Qunfeng Liu¹, gping Shen²

CMC-Computers, Materials & Continua, Vol.17, No.1, pp. 59-76, 2010, DOI:10.3970/cmc.2010.017.059

Abstract Molecular Dynamics (MD) simulations have been performed using the EAM potential to investigate the deformation behaviors and mechanical properties of <100>/{100} gold nanowires with square cross-section at a certain strain rate under different temperatures ranging from 10 K to 700 K. It is found that <100>/{100} gold nanowires at high temperatures tend to form the extended stable nanobridges-Helical Multi-shell Structure (HMS), which is similar to the deformation behavior of <110> gold nanowires at room temperature reported in the previous experimental observations and simulations. The effect of temperature on the mechanical properties and deformation behaviors of gold nanowires was analyzed. The… More >

Lei Bao^1,2, Christophe Schuman¹, Jean-sébastien Lecomte¹, Marie-Jeanne Philippe¹, Xiang Zhao², Liang Zuo², Claude Esling¹

CMC-Computers, Materials & Continua, Vol.15, No.2, pp. 113-128, 2010, DOI:10.3970/cmc.2010.015.113

Abstract The mechanisms of small plastic deformation of titanium (T40) during cold rolling and channel die compression by means of "interrupted in situ" EBSD orientation measurements were studied. These interrupted EBSD orientation measurements allow to determine the rotation flow field which leads to the development of the crystallographic texture during the plastic deformation. Results show that during rolling, tension twins and compression twins occur and various glide systems are activated, the number of grains being larger with twins than with slip traces. In channel die compression, only tension twins are observed in some grains, whereas slip traces can be spotted in… More >

Oliver K. Johnson¹, Calvin J. Gardner¹, David T. Fullwood¹, Brent L.Adams¹, Nathan Hansen², George Hansen²

CMC-Computers, Materials & Continua, Vol.15, No.2, pp. 87-112, 2010, DOI:10.3970/cmc.2010.015.087

Abstract A novel nickel nanostrand-silicone composite material at an optimized 15 vol% filler concentration demonstrates a dramatic piezoresistive effect with a negative gauge factor (ratio of percent change in resistivity to strain). The composite volume resistivity decreases in excess of three orders of magnitude at a 60% strain. The piezoresistivity does decrease slightly as a function of cycles, but not significantly as a function of time. The material's resistivity is also temperature dependent, once again with a negative dependence.
The evidence indicates that nickel strands are physically separated by matrix material even at high volume fractions, and points to a charge… More >

C.M. Hefferan¹, S.F. Li¹, J. Lind¹, U. Lienert², A.D. Rollett³, P. Wynblatt³, R.M. Suter^1,3

CMC-Computers, Materials & Continua, Vol.14, No.3, pp. 209-220, 2009, DOI:10.3970/cmc.2009.014.209

Abstract We have measured and reconstructed via forward modeling a small volume of microstructure of high purity, well annealed nickel using high energy x-ray diffraction microscopy (HEDM). Statistical distributions characterizing grain orientations, intra-granular misorientations, and nearest neighbor grain misorientations are extracted. Results are consistent with recent electron backscatter diffraction measurements. Peaks in the grain neighbor misorientation angle distribution at 60 degrees (∑3) and 39 degrees (∑9) have resolution limited widths of ≈ 0.14 degree FWHM. The analysis demonstrates that HEDM can recover grain and grain boundary statistics comparable to OIM volume measurements; more extensive data sets will lead to full, five… More >