Je-Chin Han^*, Akhilesh P. Rallabandi

Frontiers in Heat and Mass Transfer, Vol.1, No.1, pp. 1-21, 2010, DOI:10.5098/hmt.v1.1.3001

Abstract Film cooling is widely used to protect modern gas turbine blades and vanes from the ever increasing inlet temperatures. Film cooling involves a very complex turbulent flow-field, the characterization of which is necessary for reliable and economical design. Several experimental studies have focused on gas turbine blade, vane and end-wall film cooling over the past few decades. Measurements of heat transfer coefficients, film cooling effectiveness values and heat flux ratios using several different experimental methods have been reported. The emphasis of this current review is on the Pressure Sensitive Paint (PSP) mass transfer analogy to determine the film cooling effectiveness.… More >

Keyong Cheng^a,b,*, Chunzi Zhang^c, Wei Chen^a,b, Shiqiang Liang^a,†, Yongxian Guo^a,d, Xiulan Huai^a

Frontiers in Heat and Mass Transfer, Vol.3, No.3, pp. 1-6, 2012, DOI:10.5098/hmt.v3.3.3003

Abstract A film cooling method with chemical heat sink for gas turbine blades is proposed. In this method, an endothermic reaction of cooling stream occurs due to the heating from the mainstream, which leads to an improvement of film cooling effectiveness. The proposed method at different blowing ratios are computed and compared with the conventional one. The simulation result shows that due to the exsitence of the chemical heat sink the proposed method can enhance film cooling effectiveness not only in the streamwise direction, but also in the spanwise direction. More >

Vasishta Bhargava Nukala^*, Chinmaya Prasad Padhy

Sound & Vibration, Vol.58, pp. 133-150, 2024, DOI:10.32604/sv.2024.047762

Abstract A significant aerodynamic noise from wind turbines arises when the rotating blades interact with turbulent flows. Though the trailing edge of the blade is an important source of noise at high frequencies, the present work deals with the influence of turbulence distortion on leading edge noise from wind turbine blades which becomes significant in low-frequency regions. Four quasi-empirical methods are studied to verify the accuracy of turbulent inflow noise predicted at low frequencies for a 2 MW horizontal axis wind turbine. Results have shown that all methods exhibited a downward linear trend in noise spectra for a given mean wind… More >

Qifa Lang, Yuqiao Zheng^*, Tiancai Cui, Chenglong Shi, Heyu Zhang

Energy Engineering, Vol.121, No.2, pp. 483-498, 2024, DOI:10.32604/ee.2023.042437

Abstract This work presents a novel approach to achieve nonlinear vibration response based on the Hamilton principle. We chose the 5-MW reference wind turbine which was established by the National Renewable Energy Laboratory (NREL), to research the effects of the nonlinear flap-wise vibration characteristics. The turbine wheel is simplified by treating the blade of a wind turbine as an Euler-Bernoulli beam, and the nonlinear flap-wise vibration characteristics of the wind turbine blades are discussed based on the simplification first. Then, the blade’s large-deflection flap-wise vibration governing equation is established by considering the nonlinear term involving the centrifugal force. Lastly, it is… More >

Yuanjun Dai^1,2,*, Xin Wei¹, Baohua Li¹, Cong Wang¹, Kunju Shi¹

FDMP-Fluid Dynamics & Materials Processing, Vol.20, No.2, pp. 337-348, 2024, DOI:10.32604/fdmp.2023.042434

Abstract To study the impact of the trailing-edge wear on the vibrational behavior of wind-turbine blades, unworn blades and trailing-edge worn blades have been assessed through relevant modal tests. According to these experiments, the natural frequencies of trailing-edge worn blades −1, −2, and −3 increase the most in the second to fourth order, the fifth order increases in the middle, and the first order increases the least. The damping ratio data indicate that, in general, the first five-order damping ratios of trailing-edge worn blades −1 and trailing-edge worn blades −2 are reduced, and the first five-order damping ratios of trailing-edge worn… More >

