Hao Guo^a , Xianbing Ji^a,b,1 , Jinliang Xu^a,b

Frontiers in Heat and Mass Transfer, Vol.14, pp. 1-16, 2020, DOI:10.5098/hmt.14.14

Abstract With fast development of electronic devices, novel strategies of thermal management have been received great attention to dissipate high heat fluxes. As an efficient heat transfer device, loop heat pipe (LHP) provides ideal solution for such purpose. Even though LHP was invented nearly half-century ago, challenges still exist on its design, fabrication and operation. The objective of this paper is to present a thorough review on LHPs, paying more attention on the working principle, advantage and configuration. The review is performed in three aspects. First, the macroscopic operation characteristics such as start-up, temperature fluctuations and anti-gravity operation are described. Second,… More >

Wenlei Lian, Zijian Sun, Taoyi Han, Yimin Xuan^*

Frontiers in Heat and Mass Transfer, Vol.14, pp. 1-6, 2020, DOI:10.5098/hmt.14.10

Abstract An experimental facility is developed to investigate the characteristics of the nucleate boiling heat transfer in a rotating water film. The High speed photography technique is used to visualize the flow field of the rotating water film. Along with the bubble photographs, the centrifugal acceleration, heat flux into the film, and the heat transfer coefficient are calculated to learn the heat transfer characteristics of the water film. It is found that the boiling heat transfer coefficient decreases with the increment of heat flux. The heat transfer coefficient increases with acceleration increasing from 20g to 60g, but show no obvious increase… More >

Firas Aziz Ali^a,*, Adnan M. Alsaffawi^b , Karam Hashim Mohammed^a

Frontiers in Heat and Mass Transfer, Vol.15, pp. 1-7, 2020, DOI:10.5098/hmt.15.21

Abstract The augmentation of the heat transfer in heat exchangers is one of the methods to increase efficiency of the system. The double tube heat exchanger is selected to many suitable techniques of heat transfer enhancement. In this study; the friction factor and heat transfer coefficient of double tube is evaluated experimentally. The Al₂O₃ nanoparticles dispersed in ethylene glycol (EG) with a diameter 50 nm and the weight concentration (0.1%, 0.3%, 0.5%, 0.7%, 1%) has been utilized. Then the effect of parallel current and counter current with different ranges of Reynolds number (10,000 to 30,000) on the friction factor and heat… More >

Crisanto Velázquez-Becerra^1,*, Gu Yen Ambriz-Ortiz¹, Rafael Torres-Martínez², Mauro Manuel Martínez-Pacheco³

Phyton-International Journal of Experimental Botany, Vol.92, No.7, pp. 2165-2181, 2023, DOI:10.32604/phyton.2023.026954

Abstract Wood is a lignocellulosic material that, because of its organic nature, is a source of nutrients for bacteria, fungi, and insects. Incisitermes marginipennis (Latreille) is an interesting dry wood-boring termite. Because it is an extremely destructive pest, difficult to control due to its cryptic lifestyle, and for its role in the biogeochemical cycle of carbon and other elements; it is a fundamental organism. The use of less toxic and eco-friendly substances is important for protecting domestic, cultural, and historical heritage made of wood or lignocellulosic materials. The aim of this study was to evaluate the biological activity of various naphthoquinones… More >

J. Sainton, M. Derzelle

Psycho-Oncologie, Vol.16, No.2, pp. 229-233, 2022, DOI:10.3166/pson-2022-0195

Abstract L’évolution législative récente relative à la fin de vie, qui tend à substituer la procédure à la relation, interroge. Aujourd’hui, chaque question semble devoir être obstiné- ment transformée en problème à résoudre, et donc à résoudre techniquement. Nous évoluons dans un contexte marqué par la primauté de la technique et du droit sur le sens et sur le rapport humain. Ce paradigme, confronté à nos limites, accentue la double angoisse de la fin de vie : la peur de souffrir et la peur de mourir. Il favorise également une compréhension nominaliste de la liberté : l’autonomie n’est plus comprise comme… More >

