover, the physical filling and pozzolanic activity of the admixtures increased the… More >

Zhichao Han, Yaojun Zhang^*, Panyang He

Journal of Renewable Materials, Vol.8, No.4, pp. 405-416, 2020, DOI:10.32604/jrm.2020.09351

Abstract In this study, a magnetic P zeolite was directly synthesized by utilization of industrial solid wastes of zinc slag (ZS) and circulating fluidized bed fly ash (CFBFA) via one-step hydrothermal method. The effects of different CFBFA/ZS ratios and hydrothermal times on the as-synthesized zeolite were investigated. The X-ray diffraction (XRD) and vibrating sample magnetometer (VSM) results indicated that the magnetic P zeolite possessed well-defined crystals and superparamagnetism. The as-prepared zeolite was employed as a Fenton-like solid catalyst for degradation of direct green B dye wastewater. It was discovered that the magnetic P zeolite took the advantage of rapid separation and… More >

Wenjie Dong, Chenlu Wang, Minyan Gu, Long Yang, Zheng Shen^*, Yalei Zhang^*

Journal of Renewable Materials, Vol.5, Suppl.1, pp. 22-30, 2017, DOI:10.7569/JRM.2017.634126

Abstract Lactic acid can not only be used to produce multiple chemicals, but can also be the building block for biodegradable and biocompatible polylactic acid identified as a renewable resource. As a by-product in biodiesel production, the glycerol yield increases with a rapid expansion of biodiesel. However, in the chemical and environmental fields it is still a great challenge to produce lactic acid or methyl lactate from glycerol. Herein, Sn-Beta zeolite was prepared through solid-state ion exchange (Sn-Beta SSIE) and was tested for base-free one-pot catalytic selective oxidation of glycerol into methyl lactate in methanol. The results showed that a maximum… More >