Mohammad Monirujjaman Khan^1,*, Bright Yeboah-Akowuah², Kaisarul Islam¹, Eric Tutu Tchao², Sumanta Bhattacharyya³, Rajesh Dey⁴, Mehedi Masud⁵, Fahad Alraddady⁶

Computer Systems Science and Engineering, Vol.42, No.3, pp. 1079-1093, 2022, DOI:10.32604/csse.2022.022313

Abstract This research presents an ultra-wideband (UWB) textile antenna design for body-centric applications. The antenna is printed on a 1 mm thick denim substrate with a 1.7 relative permittivity. The jeans substrate is sandwiched between a partial ground plane and a radiating patch with a Q-shaped slot. The slotted radiating patch is placed above the substrate and measures 27.8 mm × 23.8 mm. In free space, the antenna covers the ultra-wideband spectrum designated by the Federal Communication Commission (FCC). Various parameters of the antenna design were changed for further performance evaluation. Depending on the operating frequency, the antenna's realized gain varied from 2.7 to 5 dB. The… More >

Suwat Sakulchat¹, Amnoiy Ruengwaree^1,*, Voranuch Thongpool², Watcharaphon Naktong³

CMC-Computers, Materials & Continua, Vol.71, No.3, pp. 6069-6088, 2022, DOI:10.32604/cmc.2022.024050

Abstract This research investigates a monopole patch antenna for Wi-Fi applications at 2.45 and 5.2 GHz, and WiMax at 3.5 GHz. A low-cost and flexible graphite sheet with good conductivity, base on graphite conductive powder and glue is used to create a radiator patch and ground plane. Instead of commercially available conductive inks or graphite sheets, we use our self-produced graphite liquid to create the graphite sheet because it is easy to produce and inexpensive. The antenna structure is formed using a low-cost and easy hand-screen printing approach that involved placing graphite liquid on a bendable polyester substrate. This research focuses… More >

El-Sayed M. El-kenawy^1,2, Abdelhameed Ibrahim^3,*, Seyedali Mirjalili^4,5, Yu-Dong Zhang⁶, Shaima Elnazer^7,8, Rokaia M. Zaki^9,10

CMC-Computers, Materials & Continua, Vol.71, No.3, pp. 4989-5003, 2022, DOI:10.32604/cmc.2022.023884

Abstract Metamaterial Antenna is a subclass of antennas that makes use of metamaterial to improve performance. Metamaterial antennas can overcome the bandwidth constraint associated with tiny antennas. Machine learning is receiving a lot of interest in optimizing solutions in a variety of areas. Machine learning methods are already a significant component of ongoing research and are anticipated to play a critical role in today's technology. The accuracy of the forecast is mostly determined by the model used. The purpose of this article is to provide an optimal ensemble model for predicting the bandwidth and gain of the Metamaterial Antenna. Support Vector… More >

Prach Asavanarakul, Amnoiy Ruengwaree^*, Suwat Sakulchat

CMC-Computers, Materials & Continua, Vol.71, No.3, pp. 4737-4748, 2022, DOI:10.32604/cmc.2022.023743

Abstract Globalization has opened practically every country in the globe to tourism and commerce today. In every region, the volume of vehicles traveling through border crossings has increased significantly. Smartcards and radio frequency identification (RFID) have been proposed as a new method of identifying and authenticating passengers, products, and vehicles. However, the usage of smartcards and RFID tag cards for vehicular border crossings continues to suffer security and flexibility challenges. Providing a vehicle's driver a smartcard or RFID tag card may result in theft, loss, counterfeit, imitation, or vehicle transmutation. RFID sticker tags would replace RFID tags as vehicle border passes… More >

Iqra Aitbar¹, Nosherwan Shoaib^1,*, Akram Alomainy², Abdul Quddious³, Symeon Nikolaou⁴, Muhammad Ali Imran⁵, Qammer H. Abbasi⁵

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 3227-3241, 2022, DOI:10.32604/cmc.2022.023008

Abstract In this paper, a compact, efficient and easy to fabricate wearable antenna integrated with Artificial Magnetic Conductor (AMC) is presented. Addition of slots and bevels/cuts in the rectangular monopole patch antenna yield a wide bandwidth along with band notches. The proposed antenna is backed with an AMC metasurface that changes the bidirectional radiation pattern to a unidirectional, thus, considerably reducing the Specific Absorption Ratio (SAR). The demonstrated antenna has a good coverage radiating away from the body and presents reduced radiation towards the body with a front-to-back ratio of 13 dB and maximum gain of 3.54 dB. The proposed design… More >

