Ping Xu^1,*, Zhiwei Zhang¹, Zhenguo Hou^2,3, Mankui Zheng¹, Jin Tong¹

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.046183

Abstract In this paper, cement and dechlorinated Polyaluminum Chloride Residue (PACR) have been used to prepare a net slurry and mortar specimens. Two hydration activity indicators have been used to quantitatively analyze the dechlorinated PACR hydration activity. In particular, the effect of dechlorinated PACR content on the compressive strength of mortar has been assessed by means of compressive strength tests. Moreover, X-ray diffraction (XRD) and scanning electron microscopy (SEM) have been employed to observe the microstructure of the considered hydration products. The following results have been obtained. The 28th day activity index of the dechlorinated PACR is 75%, and therefore it… More >

Hui Tian¹, Dandan Zhao¹, Yannan Wu^2,3,*, Xingyu Yi¹, Jun Ma¹, Xiang Zhou⁴

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.044833

Abstract

The low porosity and low permeability of tight oil reservoirs call for improvements in the current technologies for oil recovery. Traditional chemical solutions with large molecular size cannot effectively flow through the nano-pores of the reservoir. In this study, the feasibility of Nanofluids has been investigated using a high pressure high temperature core-holder and nuclear magnetic resonance (NMR). The results of the experiments indicate that the specified Nanofluids can enhance the tight oil recovery significantly. The water and oil relative permeability curve shifts to the high water saturation side after Nanofluid flooding, thereby demonstrating an increase in the water wettability… More > Graphic Abstract

Yongguo Li^1,2, Caiyin Xu^1,2,*, Can Qin^1,2, Dingjian Zheng^1,2

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.044804

Abstract The so-called ORC (Organic Rankine Cycle) heat recovery technology has attracted much attention with regard to medium and low temperature waste heat recovery. In the present study, it is applied to a Tesla turbine. At the same time, the effects of the disc speed, diameter and inter-disc gap on the internal flow field and output power of the turbine are also investigated by means of CFD (Computational Fluid Dynamics) numerical simulation, by which the pressure, velocity, and output efficiency of the internal flow field are obtained under different internal and external conditions. The highest efficiency (66.4%) is obtained for a… More >

Xiufeng Zhu^1,2, Jingying Wang^1,*

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.045260

Abstract

SR-AOP (sulfate radical advanced oxidation process) is a novel water treatment method able to eliminate refractory organic pollutants. Hydrodynamic cavitation (HC) is a novel green technology, that can effectively produce strong oxidizing sulfate radicals. This paper presents a comprehensive review of the research advancements in these fields and a critical discussion of the principal factors influencing HC-enhanced SR-AOP and the mechanisms of synergistic degradation. Furthermore, some insights into the industrial application of HC/PS are also provided. Current research shows that this technology is feasible at the laboratory stage, but its application on larger scales requires further understanding and exploration. In… More > Graphic Abstract

Xiaochu Luo¹, Xiaobing Qi², Zhao Luo³, Zhonghao Li⁴, Ruiquan Liao¹, Xingkai Zhang^1,*

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.045737

Abstract Conventional conductivity methods for measuring the void fraction in gas-liquid multiphase systems are typically affected by accuracy problems due to the presence of fluid flow and salinity. This study presents a novel approach for determining the void fraction based on a reciprocating dynamic conductivity probe used to measure the liquid film thickness under forced annular-flow conditions. The measurement system comprises a cyclone, a conductivity probe, a probe reciprocating device, and a data acquisition and processing system. This method ensures that the flow pattern is adjusted to a forced annular flow, thereby minimizing the influence of complex and variable gas-liquid flow… More >

Fang Li^1,*, Juan Wu¹, Haiyong Yi², Lihong Wu², Lingyun Du¹, Yuan Zeng¹

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.043256

Abstract Methods for horizontal well spacing calculation in tight gas reservoirs are still adversely affected by the complexity of related control factors, such as strong reservoir heterogeneity and seepage mechanisms. In this study, the stress sensitivity and threshold pressure gradient of various types of reservoirs are quantitatively evaluated through reservoir seepage experiments. On the basis of these experiments, a numerical simulation model (based on the special seepage mechanism) and an inverse dynamic reserve algorithm (with different equivalent drainage areas) were developed. The well spacing ranges of Classes I, II, and III wells in the Q gas field are determined to be… More >

Jiaqiong Wang^1,2, Tao Yang¹, Chen Hu¹, Yu Zhang^3,*, Ling Zhou^1,2

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.045825

Abstract To investigate the influence of structural parameters on the performances and internal flow characteristics of partial flow pumps at a low specific speed of 10000 rpm, special attention was paid to the first and second stage impeller guide vanes. Moreover, the impeller blade outlet width, impeller inlet diameter, blade inclination angle, and number of blades were considered for orthogonal tests. Accordingly, nine groups of design solutions were formed, and then used as a basis for the execution of numerical simulations (CFD) aimed at obtaining the efficiency values and heads for each design solution group. The influence of impeller geometric parameters… More >

Jianchao Shi^1,2, Yanan Zhang³, Wantao Liu^1,2, Yuliang Su^3,*, Jian Shi^1,2

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.044500

Abstract Class III tight oil reservoirs have low porosity and permeability, which are often responsible for low production rates and limited recovery. Extensive repeated fracturing is a well-known technique to fix some of these issues. With such methods, existing fractures are refractured, and/or new fractures are created to facilitate communication with natural fractures. This study explored how different refracturing methods affect horizontal well fracture networks, with a special focus on morphology and related fluid flow changes. In particular, the study relied on the unconventional fracture model (UFM). The evolution of fracture morphology and flow field after the initial fracturing were analyzed… More >

Zhiyong Yang, Enjie Hu, Lei Xi, Zhi Chen^*, Feng Xiong, Chuanhai Zhan

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.044030

Abstract An experimental investigation into the thermal conductivity of CF-SiC two-phase composite asphalt concrete is presented. The main objective of this study was to verify the possibility of using SiC powder instead of mineral powder as the thermal conductive filler to prepare a new type of asphalt concrete and improve the efficiency of electrothermal snow and ice melting systems accordingly. The thermal conductivity of asphalt concrete prepared with different thermally conductive fillers was tested by a transient plane source method, and the related performances were measured. Then the temperature rise rate and surface temperature were studied through field heating tests. Finally,… More >

Xin Ai^1,2,*, Mian Chen¹

FDMP-Fluid Dynamics & Materials Processing, Vol., , DOI:10.32604/fdmp.2023.026819

Abstract

The efficient development and exploitation of shale oil depends on long-distance horizontal wells. As the degree of cleaning of the wellbore plays a key role in these processes, in this study, this problem is investigated experimentally by focusing on the dimensionless cuttings bed height. A method is proposed to calculate the horizontal-well hydraulic extension taking into account the influence of the wellbore cleaning degree on the wellbore pressure distribution and assess the effect of a variety of factors such as the bottom hole pressure, the circulating pressure drop, the drilling pump performance and the formation properties. The analysis shows that… More >