Yang Xiong^1,2, Jianxin Liu^1,2,*, Xianhao Yi², Bangyan Xiao², Dan Wu², Biao Wu², Chunyu Gao²

Energy Engineering, Vol.121, No.7, pp. 1759-1780, 2024, DOI:10.32604/ee.2024.048536 - 11 June 2024

Abstract In the heterogeneous reservoirs, CO₂ flooding easily leads to CO₂ gas channeling, which can seriously affect sweeping efficiency and reduce oil recovery. After thoroughly investigating the advantages and shortcomings of various CO₂ plugging technologies, this paper focuses on the feasibility of improving conventional water-alternating gas (WAG) through CO₂-responsive gel materials. Based on the different chemical reaction mechanisms between the unique chemical structure and CO₂, changes in the material’s physical and chemical properties can respond to CO₂. The feasibility of utilizing these property changes for CO₂-responsive plugging is explored. Various CO₂-responsive gels and gel nanoparticles have been extensively researched in More >

Xiaodan Wu¹, Jie Li^1,*, Yongbin Cai², Sihui Huang¹

Energy Engineering, Vol.121, No.7, pp. 1963-1990, 2024, DOI:10.32604/ee.2024.048477 - 11 June 2024

Abstract Aiming at the problems of large energy consumption and serious pollution of winter heating existing in the rural buildings in Southern Xinjiang, a combined active-passive heating system was proposed, and the simulation software was used to optimize the parameters of the system, according to the parameters obtained from the optimization, a test platform was built and winter heating test was carried out. The simulation results showed that the thickness of the air layer of 75 mm, the total area of the vent holes of 0.24 m, and the thickness of the insulation layer of 120… More >

Xin Shen¹, Jiahao Li¹, Yujun Yin¹, Jianlin Tang^2,3,*, Weibin Lin^2,3, Mi Zhou^2,3

Energy Engineering, Vol.121, No.7, pp. 1945-1961, 2024, DOI:10.32604/ee.2024.048388 - 11 June 2024

Abstract Advanced carbon emission factors of a power grid can provide users with effective carbon reduction advice, which is of immense importance in mobilizing the entire society to reduce carbon emissions. The method of calculating node carbon emission factors based on the carbon emissions flow theory requires real-time parameters of a power grid. Therefore, it cannot provide carbon factor information beforehand. To address this issue, a prediction model based on the graph attention network is proposed. The model uses a graph structure that is suitable for the topology of the power grid and designs a supervised More >

Ying Qu¹, Jinhao Wang¹, Xueting Cheng¹, Jie Hao¹, Weiru Wang¹, Zhewen Niu², Yuxiang Wu^2,*

Energy Engineering, Vol.121, No.7, pp. 1847-1863, 2024, DOI:10.32604/ee.2024.048300 - 11 June 2024

Abstract The data-driven transient stability assessment (TSA) of power systems can predict online real-time prediction by learning the temporal features before and after faults. However, the accuracy of the assessment is limited by the quality of the data and has weak transferability. Based on this, this paper proposes a method for TSA of power systems based on an improved extreme gradient boosting (XGBoost) model. Firstly, the gradient detection method is employed to remove noise interference while maintaining the original time series trend. On this basis, a focal loss function is introduced to guide the training of… More >

Jie Ma¹, Pengcheng Yue², Haozheng Yu¹, Yuqing Zhang³, Youwen Zhang¹, Cuiping Li³, Junhui Li^3,*, Wenwen Qin³, Yong Guo¹

Energy Engineering, Vol.121, No.7, pp. 1823-1846, 2024, DOI:10.32604/ee.2024.048225 - 11 June 2024

Abstract In recent years, the proportion of installed wind power in the three north regions where wind power bases are concentrated is increasing, but the peak regulation capacity of the power grid in the three north regions of China is limited, resulting in insufficient local wind power consumption capacity. Therefore, this paper proposes a two-layer optimal scheduling strategy based on wind power consumption benefits to improve the power grid's wind power consumption capacity. The objective of the upper model is to minimize the peak-valley difference of the system load, which is mainly to optimize the system… More >

