Yunyun Song¹, Xu Zhang¹, Jialei Yang¹, Zhongqiang Zhang^1,*, Guanggui Cheng¹

The International Conference on Computational & Experimental Engineering and Sciences, Vol.25, No.2, pp. 1-1, 2023, DOI:10.32604/icces.2023.09916

Abstract Although floating oil with large particle sizes can easily be separated from water by membrane separation methods, tiny oil droplets with tremendously small volume force and density gradient at oil-water interfaces within water lead to barriers of oil-water separation. Consequently, tiny oil droplets remain in the water, resulting in energy waste, environmental pollution and biological health hazard. Traditional super-wetting membranes with extremely small pore sizes were easily blocked during the oil-water separation process. Inspired by the cactus and rice leaf, we developed a superhydrophobic-superoleophilic surface with conical micro-arrays to realize ultrafast adsorption of tiny oil… More >

Dalia S. Makki¹, Hasan Sh. Majdi², Amer A. Abdulrahman¹, Abbas J. Sultan^1,3,*, Zahraa W. Hasan¹, Laith S. Sabri^1,3, Bashar J. Kadhim¹, Muthanna H. Al-Dahhan³

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.10, pp. 2613-2637, 2023, DOI:10.32604/fdmp.2023.028081 - 25 June 2023

Abstract Bubble and slurry bubble column reactors (BCRs/SBCRs) are used for various chemical, biochemical, and petrochemical applications. They have several operational and maintenance advantages, including excellent heat and mass transfer rates, simplicity, and low operating and maintenance cost. Typically, a catalyst is present in addition to biochemical processes where microorganisms are used to produce industrially valuable bio-products. Since most applications involve complicated gas-liquid, gas-liquid-solid, and exothermic processes, the BCR/SBCR must be equipped with heat-exchanging tubes to dissipate heat and control the reactor’s overall performance. In this review, past and very recent experimental and numerical investigations on More >

Liang Yang^*, Tianle Xi, Zhixing Wang

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.6, pp. 1585-1608, 2023, DOI:10.32604/fdmp.2023.024987 - 30 January 2023

Abstract The VOF method is used to simulate the dynamics of a droplet interacting with a structure consisting of an array of microcolumns mounted on a flat surface. Such a specific configuration is intended to mimic the typical properties of lotus leaves, which typically display regularly arranged micron-scale papillary structures. After setting the initial velocity of the simulated droplet on the basis of practical considerations, an analysis is conducted about the effect of the characteristic size of the microstructure on the apparent contact angle. The pressure variation in the microstructure caves is also examined. The simulation More >

Xiaofeng Zhang¹, Lisheng Luo^2,*, Youfu Sun¹, Xinyue Cui², Yongqiang Zhang²

Journal of Renewable Materials, Vol.11, No.4, pp. 2033-2054, 2023, DOI:10.32604/jrm.2022.023651 - 01 December 2022

Abstract Considering the glulam beam-column connection form and the number of bolts, monotonic loading test and finite element analysis was carried out on 9 connection specimens in 3 groups to study the rotational performance and failure mode of the connection. The test results revealed that compared with U-shaped connectors, T-shaped connectors can effectively improve the ductility of connections, and the increase in the number of bolts can reduce the initial stiffness and ductility of connections. By theoretical analysis, formulas for calculating the initial stiffness and ultimate moment of connections were deduced. Subsequently, the moment-rotation theoretical model More > Graphic Abstract

Yingyao Cheng^1,2, Xudong Chen³, Huaming An^1,*, Huimin Wang^2,4, Kai Tao^2,5

Journal of Renewable Materials, Vol.11, No.2, pp. 825-836, 2023, DOI:10.32604/jrm.2022.022599 - 22 September 2022

Abstract Eucalyptus nitens (E. nitens) has been much used for producing paper but also shows promise for structural applications. In this study, static compressive tests were undertaken to examine its suitability to be used in an innovative composite column. The composite column was comprised of a rectangular steel tube with E. nitens timber infill. The nonlinear compressive behaviour of the composite column filled with E. nitens wood for both dry and wet conditions was examined. The same tests on rectangular steel tubes and bare dry and wet E. nitens samples were also undertaken as a comparison. For samples with different conditions, More > Graphic Abstract

