Qiping Chen¹, Yu Liu¹, Liping Zeng¹, Qiang Xiao¹, Conghui Zhou¹, Sheng Kang¹

FDMP-Fluid Dynamics & Materials Processing, Vol.14, No.4, pp. 281-291, 2018, DOI:10.32604/fdmp.2018.03721

Abstract The brake-by-wire system requirement is promoted owing to the development of green energy vehicle, and the brake pressure control method is needed. A control method for the master cylinder hydraulic pressure based on the sliding mode control approach is proposed to provide the Electro-Hydraulic Brake system (EHB) of electric vehicles with superior system performances. An assessment is carried out about the complex nonlinear characteristics and sensitivity to the external environment of these systems, which include illustrating the working principle of the EHB system, establishing the dynamic models of the key components of the EHB system. The sliding mode control method… More >

Y.H. Liu¹, X.X. Xue², J.M.Shen¹

FDMP-Fluid Dynamics & Materials Processing, Vol.11, No.2, pp. 197-204, 2015, DOI:10.3970/fdmp.2015.011.195

Abstract Blends of Polyethylene (PE) and modified-oil shale ash (MOSA) with different fractions of MOSA were prepared by the melting blend method. The effects of MOSA content on the rheological and mechanical properties of the blend were properly assessed via direct experimental analysis (more precisely, all rheological measurements were performed using a laboratory-scale XSS-300 torque rheometer with single screw extruder; the temperatures were maintained at 170°C, 180°C and 190°C under continuous extrusion). The prepared samples were observed to display a shear-thinning behaviour. Moreover, with increasing the MOSA content, we found the yield strength of the blends to increase, while its elongation… More >

Mohsen Ghorbani¹, Hossein Eisazadeh²

FDMP-Fluid Dynamics & Materials Processing, Vol.6, No.2, pp. 153-164, 2010, DOI:10.3970/fdmp.2010.006.153

Abstract Polypyrrole/Poly(vinyl acetate) (PPy/PVAc) copolymer was prepared by the copolymerization of vinyl acetate and pyrrole using FeCl3and benzoylperoxide as an oxidant in the presence of various surfactants such as sodium dodecylbenzenesulfonate and poly(ethylene glycol) in the aqueous/non-aqueous media. The PPy/PVAc copolymer was characterized in terms of conductivity, morphology, chemical structure, particle size and yield. The results indicate that the morphology, particle size, yield and electrical conductivity of the products are dependent on the type of surfactant and the arrangement of monomer injection. The chemical structure of obtained product was determined by FTIR spectroscopy. By comparison FTIR spectra between pure PPy and… More >

Marcello Lappa¹

FDMP-Fluid Dynamics & Materials Processing, Vol.2, No.2, pp. 141-152, 2006, DOI:10.3970/fdmp.2006.002.141

Abstract Numerical simulations and computer-graphics animation can be used as useful tools to discern the physicochemical environmental factors affecting the surface kinetics of growing biological tissues as well as their relative importance in determining growth. A mathematical formalism for such kinetics is proposed through parametric investigation and validated through focused comparison with experimental results. The study relies on the application of a CFD moving boundary (Volume of Fluid) method specially conceived for the simulation of these problems. In the second part of the analysis the case of two samples hydrodynamically interacting in a rotating bioreactor is considered. The interplay between two… More >

K. Matsunaga¹, H. Kawamura¹

FDMP-Fluid Dynamics & Materials Processing, Vol.2, No.1, pp. 59-64, 2006, DOI:10.3970/fdmp.2006.002.059

Abstract Existing studies on solidification phenomena mainly focused on the solidification processes per se. In real systems, however, one cannot neglect the effects of molten material convective flow, such as natural and thermocapillary convection (they strongly affect the resulting quality of the solidified materials). The present study aims to experimentally investigate on the effect of the thermocapillary flow upon the directional solidification in a liquid layer with a free upper surface. If no free surface exists, the solid--liquid interface (SLI) is vertical and straight, while, with the free surface, the SLI is inclined against the wall-normal direction and is curved in… More >

