S. Srinivasan¹, M. Z. Saghir¹

FDMP-Fluid Dynamics & Materials Processing, Vol.7, No.2, pp. 201-216, 2011, DOI:10.3970/fdmp.2011.007.201

Abstract CFD simulations have been made to understand the impact of the vibrations of the ISS on the thermodiffusion process. Simulations were made for two ternary hydrocarbon mixtures and one binary associated mixture. While one of the ternary mixture was at a pressure of 35 MPa, the second ternary mixture as well as the binary mixture were at a pressure of 0.101325 MPa. The analysis of the results showed that imposing the ISS vibrations had a profound effect on the Soret effect in all three systems. More precisely, in all three mixtures, a single convective flow cell is established. Such a… More >

L. Dammak, E. Hadj-Taïeb

FDMP-Fluid Dynamics & Materials Processing, Vol.6, No.4, pp. 419-430, 2010, DOI:10.3970/fdmp.2010.006.419

Abstract This paper presents a short and focused analysis of the pressure development inside the fluid film related to a journal bearing (i.e. the pressure distribution in the the gap between the shaft, generally referred to as the "journal", and the bearing). The related flow is considered to be isotherm, laminar, steady and incompressible. The lubricant is assumed to be an isoviscous fluid. The Reynolds equation governing the lubricant pressure is derived from the coupled continuity and momentum balance equations written in the framework of the Stokes theory. The non linear system given by coupled equations for fluid pressure development (the… More >

F. Mechighel^1,2, M. El Ganaoui¹, M. Kadja², B. Pateyron³, S. Dost⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.5, No.4, pp. 313-330, 2009, DOI:10.3970/fdmp.2009.005.313

Abstract A numerical study has been carried out to investigate the three-dimen -sional buoyant flow in a parallelepiped box heated from below and partially from the two sidewalls (a configuration commonly used for solidification problems and crystal growth systems). Attention has been paid, in particular, to phenomena of symmetry breaking and transition to unsteady non-symmetric convection for a low Prandtl number fluid (Pr=0.01). The influence of an applied horizontal magnetic field on the stability properties of the flow has been also considered. Results obtained may be summarized as follows: In the absence of magnetic field and for relatively small values of… More >

A. M. Ben-Arous¹, A. A. Busedra¹

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.4, pp. 255-262, 2008, DOI:10.3970/fdmp.2008.004.255

Abstract The problem of combined free and forced convection in horizontal semicircular ducts (flat wall at the bottom) with radial internal fins is investigated from a numerical point of view. The wall of the duct is assumed to have a uniform heat input along the axial direction with a uniform peripheral wall temperature (H1). The analysis focuses on the case of hydrodynamically and thermally fully-developed laminar flow. The governing equations for the velocity and temperature are solved by using a control-volume-based finite-difference approach. The fluid flow and heat transfer characteristics are found to be dependent on the Grashof number, the fin… More >

L. Bennamoun¹, A. Belhamri²

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.4, pp. 221-230, 2008, DOI:10.3970/fdmp.2008.004.221

Abstract This work focuses on tyipical heat and mass transfer phenomena during the processing of products in the context of the packed-bed drying method (products arranged in thick layers into dryers working in forced convection mode). The dryers are modeled as porous media at the macroscopic level. The simulations are carried out using the mass, momentum (written in the framework of the Darcy's law approximation) and energy equations applied for the different components. A diffusion model based on Fick's law is also used to take into account the drying kinetics. This approach allows monitoring of the variations of humidity and temperature… More >

V.G. Kozlov¹, N.V. Selin²

FDMP-Fluid Dynamics & Materials Processing, Vol.2, No.2, pp. 107-118, 2006, DOI:10.3970/fdmp.2006.002.107

Abstract Thermal vibrational convection in a sector of a thin spherical liquid layer subjected to pendulum vibrations (spherical pendulum) is investigated theoretically and experimentally. Temperature non-uniformity inside the liquid is caused by uniformly distributed internal heat sources (one side of the layer is isothermal, the other one is adiabatic). Experiments are carried out under conditions of stable temperature stratification in the gravity field. Heat transfer and convective structure are investigated in a wide interval of governing dimensionless parameters. A critical increase of heat transfer is revealed as the vibrations intensity is increased, caused by average convection. It is shown that thermal… More >

J.R. Lin¹, P.J. Li², T.C. Hung³

FDMP-Fluid Dynamics & Materials Processing, Vol.9, No.4, pp. 419-434, 2013, DOI:10.3970/fdmp.2013.009.419

Abstract On the basis of the Shliomis ferrofluid model (1972) together with the micro-continuum theory of Stokes (1966), the influences of non-Newtonian ferrofluids on the steady-state performance of long journal bearings have been investigated in the present paper. Analytical solutions for bearing performances are obtained from the non-Newtonian ferrofluid Reynolds-type equation. Comparing with the Newtonian non-ferrofluid case, the effects of non-Newtonian ferrofluids with applied magnetic fields provide an increase in the zero pressure-gradient angle and the load capacity, and a decrease in the friction parameter, especially for a larger non-Newtonian couple stress parameter and magnetic Langevin’s parameter. For the long journal… More >

Emad Elnajjar¹, Mohammad O. Hamdan, Yousef Haik

FDMP-Fluid Dynamics & Materials Processing, Vol.9, No.1, pp. 77-89, 2013, DOI:10.3970/fdmp.2013.009.077

Abstract In this paper, two heat transfer configurations (central-jet and side-jet) of jet impinging on a semicircular surface are experimentally studied. The internal channel is formed using flat insulated wall and a semi-circular surface using a curved flexible heater with a uniform heat flux. A set of experiments have been performed for the purpose of assessing the heat augmentation and pressure drop between the two jet configurations. The measurements include the inlet and outlet flow temperatures using thermocouples, the temperature map of the flexible heater using thermal infra-red camera, the flow rates using rotary meter and pressure drop using pressure transducer.… More >

M. M. Shemirani¹, M. Z. Saghir²

FDMP-Fluid Dynamics & Materials Processing, Vol.9, No.1, pp. 11-21, 2013, DOI:10.3970/fdmp.2013.009.011

Abstract Producing homogeneous single bulk crystals requires a good understanding of the thermo-solutal behavior in the solvent region. This study explores simulation of the growth of large diameter single bulk crystals of silicon and germanium alloy from its melt utilizing Bridgman method. Both thermal and solutal diffusion of silicon and germanium in the molten SiGe alloy are of interest. It was observed that the diffusion dominates the transport phenomenon in the solvent region especially in the first 25 mm of the model due to having a Pe_T <<1. It was also found that the control of both radial and axial applied… More >

A. Parsa¹, M.Z. Saghir¹

FDMP-Fluid Dynamics & Materials Processing, Vol.8, No.1, pp. 27-50, 2012, DOI:10.3970/fdmp.2011.008.027

Abstract Experiments onboard the International Space Station typically display undesired convective flow as a results of unwanted oscillatory g-jitters. A cubic rigid cell filled with water (90%) and isopropanol (10%) with a thermal gradient and forced vibrations is considered. The cell is under the influence of three different levels of periodic oscillation (Ra_vib ≈ 1.6, 650 and 4000) applied perpendicular to the temperature gradient. In this paper, we examine the transport process (fluid flow, heat transfer and mass transfer) due to oscillatory g-jitters in the presence of Soret effect. The full transient Navier Stokes equations coupled with the mass and heat… More >