Calvin Hong Li^a, G. P. Peterson^b,*

Frontiers in Heat and Mass Transfer, Vol.1, No.2, pp. 1-10, 2010, DOI:10.5098/hmt.v1.2.3007

Abstract An experimental investigation of the Critical Heat Flux (CHF) and heat transfer coefficient (HTC) of two-phase heat transfer of de-Ionized (DI) water, pool boiling was conducted using several kinds of sintered copper microparticle porous uniform and modulated structures. The modulated porous structure reached a heat flux of 450 W/cm² and a heat transfer coefficient of 230,000 W/m2K. The thick and thin uniform porous structures achieved CHFs of 290 W/cm² and 227 W/cm² , respectively, and heat transfer coefficients of 118,000 W/m²K and 104,000 W/m²K. The mechanisms for the dramatically improved CHFs and HTCs were identified with assistance of a visualization… More >

N. Gnanasekaran, C. Balaji^*

Frontiers in Heat and Mass Transfer, Vol.2, No.2, pp. 1-6, 2011, DOI:10.5098/hmt.v2.2.3008

Abstract This paper reports the results of an experimental investigation of transient, turbulent mixed convection in a vertical channel in which one of the walls is heated and the other is adiabatic. The goal is to simultaneously estimate the constants in a Nusselt number correlation whose form is assumed a priori by synergistically marrying the experimental results with repeated numerical calculations that assume guess values of the constants. The convective heat transfer coefficient “h”is replaced by the Nusselt number (Nu) and the constants in the Nusselt number are to be evaluated. From the experimentally obtained temperature time history and the simulated… More >

H.E. Dillon, A.F. Emery^†, A.M. Mescher, O. Sprenger, S.R. Edwards

Frontiers in Heat and Mass Transfer, Vol.2, No.2, pp. 1-14, 2011, DOI:10.5098/hmt.v2.2.3002

Abstract The stability of free convection in an annulus is governed by the boundary conditions on the inner and outer walls of the annulus and the upper and lower boundaries. This paper explores the effect of free convection on the inner surface of the annulus, where the boundary conditions for the outer wall and the upper and lower boundaries are controlled. The temperature is measured in the center of the air cavity and just below the surface of the inner annular boundary. Experimental results are shown for a radius ratio of 0.40, aspect ratio of 20.7. These more recent experimental results… More >

Rajesh Kumar Panda, B.V.S.S.S. Prasad^*

Frontiers in Heat and Mass Transfer, Vol.2, No.1, pp. 1-10, 2011, DOI:10.5098/hmt.v2.1.3008

Abstract Conjugate heat transfer from a flat circular disk is investigated both computationally and experimentally with a constant heat flux imposed on its bottom surface and a shower head of air jets impinging on the top surface. The shower head consists of a central jet surrounded by four neighboring perimeter jets. Measured temperature data at twelve locations within the plate are compared with the conjugate heat transfer result obtained at the same locations computationally by Shear Stress Transport (SST) κ-ω turbulence model. The spacing to orifice diameter ratio (H/d = 1 to 4), the jet Reynolds number (7115 to 10674) and… More >

YANAN MA¹, SHANSHAN WANG^2,*, HUIGUO DING^1,*

BIOCELL, Vol.48, No.3, pp. 463-471, 2024, DOI:10.32604/biocell.2024.048244

Abstract Background: Hepatocellular carcinoma (HCC) is a common malignant tumor with poor prognosis and high mortality worldwide. Although cystathionine-gamma-lyase (CSE) plays an important role in the development of multiple tumors, the clinical implication and potential mechanisms of CSE in HCC development remain elusive. Methods: In our study, the CSE expression in HCC was analyzed in Gene Expression Omnibus (GEO) and The Cancer Genome Atlas (TCGA) datasets and further confirmed by RT-qPCR and immunohistochemistry assays in HCC samples. Furthermore, the associations between CSE expression and HCC malignancy as well as survival were analyzed in GSE14520 and validated in HCC patients. Finally, the… More >

