Oliver K. Johnson¹, Calvin J. Gardner¹, David T. Fullwood¹, Brent L.Adams¹, Nathan Hansen², George Hansen²

CMC-Computers, Materials & Continua, Vol.15, No.2, pp. 87-112, 2010, DOI:10.3970/cmc.2010.015.087

Abstract A novel nickel nanostrand-silicone composite material at an optimized 15 vol% filler concentration demonstrates a dramatic piezoresistive effect with a negative gauge factor (ratio of percent change in resistivity to strain). The composite volume resistivity decreases in excess of three orders of magnitude at a 60% strain. The piezoresistivity does decrease slightly as a function of cycles, but not significantly as a function of time. The material's resistivity is also temperature dependent, once again with a negative dependence.
The evidence indicates that nickel strands are physically separated by matrix material even at high volume fractions, and points to a charge… More >

Silieti, M.¹, Divo, E.², Kassab, A.J.¹

CMC-Computers, Materials & Continua, Vol.12, No.2, pp. 121-144, 2009, DOI:10.3970/cmc.2009.012.121

Abstract A hybrid singularity superposition/boundary element-based inverse problem method for the reconstruction of multi-dimensional heat flux distributions is developed. Cauchy conditions are imposed at exposed surfaces that are readily reached for measurements while convective boundary conditions are unknown at surfaces that are not amenable to measurements such as the walls of the cooling holes. The purpose of the inverse analysis is to determine the heat flux distribution along cooling hole surfaces. This is accomplished in an iterative process by distributing a set of singularities (sinks) inside the physical boundaries of the cooling hole (usually along cooling hole centerline) with a given… More >

Lingfei Gao¹, Xiaoping Zheng^1,2, Zhenhan Yao¹

CMC-Computers, Materials & Continua, Vol.3, No.1, pp. 25-36, 2006, DOI:10.3970/cmc.2007.003.025

Abstract A general numerical approach is developed to model the elastic behaviours and failure processes of heterogeneous materials. The heterogeneous material body is assumed composed of a large number of convex polygon lattices with different phases. These phases are locally isotropic and elastic-brittle with the different lattices displaying variable material parameters and a Weibull-type statistical distribution. When the effective strain exceeds a local fracture criterion, the full lattice exhibits failure uniformly, and this is modelled by assuming a very small Young modulus value. An auto-select loading method is employed to model the failure process. The proposed hybrid approach is applied to… More >