Zihan Qi^*

Energy Engineering, Vol.120, No.11, pp. 2547-2563, 2023, DOI:10.32604/ee.2023.027045 - 31 October 2023

Abstract A novel operation control method for relay protection in flexible DC distribution networks with distributed power supply is proposed to address the issue of inaccurate fault location during relay protection, leading to poor performance. The method combines a fault-tolerant fault location method based on long-term and short-term memory networks to accurately locate the fault section. Then, an operation control method for relay protection based on adaptive weight and whale optimization algorithm (WOA) is used to construct an objective function considering the shortest relay protection action time and the smallest impulse current. The adaptive weight and More >

Ying Zhang¹, Xiaoqing Han², Chao Zhang¹, Ying Qu¹, Yang Liu¹, Gengwu Zhang^2,*

Energy Engineering, Vol.120, No.11, pp. 2585-2609, 2023, DOI:10.32604/ee.2023.026816 - 31 October 2023

Abstract More and more uncertain factors in power systems and more and more complex operation modes of power systems put forward higher requirements for online transient stability assessment methods. The traditional model-driven methods have clear physical mechanisms and reliable evaluation results but the calculation process is time-consuming, while the data-driven methods have the strong fitting ability and fast calculation speed but the evaluation results lack interpretation. Therefore, it is a future development trend of transient stability assessment methods to combine these two kinds of methods. In this paper, the rate of change of the kinetic energy… More >

Louis F. Marie^*, Karina Sałek, Tadhg S. O’Donovan

Energy Engineering, Vol.120, No.10, pp. 2193-2209, 2023, DOI:10.32604/ee.2023.043075 - 28 September 2023

Abstract Composite thermochemical energy storage (TCES) represents an exciting field of thermal energy storage which could address the issue of seasonal variance in renewable energy supply. However, there are open questions about their performance and the root cause of some observed phenomena. Some researchers have observed the breakdown of particles in their production phase, and in their use. This study seeks to investigate the underlying cause of this breakdown. SEM and EDX analysis have been conducted on MgCl₂ impregnated 13X zeolite composites of differing diameters, as well as LiX zeolite. This was done in order to study… More > Graphic Abstract

Song Wang^1,*, Fei Xie¹, Fengye Yang¹, Shengxuan Qiu¹, Chuang Liu², Tong Li³

Energy Engineering, Vol.120, No.10, pp. 2273-2285, 2023, DOI:10.32604/ee.2023.030107 - 28 September 2023

Abstract Winding is one of the most important components in power transformers. Ensuring the health state of the winding is of great importance to the stable operation of the power system. To efficiently and accurately diagnose the disc space variation (DSV) fault degree of transformer winding, this paper presents a diagnostic method of winding fault based on the K-Nearest Neighbor (KNN) algorithm and the frequency response analysis (FRA) method. First, a laboratory winding model is used, and DSV faults with four different degrees are achieved by changing disc space of the discs in the winding. Then,… More > Graphic Abstract

Wenzhe Guo¹, Leian Zhang^1,*, Chao Lv², Weisheng Liu³, Jiabin Tian²

Energy Engineering, Vol.120, No.10, pp. 2307-2323, 2023, DOI:10.32604/ee.2023.030029 - 28 September 2023

Abstract Aiming at the drift problem that the tracking control of the actual load relative to the target load during the electromagnetic excitation biaxial fatigue test of wind turbine blades is easy to drift, a biaxial fatigue testing machine for electromagnetic excitation is designed, and the following strategy of the actual load and the target load is studied. A Fast Transversal Recursive Least Squares algorithm based on fuzzy logic (Fuzzy FTRLS) is proposed to develop a fatigue loading following dynamic strategy, which adjusts the forgetting factor in the algorithm through fuzzy logic to overcome the contradiction More >

Yongxin Liu¹, Huaiwei Cao², Puyu Zhao², Gang Yang¹, Hua Yu¹, Fuwei He³, Bo He^2,*