Md. Mushfiqur Rahman^1,*, Md. Shabiul Islam¹, Mohammad Tariqul Islam², Samir Salem Al-Bawri³, Wong Hin Yong¹

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 2383-2399, 2022, DOI:10.32604/cmc.2022.022150

Abstract In this paper, a unit cell of a single-negative metamaterial structure loaded with a meander line and defected ground structure (DGS) is investigated as the principle radiating element of an antenna. The unit cell antenna causes even or odd mode resonances similar to the unit cell structure depending on the orientation of the microstrip feed used to excite the unit cell. However, the orientation which gives low-frequency resonance is considered here. The unit cell antenna is then loaded with a meander line which is parallel to the split bearing side and connects the other two sides orthogonal to the split… More >

Md. Amanath Ullah¹, Touhidul Alam^2,3, Ali F. Almutairi^4,*, Mohammad Tariqul Islam⁵

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 2533-2542, 2022, DOI:10.32604/cmc.2022.021852

Abstract This paper reveals a new design of UHF CubeSat antenna based on a modified Planar Inverted F Antenna (PIFA) for CubeSat communication. The design utilizes a CubeSat face as the ground plane. There is a gap of 5 mm beneath the radiating element that facilitates the design providing with space for solar panels. The prototype is fabricated using Aluminum metal sheet and measured. The antenna achieved resonance at 419 MHz. Response of the antenna has been investigated after placing a solar panel. Lossy properties of solar panels made the resonance shift about 20 MHz. This design addresses the frequency shifting… More >

Farhad Bin Ashraf¹, Touhidul Alam^2,*, Md Tarikul Islam³, Mandeep Jit Singh³, Norbahiah Binti Misran³, Mohammad Tariqul Islam³

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 2271-2284, 2022, DOI:10.32604/cmc.2022.021751

Abstract In this paper, the design and performance analysis of an Inkjet-printed metamaterial loaded monopole antenna is presented for wireless local area network (WLAN) and worldwide interoperability for microwave access (WiMAX) applications. The proposed metamaterial structure consists of two layers, one is rectangular tuning fork-shaped antenna, and another layer is an inkjet-printed metamaterial superstate. The metamaterial layer is designed using four split-ring resonators (SRR) with an H-shaped inner structure to achieve negative-index metamaterial properties. The metamaterial structure is fabricated on low-cost photo paper substrate material using a conductive ink-based inkjet printing technique, which achieved dual negative refractive index bands of 2.25–4.25… More >

Siti Julia Rosli^1,2, Hasliza A Rahim^1,2,*, Khairul Najmy Abdul Rani^1,2, Ruzelita Ngadiran^2,3, Wan Azani Mustafa^3,4, Muzammil Jusoh^1,2, Mohd Najib Mohd Yasin^1,2, Thennarasan Sabapathy^1,2, Mohamedfareq Abdulmalek⁵, Wan Suryani Firuz Wan Ariffin², Ahmed Alkhayyat⁶

CMC-Computers, Materials & Continua, Vol.71, No.2, pp. 3533-3556, 2022, DOI:10.32604/cmc.2022.021719

Abstract The essential purpose of radar is to detect a target of interest and provide information concerning the target's location, motion, size, and other parameters. The knowledge about the pulse trains’ properties shows that a class of signals is mainly well suited to digital processing of increasing practical importance. A low autocorrelation binary sequence (LABS) is a complex combinatorial problem. The main problems of LABS are low Merit Factor (MF) and shorter length sequences. Besides, the maximum possible MF equals 12.3248 as infinity length is unable to be achieved. Therefore, this study implemented two techniques to propose a new metaheuristic algorithm… More >

Wei Shen¹, Sen Wang¹, Xuanxiang Zhao², Haotian Zhang², Shuo Cao³, Lijian Zhang², Hao Yang^2,*, Xixiang Wang⁴, Lei Lei⁴

Energy Engineering, Vol.119, No.1, pp. 371-385, 2022, DOI:10.32604/EE.2022.016141

Abstract In gas insulation switch (GIS) substation, secondary devices such as line monitoring devices are placed in the switching field, and these electronic devices are vulnerable to transient electromagnetic interference caused by switching operation. In order to facilitate the measurement and research of electromagnetic disturbance data under different working conditions, a simulation test device is developed in this paper, which can be used to simulate electromagnetic disturbance of GIS substation sensor and secondary device port under switch operation. A four-channel parallel gas switch was designed, and the main characteristic parameters of electromagnetic disturbance generated by the simulation device were measured by… More >