Abdulmoseen Segun Giwa^1,*, Mingqiang Sheng², Ndungutse Jean Maurice³, Xinxin Liu¹, Zelong Wang¹, Fengmin Chang⁴, Bo Huang⁴, Kaijun Wang⁴

Journal of Renewable Materials, Vol.11, No.6, pp. 2593-2629, 2023, DOI:10.32604/jrm.2023.026314

Abstract Globally, fossil fuel dependence has created several environmental challenges and climate change. Hence, creating other alternative renewable and ecologically friendly bio-energy sources is necessary. Lignocellulosic biomass has gained significant attention recently as a renewable material for biofuel production. The large amounts of plantain and banana plant parts wasted after harvesting, as well as the peels generated daily by the fruit market and industries, demonstrate the potential of bioenergy resources. This review briefly assesses plantain and banana plant biomass (PBB) generated in the developing, developed, and underdeveloped countries, the consumable parts, and feasible products yield. It emphasized the advantages and disadvantages… More > Graphic Abstract

Kakudji Kisimba¹, Anand Krishnan^2,*, Mbuso Faya¹, Kahumba Byanga³, Kabange Kasumbwe⁴, Kaliyapillai Vijayakumar⁵, Ram Prasad^6,*

Journal of Renewable Materials, Vol.11, No.6, pp. 2575-2591, 2023, DOI:10.32604/jrm.2023.026159

Abstract Nanoparticles have distinct properties that make them potentially valuable in a variety of industries. As a result, emerging approaches for the manufacture of nanoparticles are gaining a lot of scientific interest. The biological pathway of nanoparticle synthesis has been suggested as an effective, affordable, and environmentally safe method. Synthesis of nanoparticles through physical and chemical processes uses unsafe materials, expensive equipment and adversely affects the environment. As a result, in order to support the increased utilization of nanoparticles across many sectors, nanotechnology research activities have shifted toward environmentally safe and cost-effective techniques that outperform chemical and/or biological procedures. The use… More > Graphic Abstract

Jianwei Zhang¹, Yue Yin¹, Lei Shi¹, Yi Han², Mi Zhou^3,*, Xihong Zhang⁴

Journal of Renewable Materials, Vol.11, No.6, pp. 2893-2911, 2023, DOI:10.32604/jrm.2023.025436

Abstract Dust is an environmental and health hazard. In this study, a new technology for dust suppressant is introduced using soybean urease with an optimal cementing solution. Calcium carbonate is produced by soybean urease and cementing solution, which bonds the soil particles towards a dust suppressant. A laboratory wind tunnel test is carried out to examine its effectiveness and discover possible optimization solutions. Several factors, including soybean meal concentration, cementing solution concentration, and volume of solution per unit area, are examined to quantify their influences on soil transport mass, evaporation ratio, evaporation rate, surface strength, water retention ratio, and infiltration rate… More >

Zhuoli Yang¹, Xianbin Hou², Leyang Dai^2,*

Journal of Renewable Materials, Vol.11, No.6, pp. 2941-2951, 2023, DOI:10.32604/jrm.2023.025723

Abstract Plasma-assisted ball milling was carried out on the Al+C₃H₆N₆ system and Al+C₄H₄N₄ system, respectively. The phase structure, functional groups and synthesis mechanism were analyzed by XRD and FT-IR, and the differences in the synthesis process of nano-AlN with different solid nitrogen sources were discussed. The results show that C₃H₆N₆ has a stable triazine ring structure, and its chemical bond is firm and difficult to break, so AlN cannot be synthesized directly by solid-solid reaction at room temperature. However, there are a large number of nitrile groups (-CN) and amino groups (-NH2) in C₄H₄N₄ molecules. Under the combined action of plasma… More >

Sri Hidayati^1,*, Eugenia Fonny Budiyanto¹, Hadi Saputra¹, Sutopo Hadi¹, Apri Heri Iswanto^2,3, Nissa Nurfajrin Solihat⁴, Petar Antov⁵, Lee Seng Hua^6,7, Widya Fatriasari^4,8, Mohd. Sapuan Salit⁹

Journal of Renewable Materials, Vol.11, No.6, pp. 2865-2879, 2023, DOI:10.32604/jrm.2023.027579

Abstract Black liquor is obtained as a by-product of the pulping process, which is used to convert biomass into pulp by removing lignin, hemicelluloses and other extractives from wood to free cellulose fibers. Lignin represents a major constituent in black liquor, with quantities varying from 20% to 30%, of which a very low share is used for manufacturing value-added products, while the rest is mainly burned for energy purposes, thus underestimating its great potential as a raw material. Therefore, it is essential to establish new isolation and extraction methods to increase lignin valorization in the development of bio-based chemicals. The aim… More > Graphic Abstract

