Rami K Korhonen^∗,†, Sang-Kuy Han^‡, Walter Herzog^‡

Molecular & Cellular Biomechanics, Vol.7, No.3, pp. 125-134, 2010, DOI:10.3970/mcb.2010.007.125

Abstract Changes in the osmotic environment cause changes in volume of isolated cells and cells in tissue explants, and the osmotic environment becomes hypotonic in cartilage diseases such as osteoarthritis (OA). However, it is not known how cells respond to a hypotonic osmotic challenge when situated in the fully intact articular cartilage.
A confocal laser scanning microscope was used to image chondrocytes of intact rabbit patellae in an isotonic (300 mOsm) and hypotonic (172 mOsm) immersion medium. Cell volumes were calculated before and 5, 15, 60, 120 and 240 minutes after the change in saline concentration. Local tissue strains and swelling… More >

Dilson E. Rassier^*

Molecular & Cellular Biomechanics, Vol.6, No.4, pp. 229-242, 2009, DOI:10.3970/mcb.2009.006.229

Abstract When activated skeletal muscles are stretched at slow velocities, force increases in two phases: (i) a fast increase, and (ii) a slow increase. The transition between these phases is commonly associated with the mechanical detachment of cross-bridges from actin. This phenomenon is referred to asforce enhancement during stretch. After the stretch, force decreases and reaches steady-state at levels that are higher than the force produced at the corresponding length during purely isometric contractions. This phenomenon is referred to asresidual force enhancement.The mechanisms behind the increase in force during and after stretch are still a matter of debate, and have physiological… More >

Xueying Huang^*, Chun Yang^†, Chun Yuan^‡, Fei Liu^‡, Gador Canton^‡, Jie Zheng^§, Pamela K. Woodard^§, Gregorio A. Sicard^¶, Dalin Tang^||

Molecular & Cellular Biomechanics, Vol.6, No.2, pp. 121-134, 2009, DOI:10.3970/mcb.2009.006.121

Abstract Image-based computational models for atherosclerotic plaques have been developed to perform mechanical analysis to quantify critical flow and stress/strain conditions related to plaque rupture which often leads directly to heart attack or stroke. An important modeling issue is how to determine zero stress state from in vivo plaque geometries. This paper presents a method to quantify human carotid artery axial and inner circumferential shrinkages by using patient-specific ex vivo and in vivo MRI images. A shrink-stretch process based on patient-specific in vivo plaque morphology and shrinkage data was introduced to shrink the in vivo geometry first to find the zero-stress… More >

Chun Yang^∗,†, Dalin Tang^∗,‡, Shunichi Kobayashi^§, Jie Zheng^¶, Pamela K. Woodard^§, Zhongzhao Teng^*, Richard Bach^||, David N. Ku^∗∗

Molecular & Cellular Biomechanics, Vol.5, No.4, pp. 259-274, 2008, DOI:10.3970/mcb.2008.005.259

Abstract Many acute cardiovascular syndromes such as heart attack and stroke are caused by atherosclerotic plaque ruptures which often happen without warning. MRI-based models with fluid-structure interactions (FSI) have been introduced to perform flow and stress/strain analysis for atherosclerotic plaques and identify possible mechanical and morphological indices for accurate plaque vulnerability assessment. In this paper, cyclic bending was added to 3D FSI coronary plaque models for more accurate mechanical predictions. Curvature variation was prescribed using the data of a human left anterior descending (LAD) coronary artery. Five computational models were constructed based on ex vivo MRI human coronary plaque data to… More >

Vedula S.R.K.^*, Lim T.S.^†, Hunziker W.^‡, Lim C.T.^§

Molecular & Cellular Biomechanics, Vol.5, No.3, pp. 169-182, 2008, DOI:10.3970/mcb.2008.005.169

Abstract Intercellular adhesion molecules play an important role in regulating several cellular processes such as a proliferation, migration and differentiation. They also play an important role in regulating solute diffusion across monolayers of cells. The adhesion characteristics of several intercellular adhesion molecules have been studied using various biochemical assays. However, the advent of single molecule force spectroscopy as a powerful tool to analyze the kinetics and strength of protein interactions has provided us with an opportunity to investigate these interactions at the level of a single molecule. The study of interactions involving intercellular adhesion molecules has gained importance because of the… More >

