Wankui Ni¹, Jiaxin Zhong^1,2, Haiman Wang^1,*

Journal of Renewable Materials, Vol.11, No.4, pp. 1699-1814, 2023, DOI:10.32604/jrm.2022.023805

Abstract Fiber-reinforced soils have been of great interest to experimenters for building foundations’strength performance, time, and economy. This paper investigates the effects of water content and polypropylene fiber dosage and length on loess’s unconfined compressive strength (UCS) according to the central composite response surface design test procedure. The water content is 11%–25%, the mass ratio of fiber to soil is 0.1%–0.9%, and the fiber length ranges from 6–18 mm. The response surface method (RSM) developed full quadratic models of different variables with response values. After analysis of variance (ANOVA), the mathematical model developed in this study was statistically significant (p ≤… More > Graphic Abstract

Hongfei Yue¹, Aiguo Fang², Sudong Hua^1,*, Zenghuan Gu³, Yu Jia¹, Cheng Yang⁴

Journal of Renewable Materials, Vol.10, No.8, pp. 2247-2261, 2022, DOI:10.32604/jrm.2022.018901

Abstract A phosphogypsum-based subgrade stabilizer (PBSS) was formulated using industrial by-product phosphogypsum (PG), mixed with slag and calcium-silicon-rich active material (GSR). The active powder (AP) was used to modify PBSS, and PBSS-AP was obtained. PBSS and PBSS-AP were each mixed with 10% silty soil, and cement and lime (CAL: 5% lime + 2% cement) were used as the traditional material for comparative experiments. Samples were cured under standard conditions, and tested for unconfined compressive strength (UCS), water stability, volume expansion, and leachate, to explore the stabilization effect of the three solidified materials on silty soil. The results showed that the comprehensive… More >

Zhongnan Gao^1,2,#, Xiumei Zhong^1,2,#, Qian Wang^1,2,*, Yongqi Su³, Jun Wang^1,2

Journal of Renewable Materials, Vol.10, No.4, pp. 1063-1080, 2022, DOI:10.32604/jrm.2022.017374

Abstract In the seasonal permafrost region with loess distribution, the influence of freeze-thaw cycles on the engineering performance of reinforced loess must be paid attention to. Many studies have shown that the use of fiber materials can improve the engineering performance of soil and its ability to resist freeze-thaw cycles. At the same time, as eco-environmental protection has become the focus, which has been paid more and more attention to, it has become a trend to find new environmentally friendly improved materials that can replace traditional chemical additives. The purpose of this paper uses new environmental-friendly improved materials to reinforce the… More >

Xiang Deng¹, Sudong Hua^1,*, Fan Xia², Yanfang Zhang², Dapeng Guo³, Xinxing Zhu³, Defei Zhu³

Journal of Renewable Materials, Vol.10, No.4, pp. 939-953, 2022, DOI:10.32604/jrm.2022.016874

Abstract Recycled powder (RP) is produced as a by-product during the process of recycling construction and demolition (C&D) wastes, presenting a low additional value. Using RP-based solidifying material can not only improve its utilization efficiency, but also reduce the cost of commercial solidifying materials. To date, this is the best solidifying material utilized to dispose the original waterworks sludge (OWS) with high moisture contents (60%), and the product could be used to fabricate non-fired bricks. This has become a new environment-friendly technology of “using waste to treat waste”. In this paper, the influence of different particle sizes and dosages of RP… More >

Zhiyu Weng¹, Lina Wang^1,2,*, Qiang Liu², Xuemin Pan¹, Yonghao Xu³, Jing Li¹

Journal of Renewable Materials, Vol.9, No.8, pp. 1503-1517, 2021, DOI:10.32604/jrm.2021.015003

Abstract To explore an environmentally friendly improvement measure for red clay, the function and mechanism of xanthan gum biopolymer and polypropylene fibers on the strength properties of red clay were investigated by unconfined compressive strength and scanning electron microscopy tests. The test results demonstrated that the contents and curing ages of xanthan gum had significant influences on the unconfined compressive strength of red clay. Compared with untreated soil, 1.5% xanthan gum content was the optimal ratio in which the strength increment was between 41.52 kPa and 64.73 kPa. On the other hand, the strength of xanthan gum-treated red clay increased, whereas… More >

Liang Jia, Chunxiang Li, Jian Guo^*

Journal of Renewable Materials, Vol.8, No.10, pp. 1357-1373, 2020, DOI:10.32604/jrm.2020.012136

Abstract Lime-fly ash stabilized loess has a poor early strength, which results in a later traffic opening time when it is used as road-base materials. Consideration of the significant early strength characteristics of sulphate aluminum cement (SAC), it is always added into the lime-fly ash mixtures to improve the early strength of stabilized loess. However, there is a scarcity of research on the mechanical behavior of lime-fly ash-SAC stabilized loess and there is a lack of quantitative evaluation of loess stabilized with binder materials. This research explored the effects of the amount of binder materials, curing time and porosity on the… More >