Marcello Lappa^{1, 2}

FDMP-Fluid Dynamics & Materials Processing, Vol.1, No.1, pp. 1-20, 2005, DOI:10.3970/fdmp.2005.001.001

Abstract Possible natural transport mechanisms in cubical and shallow cavities with different heating conditions (from below or from the side) are investigated by means of numerical solution of the non-linear model equations and multiprocessor computations. Attention is focused on a variety of three-dimensional steady effects that can arise in such configurations in the case of low-Pr liquids (silicon melt) even for relatively small values of the temperature gradient due to localized boundary effects and/or true instabilities of the flow. Such aspects are still poorly known or completely ignored owing to the fact that most of the existing experiments focused on the… More >

Haolong Chen^1,2, Bo Yu¹, Huanlin Zhou^1*, Zeng Meng¹

CMC-Computers, Materials & Continua, Vol.53, No.4, pp. 271-290, 2017, DOI:10.3970/cmc.2017.053.271

Abstract The cuckoo search algorithm (CS) is improved by using the conjugate gradient method(CGM), and the CS-CGM is proposed. The unknown inner boundary shapes are generated randomly and evolved by Lévy flights and elimination mechanism in the CS and CS-CGM. The CS, CGM and CS-CGM are examined for the prediction of a pipe’s inner surface. The direct problem is two-dimensional transient heat conduction in functionally graded materials (FGMs). Firstly, the radial integration boundary element method (RIBEM) is applied to solve the direct problem. Then the three methods are compared to identify the pipe’s inner surfacewith the information of measured temperatures. Finally,… More >

Yanbin Wang^1,2, Deli Gao¹, Jun Fang¹

CMC-Computers, Materials & Continua, Vol.48, No.1, pp. 25-42, 2015, DOI:10.3970/cmc.2015.048.025

Abstract In this paper, the buckling and collapse analysis of offshore pipeline under combined tension, bending moment, and external pressure has been presented with theoretical analysis and FE (finite element) simulation method respectively. Based on the model initially proposed by Kyriakides, a 2-D theoretical model has been further developed. To verify the correctness and accuracy of the model proposed in this paper, numerical simulations have been conducted with 3-D FE model using ABAQUS software. Good consistency has been shown between the calculation results which validate the availability of the theoretical analysis. On this basis, the influence of load path, material properties,… More >