Yue Chen^1,2, Haitao Li^1,2,*, Lei Gao^3,*, Wei Xu^1,2, Rodolfo Lorenzo⁴, Milan Gaff^5,6

Journal of Renewable Materials, Vol.11, No.6, pp. 2787-2808, 2023, DOI:10.32604/jrm.2023.027634

Abstract Bamboo is an eco-friendly material with light weight, high strength, short growth cycle and high sustainability, which is widely used in building structures. Engineered bamboo has further promoted the development of modern bamboo structures due to its unrestricted size and shape. However, as a fiber-reinforced material, fracture damage, especially Mode I fracture damage, becomes the most likely damage mode of its structure, so Mode I fracture characteristics are an important subject in the research of mechanical properties of bamboo. This paper summarizes the current status of experimental research on the Mode I fracture properties of bamboo based on the three-point… More >

Liefei Pei^1,2, Xiangyun Zhang¹, Zizhou Yuan^1,*

Journal of Renewable Materials, Vol.11, No.6, pp. 2969-2983, 2023, DOI:10.32604/jrm.2023.025760

Abstract Iron-based amorphous crystalline powder Fe₇₈Si₉B₁₃^AP is used as a permeability reaction barrier (PRB) combined with an electrokinetic method (EK-PRB) to study the removal rate of Cu in contaminated soil. After treating Cucontaminated soil for 5 days under different voltage gradients and soil water content, the soil pH is between 3.1 and 7.2. The increase of voltage gradient and soil water content can effectively promote the movement of Cu²⁺ to the cathode. The voltage gradient is 3 V/cm, and the water content of 40% is considered to be an optional experimental condition. Therefore, under this condition, the effects of Fe₇₈Si₉B₁₃^AP and… More >

Nurul Anis Athirah Ab Aziz^*, Chin Wei Lai^*, Boon Hoong Ong

Journal of Renewable Materials, Vol.11, No.6, pp. 2745-2770, 2023, DOI:10.32604/jrm.2023.025899

Abstract Nowadays, corrosion is not only undesirable, but it also has a significant influence on the industrial sectors and technical innovations that have demand for metals. The global economic damage is expected to reach $2.5 trillion, equivalent to more than 3.4% of the world’s GDP in 2013. It is linked with significant financial harm, manufacturing pollution, and safety issues. An electrochemical process primarily induces metal corrosion at the metalelectrolyte interface region, caused by steel oxidation and the reduction of oxygen, protons, and water. Therefore, organic and epoxy coatings can be applied as protective coatings. Additionally, it can prevent metal corrosion in… More > Graphic Abstract

Rafal A. Hadi^1,*, Suhad M. Abd², Hadee Mohammed Najm³, Shaker Qaidi^4,5,*, Moutaz Mustafa A. Eldirderi⁶, Khaled Mohamed Khedher^7,8

Journal of Renewable Materials, Vol.11, No.6, pp. 2925-2940, 2023, DOI:10.32604/jrm.2023.025558

Abstract Recent years have witnessed an increase in the quantity of waste glass (WG) across the globe. Replacing the fine aggregate with WG is one of the steps toward preserving the natural resources of the environment and creating low-cost concrete. The present study is concerned with replacing fine aggregates with glass powder (GP) at (0%, 15%, 30%, and 50%). It has studied the fresh and hardened properties (compressive strength, tensile strength, hardened density, and slump) for all the mentioned percent replacements. The findings have shown that all mixtures containing GP gave acceptable slump results within the design limits (2–5 cm) according… More >

Yatim Lailun Ni’mah^*, Nabila Eka Yuningsih, Suprapto Suprapto

Journal of Renewable Materials, Vol.11, No.6, pp. 2913-2924, 2023, DOI:10.32604/jrm.2023.025431

Abstract The adsorption of Pb(II) on silica gel synthesized from chemical glass bottle waste has been studied. The effect of independent variables (adsorbent dose, initial concentration of Pb(II), contact time, and pH) on the Pb(II) removal from water was evaluated and optimized using the Response Surface Methodology (RSM). Under optimized conditions (adsorbent dose: 20 mg; contact time: 30 min; initial Pb(II) concentration: 120 mg. L⁻¹ ; and pH: 8), the removal of Pb(II) was 99.77%. The adsorption equilibrium data obtained from the batch experiment were investigated using different isotherm models. The Langmuir isotherm model fits the experimental data. This shows that… More >