Feng Zhao, Guangdi Liu^*, Xiaoqiang Chen, Ying Wang

Energy Engineering, Vol.121, No.7, pp. 1865-1882, 2024, DOI:10.32604/ee.2024.048209 - 11 June 2024

Abstract In light of the prevailing issue that the existing convolutional neural network (CNN) power quality disturbance identification method can only extract single-scale features, which leads to a lack of feature information and weak anti-noise performance, a new approach for identifying power quality disturbances based on an adaptive Kalman filter (KF) and multi-scale channel attention (MS-CAM) fused convolutional neural network is suggested. Single and composite-disruption signals are generated through simulation. The adaptive maximum likelihood Kalman filter is employed for noise reduction in the initial disturbance signal, and subsequent integration of multi-scale features into the conventional CNN… More >

Razieh Keshavarzi, Mehdi Jahangiri^*

Energy Engineering, Vol.121, No.6, pp. 1381-1401, 2024, DOI:10.32604/ee.2024.050029 - 21 May 2024

Abstract Nowadays, the use of renewable energies, especially wind, solar, and biomass, is essential as an effective solution to address global environmental and economic challenges. Therefore, the current study examines the energy-economic-environmental analysis of off-grid electricity generation systems using solar panels, wind turbines, and biomass generators in various weather conditions in Iran. Simulations over 25 years were conducted using HOMER v2.81 software, aiming to determine the potential of each region and find the lowest cost of electricity production per kWh. In the end, to identify the most suitable location, the Technique for Order Preference by Similarity… More > Graphic Abstract

Aneel Kumar¹, Mahesh Kumar¹, Amir Mahmood Soomro¹, Laveet Kumar^2,*

Energy Engineering, Vol.121, No.6, pp. 1439-1457, 2024, DOI:10.32604/ee.2024.049977 - 21 May 2024

Abstract Electric vehicles (EVs) are the most interesting and innovative technology in the 21st century because of their enormous advantages, both technically and economically. Their emissions rate compared to fuel-based vehicles is negligible as they do not consume fuel and hence do not emit any harmful gases. However, their bulk production, adoption and lack of charging stations increase the stress of power stations due to modern-day lifestyles. If Electric vehicles demand increases drastically then conventional power stations will not bear their demand and if they generate electricity by conventional means it will be very costly and… More >

Yanqun Yu^1,*, Wenhao Xu¹, Yahui Huangfu¹, Jinhai Liu^1,2, Bensheng Wang¹, Kai Liu¹

Energy Engineering, Vol.121, No.6, pp. 1521-1533, 2024, DOI:10.32604/ee.2024.047986 - 21 May 2024

Abstract China’s unconventional gas fields have a large number of low-productivity and low-efficiency wells, many of which are located in remote and environmentally harsh mountainous areas. To address the long-term stable production of these gas wells, plunger-lift technology plays an important role. In order to fully understand and accurately grasp the drainage and gas production mechanisms of plunger-lift, a mechanical model of plunger-liquid column uplift in the plunger-lift process was established, focusing on conventional plunger-lift systems and representative wellbore configurations in the Linxing region. The operating casing pressure of the plunger-lift process and the calculation method… More >

Guanglu Xie¹, Zhimin Xue¹, Bo Xiong¹, Yaowen Huang¹, Chaoming Chen¹, Qing Liao¹, Cheng Yang^2,*, Xiaoqian Ma²

Energy Engineering, Vol.121, No.6, pp. 1495-1519, 2024, DOI:10.32604/ee.2024.047832 - 21 May 2024

Abstract The determination of source-side extracted heating parameters is of great significance to the economic operation of cogeneration systems. This paper investigated the coupling performance of a cogeneration heating and power system multidimensionally based on the operating characteristics of the cogeneration units, the hydraulic and thermodynamic characteristics of the heating network, and the energy loads. Taking a steam network supported by a gas-steam combined cycle cogeneration system as the research case, the interaction effect among the source-side prime movers, the heating networks, and the terminal demand thermal parameters were investigated based on the designed values, the… More >