S. Marisargunam^1,*, L. Kalaivani², R. V. Maheswari²

Intelligent Automation & Soft Computing, Vol.33, No.3, pp. 1711-1727, 2022, DOI:10.32604/iasc.2022.023643 - 24 March 2022

Abstract Wind Energy Conversion Systems (WECS) are extensively used for connecting directly to grid sources. Permanent magnet synchronous generator (PMSG) based WECS is coupled to both grid and machine through converters. PMSG usually associated rectifiers with converters and voltage source converters at machine side. In this work, PMSG associated rectifiers with converters are considered for analysis of grid stability. The proposed work used Particle Swarm Optimization (PSO) based optimization methods for extraction of maximum power within boundary condition in WECS operation using PMSG. This high-tech optimization has MPPT controller for pitch angle controller (PAC) combines with… More >

R. K. Rojin^1,*, M. Mary Linda²

Intelligent Automation & Soft Computing, Vol.33, No.1, pp. 245-258, 2022, DOI:10.32604/iasc.2022.021834 - 05 January 2022

Abstract Microgrids (MG) are distribution networks encompassing distributed energy sources. As it obtains the power from these resources, few problems such as instability along with Steady-State (SS) issues are noticed. To address the stability issues, that arise due to disturbances of low magnitude. Small-Signals Stability (SSS) becomes mandatory in the network. Convergence at local optimum is one of the major issues noticed with the existing optimization algorithms. This paper proposes a detailed model of SSS in Direct Current (DC)-Alternate Current (AC) Hybrid MG (HMG) using Proportional Integral and Derivative Controller (PIDC) tuned with Modified Particle Swarm… More >

G. Geethamahalakshmi^1,*, N. Kalaiarasi², D. Nageswari¹

Intelligent Automation & Soft Computing, Vol.32, No.3, pp. 1667-1685, 2022, DOI:10.32604/iasc.2022.022728 - 09 December 2021

Abstract Solar energy is the radiant heat and light energy harvested by ultra violet rays to convert into electrical Direct Current (DC). The solar energy stood ahead of other renewable energy as it can produce a constant level of alternating current over the year with minimal harmonic distortions. The renewable energy attracts the energy harvesters as there is rise of deficiency of carbon and reduction of efficiency in thermal energy generation. The concerns associated with the solar power generation are the fluctuation in the generated direct current due to the displacement of sun and deviation in… More >

Ibrahim M. Mehedi^1,2,*, Ubaid M. Al-Saggaf^1,2, Mahendiran T. Vellingiri¹, Ahmad H. Milyani¹, Nordin Bin Saad³, Nor Zaihar Bin Yahaya³

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 4001-4017, 2022, DOI:10.32604/cmc.2022.021981 - 07 December 2021

Abstract In recent times, wind energy receives maximum attention and has become a significant green energy source globally. The wind turbine (WT) entered into several domains such as power electronics that are employed to assist the connection process of a wind energy system and grid. The turbulent characteristics of wind profile along with uncertainty in the design of WT make it highly challenging for prolific power extraction. The pitch control angle is employed to effectively operate the WT at the above nominal wind speed. Besides, the pitch controller needs to be intelligent for the extraction of… More >

Xin He¹, Ping Wei², Xiaoyan Gong¹, Xiangfei Meng³, Dong Shan⁴, Jiawei Zhu^5,*

Energy Engineering, Vol.119, No.1, pp. 145-161, 2022, DOI:10.32604/EE.2022.015910 - 22 November 2021

Abstract For the past few years, wind energy is the most popular non-traditional resource among renewable energy resources and it’s significant to make full use of wind energy to realize a high level of generating power. Moreover, diverse maximum power point tracking (MPPT) methods have been designed for varying speed operation of wind energy conversion system (WECS) applications to obtain optimal power extraction. Hence, a novel and meta-heuristic technique, named enhanced atom search optimization (EASO), is designed for a permanent magnet synchronous generator (PMSG) based WECS, which can be employed to track the maximum power point.… More >

