Yasushi Koito^1,*, Shoma Hitotsuya², Takamitsu Takayama², Kenta Hashimoto²

Frontiers in Heat and Mass Transfer, Vol.21, pp. 33-46, 2023, DOI:10.32604/fhmt.2023.041829

Abstract An ultra-thin flattened heat pipe has been developed with a centered wick structure. This structure is essential to make the heat pipe thinner. However, the centered wick structure reduces the evaporation and condensation surface areas of the wick structure because it is sandwiched between heat pipe walls. In this study, because detailed discussion has not been made, heat transfer experiments were conducted for the wick structure sandwiched between two solid walls. This study focused on the evaporation heat transfer characteristics from the sandwiched wick structure. The experiments were conducted with three wick structures, that is, strip-shaped sintered copper powders with… More >

Mohammad Yaghoub Abdollahzadeh Jamalabadi, Jinxiang Xi^*

Frontiers in Heat and Mass Transfer, Vol.21, pp. 65-79, 2023, DOI:10.32604/fhmt.2023.042613

Abstract As a means of harvesting solar energy for water treatment, solar-driven vapor generation is becoming more appealing. Due to their entangled fibrous networks and high surface area, fibers can be used as building blocks to generate water vapor. In this paper, using a two-dimensional fiber bundle model, we studied the generation of solar vapor based on the fiber height, distance between fibers, and input sun radiation. The performance of solar absorption system was also evaluated by evaluating thermal and water management. Results showed a constant increase in solar vapor generation with an increasing fiber height and decreasing inter-fiber distance. However,… More > Graphic Abstract

Jian Ai¹, Jie Xue^1,*, Jiabang Yu^1,2, Xinyu Huang², Pan Wei^1,2, Xiaohu Yang², Bengt Sundén^3,*

Frontiers in Heat and Mass Transfer, Vol.21, pp. 47-63, 2023, DOI:10.32604/fhmt.2023.045134

Abstract The calculation of heat and humidity load serves as the cornerstone of Heating, Ventilation, and Air Conditioning (HVAC) design. Nevertheless, as the heat and humidity load characteristics of underground structures differ substantially from those of above-ground structures, it is a challenge to derive their accurate calculation procedure through engineering experience. Therefore, it is particularly important to carry out quantitative research on heat and humidity load. This study used Design Builder software to study the influence of the design state point of air conditioning in underground buildings on energy consumption. The study showed that compared with the single design temperature of… More >

Jiarui Wu¹, Yuzhen Kang², Junxiao Feng^1,*

Energy Engineering, Vol.120, No.12, pp. 2783-2802, 2023, DOI:10.32604/ee.2023.029358

Abstract To enhance system stability, solar collectors have been integrated with air-source heat pumps. This integration facilitates the concurrent utilization of solar and air as energy sources for the system, leading to an improvement in the system's heat generation coefficient, overall efficiency, and stability. In this study, we focus on a residential building located in Lhasa as the target for heating purposes. Initially, we simulate and analyze a solar-air source heat pump combined heating system. Subsequently, while ensuring the system meets user requirements, we examine the influence of solar collector installation angles and collector area on the performance of the solar-air… More >

Cheng Wang^1,2,*, Zhuowei Zheng¹

CMES-Computer Modeling in Engineering & Sciences, Vol.138, No.2, pp. 1563-1592, 2024, DOI:10.32604/cmes.2023.031103

Abstract The advent of Industry 4.0 has compelled businesses to adopt digital approaches that combine software to enhance production efficiency. In this rapidly evolving market, software development is an ongoing process that must be tailored to meet the dynamic needs of enterprises. However, internal research and development can be prohibitively expensive, driving many enterprises to outsource software development and upgrades to external service providers. This paper presents a software upgrade outsourcing model for enterprises and service providers that accounts for the impact of market fluctuations on software adaptability. To mitigate the risk of adverse selection due to asymmetric information about the… More >

Suprapto Suprapto, Putri Augista Nur Azizah, Yatim Lailun Ni’mah^*

Journal of Renewable Materials, Vol.11, No.12, pp. 4007-4023, 2023, DOI:10.32604/jrm.2023.031210