Energy Engineering, Vol.120, No.10, pp. 2417-2431, 2023, DOI:10.32604/ee.2023.029596 - 28 September 2023

Abstract When using high-voltage transmission lines for energy transmission in loess hilly regions, local extreme wind fields such as turbulence and high-speed cyclones occur from time to time, which can cause many kinds of mechanical and electrical failures, seriously affecting the reliable and stable energy transmission of the power grid. The existing research focuses on the wind field simulation of ideal micro-terrain and actual terrain with mostly single micro-terrain characteristics. Model boundary constraints and the influence of constrained boundaries are the main problems that need to be solved to accurately model and simulate complex flow fields.… More >

Huiru Zhao¹, Manyu Yao^1,*, Zhenqi Bai¹, Yue Zhang², Zhihua Ding³, Zhenda Hu⁴

Energy Engineering, Vol.120, No.10, pp. 2211-2231, 2023, DOI:10.32604/ee.2023.029371 - 28 September 2023

Abstract As an essential infrastructure, the rural power grid is vital in promoting agricultural and rural carbon sequestration and improving rural energy electrification. It is necessary to carry out in-depth research on its comprehensive efficiency. Based on the requirements of “double carbon” and rural revitalization strategy for the rural Power Grid, this paper focuses on the modernization and low-carbon transformation of the rural Power Grid. It constructs an input-output index system for the investment efficiency of the rural Power Grid in China under the new situation. It uses the primary data of the rural Power Grid… More >

Hongyu Mu^1,2,*, Yinyan Wang¹, Chuanlei Yang¹, Hong Teng², Xingtian Zhao², Hongquan Lu², Dechun Wang², Shiyang Hao², Xiaolong Zhang², Yan Jin²

Energy Engineering, Vol.120, No.10, pp. 2325-2342, 2023, DOI:10.32604/ee.2023.029360 - 28 September 2023

Abstract New energy vehicles have better clean and environmental protection characteristics than traditional fuel vehicles. The new energy engine cooling technology is critical in the design of new energy vehicles. This paper used one-and three-way joint simulation methods to simulate the refrigeration system of new energy vehicles. Firstly, a k-ε turbulent flow model for the cooling pump flow field is established based on the principle of computational fluid dynamics. Then, the CFD commercial fluid analysis software FLUENT is used to simulate the flow field of the cooling pump under different inlet flow conditions. This paper proposes More > Graphic Abstract

Deng Lu¹, Xujun Lang¹, Bo Yang¹, Ziyang Li¹, Hang Geng^2,*

Energy Engineering, Vol.120, No.10, pp. 2287-2306, 2023, DOI:10.32604/ee.2023.029140 - 28 September 2023

Abstract The four-circuit parallel line on the same tower effectively solves the problems faced by the line reconstruction and construction under the condition of the increasing shortage of transmission corridors. Optimizing the conductor and phase sequence arrangement of multiple transmission lines is conducive to improving electromagnetic and electrostatic coupling caused by electromagnetic problems. This paper uses the ATP-EMTP simulation software to build a 500 kV multi-circuit transmission line on the same tower. It stimulates the induced voltage and current values of different line lengths, tower spacing, vertical and horizontal spacing between different circuits, phase sequence arrangement,… More >

He Wang¹, Xiangsheng Xu¹, Guanye Shen², Bian Jing^1,*

Energy Engineering, Vol.120, No.10, pp. 2251-2272, 2023, DOI:10.32604/ee.2023.028965 - 28 September 2023

Abstract There are issues with flexible DC transmission system such as a lack of control freedom over power flow. In order to tackle these issues, a DC power flow controller (DCPFC) is incorporated into a multi-terminal, flexible DC power grid. In recent years, a multi-port DC power flow controller based on a modular multi-level converter has become a focal point of research due to its simple structure and robust scalability. This work proposes a model predictive control (MPC) strategy for multi-port interline DC power flow controllers in order to improve their steady-state dynamic performance. Initially, the… More >