Yu. Gaponenko¹, I. Ryzhkov², V. Shevtsova³

FDMP-Fluid Dynamics & Materials Processing, Vol.6, No.1, pp. 75-98, 2010, DOI:10.3970/fdmp.2010.006.075

Abstract Gas-liquid flows in annulus are analyzed for fluids in large range of viscosity ratios. The geometry corresponds to a liquid bridge co-axially placed into an outer cylinder with solid walls. The internal core consists of solid rods at the bottom and top, while the central part is a relatively short liquid zone filled with viscous liquid and kept in its position by surface tension. The gas enters into the annular duct and entrains initially quiescent liquid. The flow structures in the liquid and gas are obtained numerically for different shapes of solid rods. Solution for fully developed flow in annulus… More >

O.M.Lavrenteva, Yu. Holenbergand A.Nir¹

FDMP-Fluid Dynamics & Materials Processing, Vol.6, No.1, pp. 41-74, 2010, DOI:10.3970/fdmp.2010.006.041

Abstract A variety of exact analytical solutions describing natural and thermocapillary convection in a horizontal double layer system consisting of Newtonian and Herschel-Bulkley fluids subjected to longitudinal temperature and concentration gradients is constructed. The lower boundary of the system is a solid wall with no-slip, while the upper ones if either a solid wall or a free surface. It was demonstrated that, depending on the governing parameters of the system, viscoplastic layer is entirely yielded or unyielded, or it can be yielded partially, exhibiting up to 5 flowing and quasi-solid layers. The dependence of the flow patterns (appearance and position of… More >

A. B. Mahmud Hasan^1,2, S.M. Guo¹, M.A. Wahab¹

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.4, pp. 399-410, 2009, DOI:10.3970/fdmp.2009.005.399

Abstract The effects of gas flow channel design were studied experimentally for increasing fuel cell performance and fuel optimization. Three types of gas flow channels (serpentine, straight and interdigitated) were designed on the basis of water flooding due to electrochemical reactions, electro-osmotic drag, etc. Experimental results indicate that the best cell performance can be obtained by arranging interdigitated gas flow channel at the anode side and serpentine gas flow channel at the cathode side. Detailed analysis on complex two phase water generation and electrochemical phenomena behind those results were analyzed in this work to find out the best design for gas… More >

A. K. Plappally^1,3, I. Yakub^2,3, L. C. Brown^1,2,3, A. B. O. Soboyejo¹

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.4, pp. 373-398, 2009, DOI:10.3970/fdmp.2009.005.373

Abstract Water flow through point-of-use porous ceramic water treatment filters have been theoretically analyzed in this technical paper. Filters tested were manufactured by combining low cost materials namely, clay and sawdust. Three filters with distinct volume fractions of clay to sawdust (75:25, 65:35 and 50:50) were tested. Sintered clay filters casted in frustum shapes were structurally characterized using mercury intrusion porosimetry. A linear increase in porosity with volume fraction of sawdust was observed. Flow experiments were carried out at constant room temperature and pressure. Potable tap water was used in these studies. Flows through filters occurring with drop in the head… More >

A. Alke¹, D. Bothe¹

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.4, pp. 345-372, 2009, DOI:10.3970/fdmp.2009.005.345

Abstract We present a computational approach based on the Volume-of-Fluid (VOF) method for simulating the influence of a soluble surfactant on the behavior of two-phase systems with deformable interface. Our approach is applicable to diffusion controlled processes, where the relation between the area-specific excess surfactant concentration on the interface and the volume-specific concentration adjacent to the interface is given by an adsorption isotherm. Main issues of the numerical model are an extended surface transport theorem used for describing the interfacial flux and an iso-surface of the VOF-variable used as a connected approximation for the interface. 3D-simulations of a bubble moving through… More >

F. Mechighel^1,2, M. El Ganaoui¹, M. Kadja², B. Pateyron³, S. Dost⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.4, pp. 313-330, 2009, DOI:10.3970/fdmp.2009.005.313

Abstract A numerical study has been carried out to investigate the three-dimen -sional buoyant flow in a parallelepiped box heated from below and partially from the two sidewalls (a configuration commonly used for solidification problems and crystal growth systems). Attention has been paid, in particular, to phenomena of symmetry breaking and transition to unsteady non-symmetric convection for a low Prandtl number fluid (Pr=0.01). The influence of an applied horizontal magnetic field on the stability properties of the flow has been also considered. Results obtained may be summarized as follows: In the absence of magnetic field and for relatively small values of… More >

K.V. Pagalthivarthi¹, P.K. Gupta²

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.1, pp. 93-122, 2009, DOI:10.3970/fdmp.2009.005.093

Abstract The objective of the present work is to predict erosive wear in multisize dense slurry flow in a rotating channel. The methodology comprises numerical prediction of two-phase flow which is accomplished using the Galerkin finite element method. The wear models for both sliding wear and impact wear mechanisms account for the particle size dependence. The effect of various operating parameters such as rotation rate, solids concentration, flow rate, particle size distribution and so forth has been studied. Results indicate that wear rate in general increases along the pressure-side of the channel with rotation rate, overall solids concentration, flow rates etc.… More >

G. Accary¹, S. Meradji², D. Morvan², D. Fougère²

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.4, pp. 263-270, 2008, DOI:10.3970/fdmp.2008.004.263

Abstract In the literature, only few references have dealt with mixed-convection flows in the low Mach number approximation. For this reason, in the present study we propose to extend the standard 3D benchmark for mixed convection in a rectangular channel heated from below (Medale and Nicolas, 2005) to the case of large temperature variations (for which the Boussinesq approximation is no longer valid). The Navier-Stokes equations, obtained under the assumption of a low Mach number flow, are solved using a finite volume method. The results, corresponding to the steady-state case of the benchmark, lead to the idea of launching a call… More >

R. Abdeljabar¹, F. Onofri², M.J. Safi¹

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.4, pp. 245-254, 2008, DOI:10.3970/fdmp.2008.004.245

Abstract This paper focuses on the mechanisms of convective instability in a stable salty gradient layer (i.e. an interfacial salty layer). This layer is assumed to be initially confined between two homogeneous liquid layers: a lower layer composed of salty water of 5wt% concentration and an upper layer composed of distilled water. The mechanisms underlying the interfacial salty layer's instability are depicted experimentally using a PIV technique and via measurements of concentration and temperature. It is found that in addition to the effect of double-diffusion across the interfacial salty layer, different forms of Kelvin-Helmholtz instability occur at different locations:\newline i. At… More >

A.A. Ivanova¹, V.G. Kozlov^1,2,3, D.A. Polezhaev¹, D. Pareau³, M. Stambouli³

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.3, pp. 211-220, 2008, DOI:10.3970/fdmp.2008.004.211

Abstract The problem for the optimization of mass-transfer on the interface of two immiscible liquids by means of vibrational hydromechanics is studied experimentally. A new vibrational cell of Lewis's type expressly conceived for such purposes is described. Flow is generated by activators in the form of disks inducing translational axial oscillations near the opposite end faces of the cavity. It is shown that such vibrating disks can lead to the onset of a large-scale toroidal whirlwind effectively mixing the liquid throughout the volume. According to the experiments, in particular, axisymmetrical radial flows are generated on both sides of the horizontal liquid… More >