Xiaowu Cheng, Xinyan Tao, Lu Wang^*

Journal of Renewable Materials, Vol.11, No.2, pp. 905-920, 2023, DOI:10.32604/jrm.2022.023196 - 22 September 2022

Abstract This paper presents experimental and numerical investigations on progressive collapse behavior of a two-story glulam frame when the side column is exposed to ISO834 standard fire. The collapse mechanism initiated by fire is identified. The experimental results show that the progressive collapse of a glulam frame could be described for three stages, namely bending effect stage, catenary effect stage and failure stage, respectively. These stages are discussed in detail to understand the structural behavior before and during collapse. It is demonstrated that the entire frame slopes towards the side of the heated column, and the More >

Kesheng Lin^1,2, Jiawen Zhou^1,2, Lijuan Han^1,2, Ning Li^1,2,*

Phyton-International Journal of Experimental Botany, Vol.92, No.1, pp. 285-296, 2023, DOI:10.32604/phyton.2022.023219 - 06 September 2022

Abstract As a traditional herbal medicine, the major alkaloids in Uncaria rhynchophylla have been proven to have blood pressure-lowering and sedative effects. It is essential to develop an effective method for the determination of the major alkaloids in U. rhynchophylla. In this research, a rapid quantitative analysis involving multi-components analysis by a single marker strategy coupled with core-shell column HPLC was adopted to analyse four alkaloids (corynoxeine, isocorynoxeine, isorhynchophylline, rhynchophylline) in U. rhynchophylla. Isorhynchophylline was selected as the internal reference substance, the content of which was determined by the traditional external standard method. Relative correction factors (RCF) between isorhynchophylline More >

Mahdi Hosseini^1,2,*, Bingyu Jian^1,2, Haitao Li^1,2,*, Dong Yang^1,2, Ziang Wang^1,2, Zixian Feng^1,2, Feng Shen³, Jian Zhang⁴, Rodolfo Lorenzo⁵, Ileana Corbi⁶, Ottavia Corbi⁶

Journal of Renewable Materials, Vol.10, No.12, pp. 3243-3262, 2022, DOI:10.32604/jrm.2022.022171 - 14 July 2022

Abstract The use of fibre-reinforced polymer (FRP) to confine concrete columns improves the strength and ductility of the columns by reducing passive lateral confinement pressure. Many numerical and analytical formulations have been proposed in the literature to describe the compressive behaviour of FRP confined concrete under both monotonic and cyclic loads. However, the effect of a stress/strain level in the columns has not been well defined because of the lack of well-defined strategies of modelling and oversimplification of the model. This paper reviews the existing FRP combinations and the available numerical and analytical methods to determine More >

Norwini Zaidi¹, Iskandar Ishak^2,*, Fatimah Sidi², Lilly Suriani Affendey²

Computer Systems Science and Engineering, Vol.43, No.3, pp. 1175-1188, 2022, DOI:10.32604/csse.2022.021969 - 09 May 2022

Abstract Data transformation is the core process in migrating database from relational database to NoSQL database such as column-oriented database. However, there is no standard guideline for data transformation from relational database to NoSQL database. A number of schema transformation techniques have been proposed to improve data transformation process and resulted better query processing time when compared to the relational database query processing time. However, these approaches produced redundant tables in the resulted schema that in turn consume large unnecessary storage size and produce high query processing time due to the generated schema with redundant column… More >

R. Amirthavalli^1,*, S. Thanga Ramya², N. R. Shanker³

Computer Systems Science and Engineering, Vol.41, No.2, pp. 829-847, 2022, DOI:10.32604/csse.2022.020307 - 25 October 2021

Abstract In Underwater Acoustic Sensor Network (UASN), routing and propagation delay is affected in each node by various water column environmental factors such as temperature, salinity, depth, gases, divergent and rotational wind. High sound velocity increases the transmission rate of the packets and the high dissolved gases in the water increases the sound velocity. High dissolved gases and sound velocity environment in the water column provides high transmission rates among UASN nodes. In this paper, the Modified Mackenzie Sound equation calculates the sound velocity in each node for energy-efficient routing. Golden Ratio Optimization Method (GROM) and… More >