D. Sabaripandiyan^1,*, H. Habeebullah Sait², G. Aarthi³

Intelligent Automation & Soft Computing, Vol.32, No.2, pp. 1055-1070, 2022, DOI:10.32604/iasc.2022.021950 - 17 November 2021

Abstract The main aspiration of this paper is to improve the efficiency of Solar Photovoltaic (SPV) power system with a new Hybrid controller for standalone/isolated Solar PV applications is proposed. This controller uses the merits of both Adapted Neuro-Fuzzy Inference System (ANFIS) and Perturbation & Observation (P&O) control techniques to concede rapid recovery at dynamic change of environment conditions such as solar irradiation and temperature. The ANFIS strategy itself has the merits over Fuzzy Logic and ANN methods. Conversely, P&O has its simplicity in implementation. Hence a case study for rapid recovery with the proposed controller… More >

Yasemin Onal^*

Computer Systems Science and Engineering, Vol.41, No.1, pp. 141-156, 2022, DOI:10.32604/csse.2022.020367 - 08 October 2021

Abstract Predicting the power obtained at the output of the photovoltaic (PV) system is fundamental for the optimum use of the PV system. However, it varies at different times of the day depending on intermittent and nonlinear environmental conditions including solar irradiation, temperature and the wind speed, Short-term power prediction is vital in PV systems to reconcile generation and demand in terms of the cost and capacity of the reserve. In this study, a Gaussian kernel based Support Vector Regression (SVR) prediction model using multiple input variables is proposed for estimating the maximum power obtained from… More >

N. Kanagaraj^*

Computer Systems Science and Engineering, Vol.40, No.2, pp. 517-538, 2022, DOI:10.32604/csse.2022.019149 - 09 September 2021

Abstract In this paper, the hybrid photovoltaic-thermoelectric generator (PV-TEG) combined dynamic voltage restorer (DVR) system is proposed for the power quality disturbances compensation in a single-phase distribution system. The stable and precise level of input voltage is essential for the smooth and trouble-free operation of the electrically sensitive loads which are connected at the utility side to avoid system malfunctions. In this context, the hybrid PV-TEG energy module combined DVR system is proposed in this paper. With the support of the hybrid energy module, the DVR will perform the power quality disturbances compensation effectively with needed… More >

M. Usman Khan^1,*, K. M. Hasan¹, A. Faisal Murtaza², H. M. Usman², Hadeed A. Sher³

CMC-Computers, Materials & Continua, Vol.70, No.1, pp. 135-150, 2022, DOI:10.32604/cmc.2022.019381 - 07 September 2021

Abstract

In this paper, a stand-alone photovoltaic (PV) system based on a Double Ended Forward Converter (DEFC) is presented. The proposed converter is specified for 48 V, 100 W applications as most of the equipment used in telecommunication and aircraft fall in this range. The literature has limited potential application of DEFC in PV systems. The research work deals with an in-depth study of DEFC and proposes an improved DEFC for PV applications with battery backup. Besides, a bi-directional dc-dc converter for the battery is integrated to track the Maximum Power Point (MPP) of the PV

More >

K. Karthick^1,*, K. Jaiganesh², S. Kavaskar³

Energy Engineering, Vol.118, No.6, pp. 1887-1904, 2021, DOI:10.32604/EE.2021.017563 - 10 September 2021

Abstract The energy efficient product can be operated with longer duration. They offer wonderful solutions compared to other conventional water pumping system as it needs less maintenance, simple in installation, zero fuel cost, longer operating life, highly reliable and free from production of greenhouse gases. In this paper we analyzed the different topologies of DC–DC converter in terms of their operating region of MPPT, quality of input and output currents. We discussed the MPPT algorithms to address partial shading effects in SPV array, present state of the technology, factors affecting the performance of the system, efficiency… More >