Chyanbin Hwu¹, T.L. Kuo, Y.C. Chen

CMC-Computers, Materials & Continua, Vol.11, No.3, pp. 165-184, 2009, DOI:10.3970/cmc.2009.011.165

Abstract In this paper the near tip solutions for interface corners written in terms of the stress intensity factors are presented in a unified expression. This single expression is applicable for any kinds of interface corners including corners and cracks in homogeneous materials as well as interface corners and interface cracks lying between two dissimilar materials, in which the materials can be any kinds of linear elastic anisotropic materials or piezoelectric materials. Through this unified expression of near tip solutions, the singular orders of stresses and their associated stress/electric intensity factors for different kinds of interface problems can be determined through… More >

Chien-Ching Ma^1,2, Wen-Cha Wu²

CMC-Computers, Materials & Continua, Vol.11, No.2, pp. 79-108, 2009, DOI:10.3970/cmc.2009.011.079

Abstract The two-dimensional problem of a planar transversely isotropic piezoelectric layered half-plane subjected to generalized line forces and edge dislocations in the layer is analyzed by using the Fourier-transform method and the series expansion technique. The full-field solutions for displacements, stresses, electrical displacements and electric fields are expressed in explicit closed forms. The complete solutions consist only of the simplest solutions for an infinite piezoelectric medium with applied loadings. It is shown in this study that the physical meaning of this solution is the image method. The explicit solutions include Green's function for originally applied loadings in an infinite piezoelectric medium… More >

Deepak A Apte¹, Ranjan Ganguli^1,2

CMC-Computers, Materials & Continua, Vol.10, No.2, pp. 139-162, 2009, DOI:10.3970/cmc.2009.010.139

Abstract The influence of electric field and temperature on power consumption of piezoelectric actuated integrated structure is studied by using a single degree of freedom mass-spring-damper system model coupled with a piezoactuator. The material lead zirconate titanate, is considered as it is capable of producing relatively high strains (e.g., 3000με). Actuators are often subject to high electric fields to increase the induced strain produced, resulting in field dependant piezoelectric coefficient d₃₁, dielectric coefficient ε₃₃ and dissipation factor δ. Piezostructures are also likely to be used across a wide range of temperatures in aerospace and undersea operations. Again, the piezoelectric properties can… More >

C. H. Cheng¹, S. C. Chen²

CMC-Computers, Materials & Continua, Vol.1, No.3, pp. 205-212, 2004, DOI:10.3970/cmc.2004.001.205

Abstract A shear mode piezoelectric actuator is applied to deflect the diaphragm of pressure chamber in the droplet ejector or inkjet printhead. The deflection of the bulge-diaphragm and resulting swept volume is analyzed by analytical and numerical method. With free-body treatment of the model, the analytical exact solutions for the two free bodies of bulge-diaphragm and piezoelectric beam were obtained. Also, the numerical solution by ANSYS is obtained to verify the analytical result. Besides, the whole-model solution coupling the bulge-diaphragm and piezoelectric beam together was obtained by ANSYS to compare with the result of free-body analysis. In order to estimate the… More >