Gretchen J. McAuliffe^*, Jung Yun Chang^†, Raymond P. Glahn^‡, Michael L. Shuler^§

Molecular & Cellular Biomechanics, Vol.5, No.2, pp. 119-132, 2008, DOI:10.3970/mcb.2008.005.119

Abstract Microscale cell culture analogs (μCCAs) are used to study the metabolism and toxicity of a chemical or drug. These in vitro devices are physical replicas of physiologically based pharmacokinetic models that combine microfabrication and cell culture. The goal of this project is to add an independent GI tract μCCA to a multi-chamber chip μCCA representing the primary circulation. The GI tract μCCA consists of two chambers separated by a microporous membrane on which intestinal epithelial cells are cultured. Compounds of interest are pumped through the top chamber, allowing drug to be absorbed through the epithelial layer and circulated into the… More >

Jin Suo^*, John N. Oshinski^∗,†, D.P. Giddens^∗,‡

Molecular & Cellular Biomechanics, Vol.5, No.1, pp. 9-18, 2008, DOI:10.3970/mcb.2008.005.009

Abstract Atherosclerotic plaques in human coronary arteries are focal manifestations of systemic disease, and biomechanical factors have been hypothesized to contribute to plaque genesis and localization. We developed a computational fluid dynamics (CFD) model of the ascending aorta and proximal sections of the right and left coronary arteries of a normal human subject using computed tomography (CT) and magnetic resonance imaging (MRI) and determined the pulsatile flow field. Results demonstrate that flow patterns in the ascending aorta contribute to a pro-atherosclerotic flow environment, specifically through localization of low and oscillatory wall shear stress in the neighborhood of coronary orifices. Furthermore, these… More >

S.R.K. Vedula¹, T.S. Lim², P.J. Kausalya³, W. Hunziker³, G. Rajagopal², C.T. Lim^1,4

Molecular & Cellular Biomechanics, Vol.2, No.3, pp. 105-124, 2005, DOI:10.3970/mcb.2005.002.105

Abstract Cell-cell adhesion is an extremely important phenomenon as it influences several biologically important processes such as inflammation, cell migration, proliferation, differentiation and even cancer metastasis. Furthermore, proteins involved in cell-cell adhesion are also important from the perspective of facilitating better drug delivery across epithelia. The adhesion forces imparted by proteins involved in cell-cell adhesion have been the focus of research for sometime. However, with the advent of nanotechnological techniques such as the atomic force microscopy (AFM), we can now quantitatively probe these adhesion forces not only at the cellular but also molecular level. Here, we review the structure and function… More >

Girish K.¹, Hema Singh²

CMC-Computers, Materials & Continua, Vol.52, No.3, pp. 197-212, 2016, DOI:10.3970/cmc.2016.052.196

Abstract Aerospace structures can be approximately modeled as a combination of canonical structures such as cylinder, cone and ellipsoid. Thus the RCS estimation of such canonical structures is of prime interest. Furthermore metamaterials possess peculiar electromagnetic properties which can be useful in modifying the RCS of structures. This paper is aimed at calculating the RCS of an infinitely long PEC circular cylinder coated with one or two layers of metamaterial. The incident and scattered fields of coated cylinder are expressed in terms of series summation of Bessel and Hankel functions. The unknown coefficients of summation are obtained by applying appropriate boundary… More >

Taohua Chen¹, Yueyun Chen^1,*, Rongling Jian¹, Zushen Liu², Alan Yang³

CMC-Computers, Materials & Continua, Vol.60, No.1, pp. 335-349, 2019, DOI:10.32604/cmc.2019.07073

Abstract A novel broadband microstrip antenna under operation of TM_1/2,0, TM₁₀ and TM₁₂ modes through a shorting wall and slots is proposed in this paper. Initially, an inverted U-shaped slot is adopted around the feeding point, which achieves a good impedance matching on TM₁₀ mode and separates the patch into two parts. Additionally, a shorting wall is added underneath the edge of smaller patch to excite another one-quarter resonant mode, i.e., TM_1/2,0 mode of smaller patch close to TM₁₀ mode to expand the impedance bandwidth. Further, the antenna width is enlarged and two symmetrical vertical rectangular slots are cut on the… More >