Abstract This research focuses on the effective removal of methylene blue dye using silica gel synthesized from chemical glass bottle waste as an environmentally friendly and cost-effective adsorbent. The adsorption process was optimized using Box-Behnken Design (BBD) and Response Surface Methodology (RSM) to investigate the influence of pH (6; 8 and 10), contact time (15; 30 and 45 min), adsorbent mass (30; 50 and 70 mg), and initial concentration (20; 50 and 80 mg/L) of the adsorbate on the adsorption efficiency. The BBD was conducted using Google Colaboratory software, which encompassed 27 experiments with randomly assigned combinations. The silica gel synthesized… More > Graphic Abstract

AMGAD M. RABIE^*

BIOCELL, Vol.47, No.10, pp. 2133-2139, 2023, DOI:10.32604/biocell.2023.030057

Abstract Despite the global decline in the severity of the coronavirus disease 2019 (COVID-19) cases, the disease still represents a major concern to the relevant scientific and medical communities. The primary concern of drug scientists, virologists, and other concerned specialists in this respect is to find ready-to-use suitable and potent anticoronaviral therapies that are broadly effective against the different species/strains of the coronaviruses in general, not only against the current and previous coronaviruses (e.g., the recently-appeared severe acute respiratory syndrome coronavirus 2 “SARS-CoV-2”), i.e., effective antiviral agents for treatment and/or prophylaxis of any coronaviral infections, including those of the coming ones… More > Graphic Abstract

Yazeed Yasin Ghadi¹, Mohammed S. Alshehri², Sultan Almakdi², Oumaima Saidani^3,*, Nazik Alturki³, Fawad Masood⁴, Muhammad Shahbaz Khan⁵

CMC-Computers, Materials & Continua, Vol.77, No.1, pp. 781-797, 2023, DOI:10.32604/cmc.2023.042777

Abstract Securing digital image data is a key concern in today’s information-driven society. Effective encryption techniques are required to protect sensitive image data, with the Substitution-box (S-box) often playing a pivotal role in many symmetric encryption systems. This study introduces an innovative approach to creating S-boxes for encryption algorithms. The proposed S-boxes are tested for validity and non-linearity by incorporating them into an image encryption scheme. The nonlinearity measure of the proposed S-boxes is 112. These qualities significantly enhance its resistance to common cryptographic attacks, ensuring high image data security. Furthermore, to assess the robustness of the S-boxes, an encryption system… More >

T. E. Boukelia^1,2,*, A. Bourouis¹, M. E. Abdesselem³, M. S. Mecibah³

Energy Engineering, Vol.120, No.11, pp. 2449-2467, 2023, DOI:10.32604/ee.2023.030183

Abstract Concentrating Solar Power (CSP) plants offer a promising way to generate low-emission energy. However, these plants face challenges such as reduced sunlight during winter and cloudy days, despite being located in high solar radiation areas. Furthermore, their dispatch capacities and yields can be affected by high electricity consumption, particularly at night. The present work aims to develop an off-design model that evaluates the hourly and annual performances of a parabolic trough power plant (PTPP) equipped with a waste heat recovery system. The study aims to compare the performances of this new layout with those of the conventional Andasol 1 plant,… More >

Dengyun Li, Baiwen Du, Kai Zhu, Jicheng Yu^*, Siyuan Liang, Changxi Yue

Energy Engineering, Vol.120, No.11, pp. 2611-2628, 2023, DOI:10.32604/ee.2023.028282

Abstract Self-heating and electric field distribution are the primary factors affecting the accuracy of the Ultra High Voltage Direct Current (UHVDC) resistive divider. Reducing the internal temperature rise of the voltage divider caused by self-heating, reducing the maximum electric field strength of the voltage divider, and uniform electric field distribution can effectively improve the UHVDC resistive divider’s accuracy. In this paper, thermal analysis and electric field distribution optimization design of 1200 kV UHVDC resistive divider are carried out: (1) Using the proposed iterative algorithm, the heat dissipation and temperature distribution of the high voltage DC resistive divider are studied, and the… More >