Sen Zhang¹, Jie Jiang^2,3,*, Yuedong Wang⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.5, pp. 1159-1172, 2023, DOI:10.32604/fdmp.2022.024070

Abstract To improve the application of discrete element models (DEM) to the design of agricultural crushers, in this study a new highly accurate model is elaborated. The model takes into account the fiber structure, porous nature of the material and the leaf sheath coating structure. Dedicated experimental tests are conducted to determine the required “intrinsic” and basic contact parameters of the considered banana straw materials. A large number of bonding parameters are examined in relation to the particle aggregation model in order to characterize different actual banana straws. Using the particle surface energy contact model, the viscosity characteristics of the crushed… More > Graphic Abstract

Marion Thébault¹, Larysa Kutuzova², Sandra Jury¹, Iris Eicher¹, Edith-Martha Zikulnig-Rusch¹, Andreas Kandelbauer^2,*

Journal of Renewable Materials, Vol.8, No.6, pp. 603-630, 2020, DOI:10.32604/jrm.2020.09616

Abstract Here, the effects of substituting portions of fossil-based phenol in phenol formaldehyde resin by renewable lignin from two different sources are investigated using a factorial screening experimental design. Among the resins consumed by the wood-based industry, phenolics are one of the most important types used for impregnation, coating or gluing purposes. They are prepared by condensing phenol with formaldehyde (PF). One major use of PF is as matrix polymer for decorative laminates in exterior cladding and wet-room applications. Important requirements for such PFs are favorable flow properties (low viscosity), rapid curing behavior (high reactivity) and sufficient self-adhesion capacity (high residual… More >

J. Mohan¹, D. Carolan¹, N. Murphy¹, A. Ivankovic¹, D. Dowling¹

Structural Durability & Health Monitoring, Vol.3, No.2, pp. 81-86, 2007, DOI:10.3970/sdhm.2007.003.081

Abstract The aim of this work is to investigate the influence of a variety of plasma treatments on the surface properties of an epoxy-based composite material and to establish a relationship between these properties and the subsequent mechanical behaviour of adhesively bonded joints. To this end, specimens were subjected to three different types of plasma treatment: two short treatments (2min) of He and He plus O₂, and one long treatment (15min) of He plus O₂. The variation in surface energy of the composite specimens was examined in each case over a period of up to 3 days using contact angle measurements.… More >