P. Laperle, M. Achille, D. Ummel

Psycho-Oncologie, Vol.16, No.2, pp. 253-259, 2022, DOI:10.3166/pson-2022-0194

Abstract Les soignants en oncologie et en soins palliatifs gagnent à considérer les effets de l’euthanasie sur leur pratique. Choisir les circonstances de sa mort est dans l’ère du temps, ce qui influence les trajectoires de soins. Ainsi, il devient pertinent de s’intéresser à l’impact du décès anticipé (euthanasique ou naturel) à la fois sur l’accompagnement du patient et sur celui des proches endeuillés. À cet égard, nous proposons une approche relationnelle et des pistes d’intervention fondées sur les empreintes laissées par la mort et le paysage relationnel du deuil. More >

Hawraa S. Mohammed^*, Mahmoud A. Mashkour

FDMP-Fluid Dynamics & Materials Processing, Vol.19, No.9, pp. 2329-2343, 2023, DOI:10.32604/fdmp.2023.026890

Abstract This study considers the effect of Eichhornia Crassipes Biodiesel (ECB) blends on the performances, combustion, and emission characteristics of a direct injection compression ignition engine operated in a dual-fuel mode (DFM) and equipped with an Exhaust gas recirculation technique (EGR). In particular, a single-cylinder, four-stroke, water-cooled diesel engine was utilized and four modes of fuel operation were considered: mode I, the engine operated with an ordinary diesel fuel; mode II, the engine operated with the addition of 2.4 L/min of liquefied petroleum gas (LPG) and 20% EGR; mode III, 20% ECB with 2.4 L/min LPG and 20% EGR; mode IV,… More >

Roshan Devidas Bhagat^a,*, Samir J. Deshmukh^b

Frontiers in Heat and Mass Transfer, Vol.16, pp. 1-16, 2021, DOI:10.5098/hmt.16.23

Abstract Numerical analysis of passive two phase fluid flow in a 3D Closed Loop Pulsating Heat Pipe (CLPHP) with turns in evaporator and condenser section is carried out. Water is used as working fluid. The volume of fluid model (VOF) is used to simulate passive two-phase fluid flow in a Closed Loop Pulsating Heat Pipe. Filling ratio (FR) of is kept in the range of 60 to 70%. The evaporator temperature is set in the range of 353 K. The condenser temperature is set in the range of 298 K. The contours of volume fraction water, wall temperature and contours of… More >

Yasushi Koito^*

Frontiers in Heat and Mass Transfer, Vol.16, pp. 1-6, 2021, DOI:10.5098/hmt.16.8

Abstract Numerical analyses were conducted for an ultra-thin heat pipe in which a thin wick layer was placed on the bottom. The vapor temperature drop caused by vapor flow friction was discussed for two types of the ultra-thin heat pipes with small and large widths. The numerical results were compared with those obtained for an ultra-thin heat pipe with a centered-wick structure. It was confirmed that the vapor temperature drop was reduced effectively by increasing the width of the heat pipe. Therefore, a wider ultra-thin heat pipe, that is, an ultra-thin vapor chamber is a promising option for nextgeneration thermal management. More >

Randeep Singh^a,*,†, Gero Lapp^a, Jason Velardo^b, Phan Thanh Long^a, Masataka Mochizuki^c, Aliakbar Akbarzadeh^d, Abhijit Date^d, Karsten Mausolf^e, Kristin Busse^e

Frontiers in Heat and Mass Transfer, Vol.16, pp. 1-8, 2021, DOI:10.5098/hmt.16.2

Abstract In this paper, different options, based on heat pipes, for thermal management of electric vehicle (EV) battery system, at cell, module and pack level, for 40 to 400 W output heat, has been explored, analysed and compared. Cooling architecture based on embedded heat pipe (EHP) with single phase pumped cold plate (CP), as most adaptable design for low to medium range EVs, while EHP with loop heat pipe (LHP) as high performance design for high-end carlines, has been classified as potential cooling systems. Experimentally, it was shown that EHPs will provide best performance for heat acquisition at cell/module level, while… More >