Mamdouh El Haj Assad¹, Ibrahim Mahariq^2,*, Zaher Al Barakeh², Mahmoud Khasawneh², Mohammad Ali Amooie³

CMC-Computers, Materials & Continua, Vol.69, No.3, pp. 3767-3781, 2021, DOI:10.32604/cmc.2021.018872

Abstract CO₂ emission is considerably dependent on energy consumption and on share of energy sources as well as on the extent of economic activities. Consequently, these factors must be considered for CO₂ emission prediction for seven middle eastern countries including Iran, Kuwait, United Arab Emirates, Turkey, Saudi Arabia, Iraq and Qatar. In order to propose a predictive model, a Multilayer Perceptron Artificial Neural Network (MLP ANN) is applied. Three transfer functions including logsig, tansig and radial basis functions are utilized in the hidden layer of the network. Moreover, various numbers of neurons are applied in the structure of the models. It… More >

Abdulkhaliq Alshoaibi^*

Phyton-International Journal of Experimental Botany, Vol.91, No.1, pp. 45-55, 2022, DOI:10.32604/phyton.2022.016434

Abstract Pearl millet (Pennisetum spicatum (L.) Körn.) and maize (Zea mays L.) are C₄ grass species grown for feeding humans and animals in Almadinah Almunawwarah, which is in the western part of Saudi Arabia. During the winter, the mean temperature, which drops to 14°C, represents a major problem for the growth of these species in this region. Therefore, the objectives of this research were to investigate the growth response and the photosynthetic performance of P. spicatum and Z. mays under a low temperature stress. The treatments involved daytime and nighttime temperatures of 14/12°C (low temperature) and 24/22°C (optimum temperature). The results… More >

Christian Brütting¹, Julia Dreier², Christian Bonten², Volker Altstädt¹, Holger Ruckdäschel^1,*

Journal of Renewable Materials, Vol.9, No.11, pp. 1859-1868, 2021, DOI:10.32604/jrm.2021.016244

Abstract Polylactide (PLA) bead foams show a high potential regarding their applicability in packaging or consumer products. Concerning the comparable properties of PLA to Polystyrene (PS) and the good CO₂ footprint it represents a potential alternative to petroleum-based polymer foams. However, foaming of PLA is challenging, due to its low melt strength, therefore chemical modifiers are often used. Concerning the bead foam technology regarding PLA, the available literature is limited so far. Within this study, the bead foaming behavior of neat and modified amorphous PLA was investigated. The material was modified by talc and an epoxy-based chain extender. These compounds have… More >

R. Ariza-Flores¹, D. Trujillo-García², M. A. Otero-Sánchez², E. Canales Sosa², C. H. Avendaño-Arrazate^3,*, L. A. Gálvez-Marroquín⁴, P. Cadena Iñiguez⁵

Phyton-International Journal of Experimental Botany, Vol.90, No.3, pp. 933-947, 2021, DOI:10.32604/phyton.2021.013227

Abstract The aim of this study was to evaluate some physiological aspects of papaya crops in semi conventional and organic production systems. The following factors assessed in this experiment were: 1. Production systems (organic and semi conventional); 2. Genotypes (Maradol and Maradona F1), and 3. Cover crop plants (Canavalia, vegetative cover and no cover). Twelve treatments were obtained -product of factors’ combination- and distributed under a threerepetition experimental design of subdivided parcels. The factors examined in this study, that changed the CO₂ assimilation rate, were production system and genotype. It was determined that the greatest gas exchange in papaya crops happened… More >

Abdulkhaliq Alshoaibi^*

Phyton-International Journal of Experimental Botany, Vol.90, No.3, pp. 731-745, 2021, DOI:10.32604/phyton.2021.015476

Abstract Seeds of three Saudi pearl millet cultivars (Pennisetum spicatum) from three regions (Madinah, Khulais and Jaizan) were inoculated with arbuscular mycorrhizal fungus Glomus mosseae obtained from the Agriculture Research Center of Giza, Egypt to enhance their salt tolerance. Five different NaCl concentrations (0, 30, 60, 90, and 120 mM) were used for treating cultivars with and without mycorrhiza. Growth rates, chlorophyll content, chlorophyll fluorescence (Fv/Fm), proline content and gas exchange were measured to determine the effect of salinity on these cultivars. The results indicated that compared to cultivars without mycorrhiza, all cultivars with mycorrhiza had enhanced growth and physiological parameters… More >