Jiefeng Wang¹, Eddie Yin Kwee Ng^2,*, Jianwu Li¹, Yanhao Cao¹, Yanan Huang¹, Liang Li^1,2,3,*

Frontiers in Heat and Mass Transfer, Vol.21, pp. 1-31, 2023, DOI:10.32604/fhmt.2023.045510

Abstract The flow structure of the vortex cooling is asymmetrical compared to the traditional gas turbine leading edge cooling, such as the impingement cooling and the axial flow cooling. This asymmetrical property will affect the cooling performance in the blade leading edge, whereas such effects are not found in most of the studies on vortex cooling due to the neglect of the mainstream flow in the airfoil channel. This study involves the mainstream flow field and the rotational effects based on the profile of the GE E³ blade to reveal the mechanism of the asymmetrical flow structure effects. The nozzle position… More > Graphic Abstract

Wenyang Tang^1,2, Cong Liu^1,*, Bo Zhang²

Energy Engineering, Vol.120, No.11, pp. 2667-2681, 2023, DOI:10.32604/ee.2023.040743

Abstract Harsh working environments and wear between blades and other unit components can easily lead to cracks and damage on wind turbine blades. The cracks on the blades can endanger the shafting of the generator set, the tower and other components, and even cause the tower to collapse. To achieve high-precision wind blade crack detection, this paper proposes a crack fault-detection strategy that integrates Gated Residual Network (GRN), a fusion module and Transformer. Firstly, GRN can reduce unnecessary noisy inputs that could negatively impact performance while preserving the integrity of feature information. In addition, to gain in-depth information about the characteristics… More >

Yi Zhang^*, Jiamin Guo, Huanghua Peng

Energy Engineering, Vol.120, No.11, pp. 2489-2502, 2023, DOI:10.32604/ee.2023.029496

Abstract The windy environment is the main cause affecting the efficiency of offshore wind turbine installation. In order to improve the stability and efficiency of single-blade installation of offshore wind turbines under high wind speed conditions, the Stewart platform is used as an auxiliary tool to help dock the wind turbine blade in this paper. In order to verify the effectiveness of the Stewart platform for blade docking, a blade docking simulation system consisting of the Stewart platform, wind turbine blade, and wind load calculation module was built based on Simulink/Simscape Multibody. At the same time, the PID algorithm is used… More >

Wenzhe Guo¹, Leian Zhang^1,*, Chao Lv², Weisheng Liu³, Jiabin Tian²

Energy Engineering, Vol.120, No.10, pp. 2307-2323, 2023, DOI:10.32604/ee.2023.030029

Abstract Aiming at the drift problem that the tracking control of the actual load relative to the target load during the electromagnetic excitation biaxial fatigue test of wind turbine blades is easy to drift, a biaxial fatigue testing machine for electromagnetic excitation is designed, and the following strategy of the actual load and the target load is studied. A Fast Transversal Recursive Least Squares algorithm based on fuzzy logic (Fuzzy FTRLS) is proposed to develop a fatigue loading following dynamic strategy, which adjusts the forgetting factor in the algorithm through fuzzy logic to overcome the contradiction between convergence accuracy and convergence… More >

Shu Dai^1,*, Bert Sweetman²

The International Conference on Computational & Experimental Engineering and Sciences, Vol.27, No.2, pp. 1-1, 2023, DOI:10.32604/icces.2023.09687

Abstract Short-term wind process is normally assumed to be a Gaussian distribution, such as TurbSim, the widely used 3D wind field tool. Nowadays, newest researches indicate that non-Gaussian wind model is believed to be more accurate according to the field observation data. A new numerical method is proposed to generate non-Gaussian wind filed using translation process theory and spectral representation method. This study presents a comprehensive investigation on power production and blades fatigue damage of floating offshore wind turbines (FOWTs) to the non-Gaussian wind field. The comparisons of Gaussian and non-Gaussian simulation results indicate that the non-Gaussian wind fields will cost… More >