J. Dujc^1,3, B. Brank^1,2, A. Ibrahimbegovic³

CMES-Computer Modeling in Engineering & Sciences, Vol.69, No.3, pp. 223-260, 2010, DOI:10.3970/cmes.2010.069.223

Abstract We present a quadrilateral finite element with discontinuous displacement fields that can be used to model material failure in 2d brittle and ductile solids. The element provides mesh-objective results. The element's kinematics can represent linear displacement jumps along the discontinuity line in both normal and tangential directions to the line. The cohesive law in the discontinuity line is based on rigid-plasticity model with softening. The material of the bulk of the element is described by hardening plasticity model. Static condensation of the jump-in-displacements kinematic parameters is made, which provides standard form of the element stiffness matrix. However, in order to… More >

A. Ramachandra Murthy¹ , G.S. Palani¹ , Nagesh R. Iyer¹ , Smitha Gopinath¹ and V. Ramesh Kumar¹

CMES-Computer Modeling in Engineering & Sciences, Vol.86, No.5, pp. 409-434, 2012, DOI:10.3970/cmes.2012.086.409

Abstract This paper presents the details of projectile impact on reinforced concrete structural components. Nonlinear explicit transient dynamic analysis has been carried out by using finite element method. Concrete damage model has been employed to represent the nonlinear behaviour of target under impact load. Various methods of modeling of reinforcement have been explained. A brief note on equation of state for concrete, contact algorithms and nonlinear explicit transient dynamic analysis has been given. Numerical studies have been carried out to compute the response of concrete target due to impact of projectile. The computed penetration depth have been compared with the corresponding… More >

A. Ataş¹, C. Soutis²

CMC-Computers, Materials & Continua, Vol.34, No.3, pp. 199-226, 2013, DOI:10.3970/cmc.2013.034.199

Abstract A strength prediction method is presented for double-lap single fastener bolted joints of cross-ply carbon fibre reinforced plastic (CFRP) composite laminates using cohesive zone elements (CZEs). Three-dimensional finite element models were developed and CZEs were inserted into subcritical damage planes identified from X-ray radiographs. The method makes a compromise between the experimental correlation factors (dependant on lay-up, stacking sequence and joint geometry) and three material properties (fracture energy, interlaminar strength and nonlinear shear stress-strain response). Strength of the joints was determined from the predicted load-displacement curves considering sub-laminate and plylevel scaling effects. The predictions are in a reasonable agreement with… More >