Lihui Ma^1,*, Zhuo Han¹, Wei Li¹, Guangfeng Qi¹, Ran Cheng², Yuanyuan Wang¹, Xiangran Mi³, Xiaohan Zhang¹, Yunfei Li¹

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.046405

Abstract When a gas-liquid two-phase flow (GLTPF) enters a parallel separator through a T-junction, it generally splits unevenly. This phenomenon can seriously affect the operation efficiency and safety of the equipment located downstream. In order to investigate these aspects and, more specifically, the so-called bias phenomenon (all gas and liquid flowing to one pipe, while the other pipe is a liquid column that fluctuates up and down), laboratory experiments were carried out by using a T-junction connected to two parallel vertical pipes. Moreover, a GLTPF prediction model based on the principle of minimum potential energy was introduced. The research results indicate… More >

Nannan Liu^*, Hengchen Qi, Hui Xu, Yanfeng He

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.048354

Abstract

Low salinity water containing sulfate ions can significantly alter the surface wettability of carbonate rocks. Nevertheless, the impact of sulfate concentration on the desorption of oil film on the surface of carbonate rock is still unknown. This study examines the variations in the wettability of the surface of carbonate rocks in solutions containing varying amounts of sodium sulfate and pure water. The problem is addressed in the framework of molecular dynamics simulation (Material Studio software) and experiments. The experiment’s findings demonstrate that sodium sulfate can increase the rate at which oil moisture is turned into water moisture. The final contact… More >

Dmitry Bratsun^*, Natalia Elenskaya, Ramil Siraev, Mikhail Tashkinov

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.047928

Abstract In this work, we numerically study the hydrodynamic permeability of new-generation artificial porous materials used as scaffolds for cell growth in a perfusion bioreactor. We consider two popular solid matrix designs based on triply periodic minimal surfaces, the Schwarz P (primitive) and D (diamond) surfaces, which enable the creation of materials with controlled porosity gradients. The latter property is crucial for regulating the shear stress field in the pores of the scaffold, which makes it possible to control the intensity of cell growth. The permeability of functionally graded materials is studied within the framework of both a microscopic approach based… More > Graphic Abstract

Lijun Mu, Xiaojia Xue, Jie Bai^*, Xiaoyan Li, Xueliang Han

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.049013

Abstract Following large-scale volume fracturing in shale oil reservoirs, well shut-in measures are generally employed. Laboratory tests and field trials have underscored the efficacy of fracturing fluid imbibition during the shut-in phase in augmenting shale oil productivity. Unlike conventional reservoirs, shale oil reservoirs exhibit characteristics such as low porosity, low permeability, and rich content of organic matter and clay minerals. Notably, the osmotic pressure effects occurring between high-salinity formation water and low-salinity fracturing fluids are significant. The current understanding of the mobilization patterns of crude oil in micro-pores during the imbibition process remains nebulous, and the mechanisms underpinning osmotic pressure effects… More >

Anastasia Bushueva, Olga Vlasova, Denis Polezhaev^*

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.048271

Abstract The steady flow in a Hele-Shaw cell filled with fluids with a high viscosity contrast in the presence of fluid oscillations is experimentally studied. The control of oscillatory dynamics of multiphase systems with interfaces is a challenging technological problem. We consider miscible (water and glycerol) and immiscible (water and high-viscosity silicone oil PMS-1000) fluids under subsonic oscillations perpendicular to the interface. Observations show that the interface shape depends on the amplitude and frequency of oscillations. The interface is undisturbed only in the absence of oscillations. Under small amplitudes, the interface between water and glycerol widens due to mixing. When the… More >

Mengdong An¹, Weiyuan Zhong¹, Wei Xu², Xiuli Wang^1,*

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.046604

Abstract The reactor coolant pump (RCP) rotor seizure accident is defined as a short-time seizure of the RCP rotor. This event typically leads to an abrupt flow decrease in the corresponding loop and an ensuing reactor and turbine trip. The significant reduction of core coolant flow while the reactor is being operated at full load can have very negative consequences. This potentially dangerous event is typically characterized by a complex transient behavior in terms of flow conditions and energy transformation, which need to be analyzed and understood. This study constructed transient flow and rotational speed mathematical models under various degrees of… More >

Shuilian Li¹, Fan Zeng¹, Xinli Wei^2,*

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.043614

Abstract In order to increase the efficiency of solar air collectors, a new variant with a protrusion is proposed in this study, and its performances are analyzed from two points of view, namely, in terms of optics and thermodynamics aspects. By comparing and analyzing the light paths of the protrusion and the dimple, it can be concluded that when sunlight shines on the dimple, it is reflected and absorbed multiple times, whereas for the sunlight shining on the protrusion, there is no secondary reflection or absorption of light. When the lighting area and the properties of the surfaces are the same,… More >

Andrei Vasiliev, Andrei Sukhanovskii^*, Elena Popova

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.048092

Abstract The formation of convective flows in a rotating cylindrical layer with an inclined bottom and free surface is studied. Convection is driven by localized cooling at the center of the upper free surface and by rim heating at the bottom near the sidewall. The horizontal temperature difference in a rotating layer leads to the formation of a convective flow with a complex structure. The mean meridional circulation, consisting of three cells, provides a strongly non-uniform differential rotation. As a result of the instability of the main cyclonic zonal flow, the train of baroclinic waves appears in the upper layer. The… More >

Victor Kozlov^1,*, Vladimir Saidakov¹, Nikolai Kozlov²

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.048068

Abstract The behavior of two immiscible low-viscosity liquids differing in density and viscosity in a vertical flat layer undergoing modulated rotation is experimentally studied. The layer has a circular axisymmetric boundary. In the absence of modulation of the rotation speed, the interphase boundary has the shape of a short axisymmetric cylinder. A new effect has been discovered, under the influence of rotation speed modulation, the interface takes on a new dynamic equilibrium state. A more viscous liquid covers the end boundaries of the layer in the form of thin films, which have the shape of round spots of almost constant radius;… More >

Huiyan Zhao¹, Xuezhong Chen¹, Zhijian Hu^2,*, Man Chen¹, Bo Xiong³, Jianying Yang¹

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2024.048840

Abstract Using the typical characteristics of multi-layered marine and continental transitional gas reservoirs as a basis, a model is developed to predict the related well production rate. This model relies on the fractal theory of tortuous capillary bundles and can take into account multiple gas flow mechanisms at the micrometer and nanometer scales, as well as the flow characteristics in different types of thin layers (tight sandstone gas, shale gas, and coalbed gas). Moreover, a source-sink function concept and a pressure drop superposition principle are utilized to introduce a coupled flow model in the reservoir. A semi-analytical solution for the production… More >