Mamdouh El Haj Assad^1,*, Ali Khosravi², Mohammad AlShabi³, Bassam Khuwaileh³, Abdul-Kadir Hamid⁴

Energy Engineering, Vol.118, No.3, pp. 447-458, 2021, DOI:10.32604/EE.2021.014590

Abstract In this work, a life cycle analysis is accomplished for flat plate solar collectors. The purpose of this investigation is to predict the energy consumption during the manufacturing processes that results in carbon dioxide emissions. Energy consumption and system efficiency enhancement will be studied and predicted. CES EduPack software is used to perform the analysis of the currently commercial system, and the suggested changes are implemented to increase the efficiency and make the comparison. Even though cost analysis is done, the priority of selection is given to the most energy conserving and environmentally friendly alternative. However, if the compared alternatives… More >

Jinguang Yang, Feng Zhao, Min Zhang^*, Yan Liu, Xiaofang Wang

CMES-Computer Modeling in Engineering & Sciences, Vol.126, No.3, pp. 935-953, 2021, DOI:10.32604/cmes.2021.014176

Abstract For a radial inflow turbine (RIT), leakage flow in impeller backface cavity has critical impacts on aerodynamic performance of the RIT and axial force acting on the RIT impeller. In order to control this leakage flow, different types of labyrinth seals are numerically studied in this paper based on a supercritical carbon dioxide (S-CO₂) RIT. The effects of seal clearance and cavity outlet pressure are first analyzed, and the impacts of seal design parameters, including height, number and shape of seal teeth, are evaluated. Results indicate that adding labyrinth seal can improve cavity pressure and hence adequately inhibits leakage flow.… More >

Ting Jiang^1,3, Chunmei Yang^1,2,*, Yueqiang Yu³, Bakary S. Doumbia^1,2, Jiuqing Liu^1,*, Yan Ma^1,2

Journal of Renewable Materials, Vol.9, No.1, pp. 119-128, 2021, DOI:10.32604/jrm.2021.011490

Abstract

As a natural and environmentally friendly renewable material, Northeast China ash wood (NCAW) (Fraxinus mandshurica Rupr.) was cut by water-jet assisted CO₂ laser (WACL), the surface quality was evaluated by surface roughness of cut section. The surface roughness was measured by three-dimensional (3D) profilometry. Furthermore, the micromorphology of machined surface was observed by scanning electronic microscopy (SEM). Carbon content changes of machined surface were measured by energy dispersive spectrometer (EDS). A relationship between surface roughness and cutting parameters was established using response surface methodology (RSM). It is concluded that the cutting speed, laser power and water pressure played an important… More >

Hua Tian¹, Ke Kang¹, Lingfeng Shi^2,*, Rui Sun¹

Energy Engineering, Vol.117, No.5, pp. 267-277, 2020, DOI:10.32604/EE.2020.011440

Abstract The anti-sublimation CO₂ capture technology has attracted the attention of researchers due to its advantages such as no pollution and high product purity. The anti-sublimation process is the core link of this technology, so the study of this process is of great significance to the low-temperature capture system. At present, there are few research works on the CO₂ anti-sublimation process. In order to study the influence of key parameters on the capture performance during CO₂ anti-sublimation, a one-dimensional steady-state of CO₂ anti-sublimation process in a double pipe heat exchanger was established based on the mixture gas of N₂ and CO₂.… More >

Ganggang Hou¹, Tongjing Liu^{1, *}, Xinyu Yuan¹, Jirui Hou¹, Pengxiang Diwu²

CMES-Computer Modeling in Engineering & Sciences, Vol.123, No.3, pp. 1223-1246, 2020, DOI:10.32604/cmes.2020.09008

Abstract CO₂ flooding has been widely studied and applied to improve oil recovery from low permeability reservoirs. Both the experimental results and the oilfield production data indicate that produced oil components (POC) will vary during CO₂ flooding in low permeability reservoirs. However, the present researches fail to explain the variation reason and rule. In this study, the physical model of the POC variation during CO₂ flooding in low permeability reservoir was established, and the variation reason and rule were defined. To verify the correctness of the physical model, the interaction rule of the oil-CO₂ system was studied by related experiments. The… More >