PEI QIN^#, MIAO LIU^#, XIN WANG, JIANHUA MA^*

BIOCELL, Vol.48, No.3, pp. 513-523, 2024, DOI:10.32604/biocell.2023.045640

Abstract Background: L-dopa (Levodopa) is well known for managing PD (Parkinson’s disease); however, its prolonged use caused dyskinesia (LID). Due to the varied presentation of LID, effective treatment options are scarce. Flavonoids reported their neuroprotective activity by ameliorating acetylcholinesterase, monoamine oxidase, and neuroinflammation. Kaempferol is another flavonoid bearing these potentials. Aim: To evaluate neuroprotective activity of kaempferol in dyskinetic rats. Methods: PD was developed in Sprague-Dawley rats by injecting combination of L-ascorbic acid (10 µL) + 6-OHDA (12 µg) in medial forebrain bundle to induce neuronal damage in substantial nigra (SNr). LID was induced by administrating combination of L-dopa (20 mg/kg)… More > Graphic Abstract

Nikola Stosic^**, Ian K. Smith, Ahmed Kovacevic

Frontiers in Heat and Mass Transfer, Vol.3, No.2, pp. 1-7, 2012, DOI:10.5098/hmt.v3.2.3003

Abstract Due to fast rotation of screw compressor rotors, temperature is uniform in the rotor cross section and temperature field is a function of the axial coordinate only. Apart of that the rotors in one cross section the rotors are simultaneously heated by hot gas on one side while cooled at another side by cold gas. As a result of identification of the main modes of heat transfer both in the rotors and between the rotors and their surroundings and the relative significance of each, a novel procedure is suggested to cool the rotors by injection of minute quantities of a… More >

Frantisek Kavicka^a,*, Jana Dobrovska^b, Karel Stransky^a, Bohumil Sekanina^a, Josef Stetina^a

Frontiers in Heat and Mass Transfer, Vol.3, No.2, pp. 1-9, 2012, DOI:10.5098/hmt.v3.2.3002

Abstract Corundo-baddeleyit material (CBM) – EUCOR – is a heat- and wear-resistant material even at extreme temperatures. This article introduces an original numerical model of solidification and cooling of this material in a non-metallic mold. The second, cooperating model of chemical heterogeneity and its application on EUCOR samples prove that the applied method of measuring the chemical heterogeneity provides the detailed quantitative information on the material structure and makes it possible to analyze the solidification process. The verification of both numerical models was conducted on a real cast 350 x 200 x 400 mm block. More >

Milind S. Patil^a,*, Ramchandra S. Jahagirdar^b, Eknath R. Deore^a,†

Frontiers in Heat and Mass Transfer, Vol.3, No.3, pp. 1-5, 2012, DOI:10.5098/hmt.v3.3.3008

Abstract Convection heat loss inevitably occurs in receivers of high concentrating solar concentrators. All the concentrators are need to be tack during the operation and hence the position of the receiver is changing continually. The angle of the receiver axis will then play an important role in the heat loss. Few researches were reported for the hemispherical cavity receivers numerically. The paper presented here is an experimental investigation natural convection heat loss from hemispherical cavity receiver. Cavity receiver of diameter 540 mm was tested. It is observed that the heat loss was minimum for 90° and maximum for 0°. More >

Mohammad Izadifar^a,b,*, Xiongbiao Chen^a,b

Frontiers in Heat and Mass Transfer, Vol.3, No.4, pp. 1-7, 2012, DOI:10.5098/hmt.v3.4.3004

Abstract Heat can be potentially used for accelerating biodegradation of implanted tissue engineered scaffolds. Cyclic and continuous radio frequency (RF) heating was applied to implanted chitosan and alginate scaffolds at 4 applied voltages, 3 frequencies, and 2 thermally conditioning environments. A 3D finite element model was developed to simulate the RF treatment. A uniform RF heating was achieved at the scaffold top. For alginate, voltage was the only significant RF heating factor while both frequency and voltage significantly affected RF heating of chitosan. Less temperature gradient across the scaffold was achieved at a conditioning environment at <30°C. Surrounding tissue was insignificantly… More >