N.I. Wakayama¹, D.C. Yin², J.W. Qi³

FDMP-Fluid Dynamics & Materials Processing, Vol.1, No.2, pp. 153-170, 2005, DOI:10.3970/fdmp.2005.001.153

Abstract The production of crystals of adequate size and high quality is the "bottleneck'' for three-dimensional structure analysis of protein crystals. In this work, in order to shed additional light on the (still controversial) beneficial effect of microgravity on crystal growth, we focus on recent advanced experimental and theoretical research about the effects of buoyancy-driven convection on protein crystallization. In the light of the numerical studies the following major outcomes can be highlighted: (1) when the crystal size exceeds several dozens of µm, buoyancy-driven convection dominates solute transport near the growing crystal and the crystal growth rate becomes larger than that… More >

Hsien-Chie Cheng^1,2, Chien-Hao Ma¹, Ching-Feng Yu³, Su-Tsai Lu⁴, Wen-Hwa Chen^2,3

CMC-Computers, Materials & Continua, Vol.38, No.3, pp. 129-154, 2013, DOI:10.3970/cmc.2013.038.129

Abstract User experiences for electronic devices with high portability and flexibility, good intuitive human interfaces and low cost have driven the development of semiconductor technology toward flexible electronics and display. In this study proposes, an advanced flexible interconnect technology is proposed for flexible electronics, in which an ultra-thin IC chip having a great number of micro-bumps is bonded onto a very thin flex substrate using an epoxy-based anisotropic conductive film (ACF) to form fine-pitch and reliable interconnects or joints (herein termed ACF-typed thin-flip-chip-on-flex (TFCOF) technology). The electrical and thermal -mechanical performances of the micro-joints are the key to the feasibility and… More >

H. Jiang^1,2, B. Yang¹, S. Liu³

CMC-Computers, Materials & Continua, Vol.38, No.2, pp. 61-77, 2013, DOI:10.3970/cmc.2013.038.061

Abstract Actin, fibrin and collagen fiber networks are typical hierarchical biological materials formed by bundling fibrils into fibers and branching/adjoining fibers into networks. The bundled fibrils interact with each other through weak van der Waals forces and, in some cases, additional spotted covalent crosslinks. In the present work, we apply Timoshenko's beam theory that takes into account the effect of transverse shear between fibrils in each bundle to study the overall mechanical behaviors of such fiber networks. Previous experimental studies suggested that these fibers are initially loose bundles. Based on the evidence, it is hypothesized that the fibers undergo transitions from… More >

E.J. Sapountzakis¹, G.C. Tsiatas²

CMC-Computers, Materials & Continua, Vol.6, No.2, pp. 103-116, 2007, DOI:10.3970/cmc.2007.006.103

Abstract In this paper the general flexural-torsional buckling and vibration problems of composite Euler-Bernoulli beams of arbitrarily shaped cross section are solved using a boundary element method. The general character of the proposed method is verified from the formulation of all basic equations with respect to an arbitrary coordinate system, which is not restricted to the principal one. The composite beam consists of materials in contact each of which can surround a finite number of inclusions. It is subjected to a compressive centrally applied load together with arbitrarily transverse and/or torsional distributed or concentrated loading, while its edges are restrained by… More >

Dun Li¹, Hong Wu¹, Jinzhu Gao², Zhuoyun Liu¹, Lun Li¹, Zhiyun Zheng^1,*

CMC-Computers, Materials & Continua, Vol.61, No.1, pp. 301-321, 2019, DOI:10.32604/cmc.2019.05953

Abstract With the rapid development of the semantic web and the ever-growing size of uncertain data, representing and reasoning uncertain information has become a great challenge for the semantic web application developers. In this paper, we present a novel reasoning framework based on the representation of fuzzy PR-OWL. Firstly, the paper gives an overview of the previous research work on uncertainty knowledge representation and reasoning, incorporates Ontology into the fuzzy Multi Entity Bayesian Networks theory, and introduces fuzzy PR-OWL, an Ontology language based on OWL2. Fuzzy PR-OWL describes fuzzy semantics and uncertain relations and gives grammatical definition and semantic interpretation. Secondly,… More >